電機繞組 的英文怎麼說

中文拼音 [diànrào]
電機繞組 英文
machine winding
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : machineengine
  • : 繞名詞1. [書面語] (彎曲) bend2. (姓氏) a surname
  • : Ⅰ名詞1 (由不多的人員組成的單位) group 2 (姓氏) a surname Ⅱ動詞(組織) organize; form Ⅲ量詞(...
  • 電機 : (任何產生和應用電能的機器 特指發電機、電動機) any power generating or power driven machine esp ...
  1. The armature winding in no. 2 generator rewound

    了2號發
  2. The control system with such method is simulated and a inverter is made for speed control of single - phase motor. the method presented in this paper offers such advantages as easy implementation, large range of frequency and rapid dynamic response. furthermore, using this method, the single - phase motor with symmetrical or dissymmetrical windings can operate symmetrically

    本文提出的變頻調速控制方法具有系統設計簡單易實現,調速范圍大,動態響應快等特點,而且在電機繞組對稱和不對稱兩種情況下均可實現變頻調速的對稱運行。
  3. The submersible motor has motor winding thermostats

    潛水配置電機繞組溫控器。
  4. The generator shall be run without load for 30 minutes, to record the phase current, volt, frequency, stator and bearing temperature once at intervals of 10 minutes

    應空載試運行2小時,每隔30分鐘記錄一次相流、和軸承溫度。
  5. The dissertation is organized as follow : first, the characteristics of srm and its control system ' s development are introduced. previously major methods used to implement non - position sensor detection and the significance of making search for this direction is generated. and the configuration and fundamental operating principle of srm are analyzed ; some study of linear model and nonlinear model with phase coil as fundamental parameter are presented and sr ' s linear model and nonlinear model are set up

    本文就以上兩個問題進行了深入研究,首先介紹了sr及其控制系統的發展歷程,研究無位置傳感器srd的意義和總結已有的無位置傳感器檢測方法,並且通過分析sr的結構和運行原理,研究sr電機繞組的線性感模型和非線性感模型,建立了的線性和非線性數學模型,重點研究sr的非線性模型,為sr運行與控制特性的研究和模擬研究奠定了理論基礎。
  6. Dissertation explains the theory and characteristices of switched reluctance motor based on its idealy linear math mode. analyseing and researching on control characteristic, control parameters, control strategy and their relationship, thesis designed hardware circuit and software of control system based on the strategy. dissertation discussed the transform function of system and illustrates it is essential to chang parameters in the pid control arithmetic, estimating parameters for the digital pid controller primarily, dissertation also researched on the exciting and protection of igbt

    論文以開關磁阻的理想線性數學模型為理論基礎,對其原理特性進行了說明,對開關磁阻的控制特性(轉速、轉矩) 、可控參數(導通角、關斷角、相流、壓)與控制策略(流斬波、壓斬波、角度位置控制等)及它們之間的關系進行了研究和分析。
  7. Theory application of motor winding

    電機繞組理論及應用
  8. Theory of motor winding

    電機繞組理論
  9. The system takes both advantages, the former is fast and convenient characteristics of dasylab in building a control and measure system, and the latter is the powerful program function and abundant control button of labwindows / cvi. it can acquire, analysis and save the real - time data in the experiments of the lim and electromagnet meanwhile, it can control the start / stop of the lim. electromagnet and dc motor, as well as it can control the change of the voltage and frequency of the lim. the exciting windings voltage and rotor windings voltage of the dc motor

    整個測控系統利用了dasylab建採集分析系統的簡單快捷和labwindows cvi豐富的控制項與強大的編程功能,將兩者的優點有的結合起來,可以完成直線磁鐵試驗中的數據採集、分析、存儲,並且可以控制試驗中直線磁鐵、直流的啟動與停止,對直線電機繞組壓、直線電機繞組壓頻率、直流勵磁壓、直流壓、磁鐵壓的大小進行控制。
  10. Test specification of the interture insulation on armature winding for dc machines

    直流匝間絕緣試驗規范
  11. It is showed that the torque ripple is not only connected with the phase currents, but also with the other factors, such as the instantaneous phase emf ' s in the case of commutation, the angle of commutation and the parameters of the windings

    從一個新的角度分析了換相引起轉矩波動的原因,指出換相轉矩波動不僅與電機繞組流有關,還與換相時相感生勢瞬時值、換相位置角、參數等因素有關。
  12. Two or more generators shall be used to generate electricity by the synchronous equipment

    在帶負載試運時,每隔30分鐘記錄一次相流、和軸承溫度。
  13. If the motor winding thermostats are not connected the warranty is void

    如果沒有配置電機繞組溫控器,則本質量保證無效!
  14. Error analysis and elimination for measuring the widing temperature - rise of electromotor with a constant flow source method

    恆流源法測量電機繞組溫升的誤差分析及消除
  15. Before connection upon completion of generator ' s mounting, measured insulation resistance of generator ' s winding, dry out the generator if necessary

    安裝完畢接線前,測試發定子及勵磁電機繞組絕緣阻。如果需要,對要進行乾燥。
  16. It is used for measuring surface temperature of large, middle, and small electromotor coil, stator and other slender gulf capable of shock - proof and withstand pressure

    用於測量大中小型電機繞組定子及其它小間隙,表面測溫場合具有抗振耐壓等優點。
  17. Both software and hardware are synthesized. three - phase bridge inverter used, the current in each phase is made similar to sine wave using current closed loop control

    以igbt三相橋作為主逆變路,對電機繞組流按正弦規律進行流閉環控制實現正弦波細分驅動。
  18. Checking methods and evaluation of water circuit within the winding of turbo generator

    汽輪發電機繞組內部水系統檢驗方法及評定
  19. Electrical fault analysis for large synchronous generator winding

    大型發電機繞組氣故障分析
  20. This paper briefly introduces work principle, primary characteristic index and several kinds of driving circuits of stepping motor. accordingly, the paper puts forward a kind of practical method of divided driving of stepping motor. that is, it is cutting wave constant current to drive stepping motor based on single chipped microcomputer dealing with divided current

    本文簡要地介紹了步進的工作原理、主要性能指標及幾種驅動路,在此基礎上提出了步進的細分驅動的實現方法,即利用單片來處理步進電機繞組的細分流基礎上進行斬波恆流驅動。
分享友人