電橋測量 的英文怎麼說

中文拼音 [diànqiáocèliáng]
電橋測量 英文
bridge measurement
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 橋 : 名詞1. （橋梁） bridge 2. （姓氏） a surname
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. This measurement amplifier with relay outputs works as a uniform voltage amplifier for strain gauge measuring bridges

    這款測量放大器帶有繼電輸出，它像恆定電壓放大器那樣工作，用於應變測量電橋。
  2. The bonded-foil gage monitored with a wheatstone bridge has become a highly perfected measuring system.

    用惠斯登電橋監測的粘貼箔式應變片已成為高度完善的測量系統。
  3. The bonded - foil gage monitored with a wheatstone bridge has become a highly perfected measuring system

    用惠斯登電橋監測的粘貼?箔式應變片已成為高度完善的測量系統。
  4. In the paper, through the calibration test of ground load, the relationship between outputs of electrical resistance of strain gauges and the external load applied on the structure has been gotten, and then the load history can directly be deduced from the measured strain history. so the fatigue load can be compiled

    本文所建立的應變法實測疲勞載荷，其主要方法是通過進行地面加載標定實驗，確定所設計應變電橋輸出量與結構上作用的外載荷之間的關系，再由實測應變歷程直接得到載荷歷程的方法。
  5. It is important to keep the bridge voltage low in order to avoid a self-heating of the measuring element by the bridge current.

    保持電橋低電壓很重要，以避免橋路電流測量元件自熱。
  6. Assessment of inadvertent initiation of bridge wire electro - explosive devices by radio - frequency radiation - guide

    由射頻輻射引起的測量電橋標準導線電起爆器件的意外著火的評定.指南
  7. Loss angle measuring bridge

    損耗角測量用電橋
  8. Manufactures and supplies components for precise and reliable measurement of pressure, level and vacuum on processes involving corrosive, viscous, clogging fluids

    -主要有lcr數字電橋系列電容測量儀，電感測量分選系列漏電流測試儀系列耐壓測試儀。
  9. This paper introduces the initiation principles and c alculates the burst current of bridge foils that is measured by rogofiski coil, a nd the results are consistent with those computed initiation model. this s hows the validity of measurement results and the accuracy of experimental models

    介紹了橋箔起爆機理，計算了爆發電流，採用羅果夫斯基線圈對橋箔的爆發電流進行測量，其結果與計算值符合得很好，說明了橋箔起爆模型的準確性和測量結果的有效性。
  10. Abstract : this paper introduces the initiation principles and c alculates the burst current of bridge foils that is measured by rogofiski coil, a nd the results are consistent with those computed initiation model. this s hows the validity of measurement results and the accuracy of experimental models

    文摘:介紹了橋箔起爆機理，計算了爆發電流，採用羅果夫斯基線圈對橋箔的爆發電流進行測量，其結果與計算值符合得很好，說明了橋箔起爆模型的準確性和測量結果的有效性。
  11. - the focal point of this paper is studying the problem of cargoes ? weight measurement, besides the component of mechanical system, the component and control of electric - control system, the full - digital dc speed adjustment system and the hardware and software design of plc control system. this paper puts forward the project of current static measurement method and corrects it with acceleration dynamic measurement

    本文除分析介紹了集裝箱橋吊的機械繫統組成、電控系統的組成及控制、全數字直流調速器以及plc控制系統的軟硬體設計外，重點研究了集裝箱裝卸橋中的貨物稱重問題，提出了應用電流靜態測量法的稱重方案，並且採用了加速度動態測量法對其進行動態校正，在實際應用中取得了令人滿意的效果。
  12. A resolution method in software is applied to calibrate zero point and full scale of the circuit. software approach to nonlinear correction for sensor and circuit is presented. therefore system error is eliminated, and measurement accuracy of temperature is improved. the signal of acidity electrode is detected by a differential amplifier circuit, which consists of operational amplifiers tlc2254 with high input impedance and low drift

    採用橋路和單運放差動放大電路對溫度傳感器信號檢測放大，軟體校正溫度傳感器和測量電路的非線性，軟體校準測量電路的零點和滿度，消除測量電路的系統誤差，提高補償溫度的測量精度；採用高阻、低漂移運放tlc2254組成高阻差動放大電路用於酸度電極信號測量。
  13. The uncertainty of the copper alloy electric - conductivity measured by kelvin method

    電橋法測量銅合金導電率的不確定度
  14. It will effect the system in safety and running economy directly > test of tradition past the method is an usage to give or get an electric shock the bridge method or direct current to press to decline the method to proceed to measure, and the electric current for producing of is only in the ma class which ca n ' t broke through the oxidize surface

    高壓斷路器是電力系統中最重要的控制和保護設備之一，它對系統的安全、經濟運行有著直接的影響。以前傳統的測試方法是使用電橋法或直流壓降法進行測量，所產生的電流僅在ma級，不能擊穿觸頭氧化膜。
  15. An experimental study of the measurement of resistae by applying unequilibrium electric bridge

    應用非平衡電橋測量電阻實驗的研究
  16. According to the principles of unequilibrium electric bridge, this paper analyses the work features of the three bridge types and based on experiments, shows how to select the bridge types and parametes. to reduce the non - linear errors and avoid centain unusual circumstances in the measurement

    從非平衡電橋測電阻原理出發，分析了3種橋式的工作特性，並通過實例說明如何選取電橋的橋式與參數，以減少測量的非線性誤差及避免一些異常情況。
  17. Dc bridges for measuring resistance ; amendment 2

    電阻測量用直流電橋.第2次修訂
  18. D. c. bridges for measuring resistance

    電阻測量用直流電橋
  19. In the pressure characteristic test, a new method of testing pressure difference is brought out. with an entire bridge circuit and two pressure sensors, the structure is simple but the result is of high precision

    電液伺服閥壓力特性實驗中，提出利用兩只壓力傳感器通過全橋電路測量差壓的新方法，該方法硬體結構簡單，測試精度高。
  20. The portable dc bridge is a device for measuring resistance that be applied widely to field - testing of electric power system

    摘要攜帶式直流電橋是一種電隊測量儀器，在電力系統現場測試中應用極廣。
分享友人
分享到 Line

分享到臉書