電氣文字 的英文怎麼說

中文拼音 [diànqìwénzì]
電氣文字 英文
dqwz
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 文 : Ⅰ名詞1 （字） character; script; writing 2 （文字） language 3 （文章） literary composition; wri...
  • 字 : Ⅰ名詞1 （文字） character; word 2 （字音） pronunciation 3 （字體） form of a written or printed ...
  • 電氣 : [電學] electrical; electric電氣安裝 electric mounting; 電氣保護 electric protection; 電氣保護裝置...
  • 文字 : 1 （書寫符號） characters; script; writing 2 （語言的書面形式） written language 3 （文章形式） w...
  1. The control system of furnace " s temperature has been widely used in every walk of life, as an important link of repair and manufacture of the electrical equipment such as electromotor transformer etc., soaking lacquer drying craft has some especial requests on drying crafto this article starts with the analysis of drying chamber " s configuration, analyzed its configuration limitation and control function limitation according to the factory " s situation and advances the conception of heated air drying circulation, in addition, this article adopts an intellectualize a / d module, a development sampling tuning - voltage circuit, and presents the method to measure online the insulation resistance of products in order to improve constantly products quality

    而浸漆乾燥工藝作為電機、變壓器等電氣設備的修理、製造中的重要環節之一，對乾燥過程的質量要求有一定的特殊性。該文從乾燥爐的結構分析入手，聯繫到工廠的實際情況分析了結構功能缺陷和控制功能缺陷，提出了熱風循環乾燥的概念，同時，選擇了較為先進的a d板卡、熱電阻信號調理板等專業化智能卡，運用數字pid控制技術，構成了一個較有特色的計算機控制系統。此外，該文還從保證乾燥品質量的角度，採用智能化交流模塊和自製采樣調壓電路的方法，提出了在線檢測產修品的絕緣電阻的方法和手段，以確保企業產品質量不斷提高。
  2. Because the monitoring of electricity equipment is still in the condition of traditional prophylactic test ( monitoring off line ), wordage list and management method of handwork operation, to strengthen the real - time monitoring of the operation state of electricity equipment ( monitoring on line ), find out the anomaly of equipment, monitor and analysis the fault, then take a corresponding measures to lower the fault loss so that we can make the transition between the regulations of periodic repairing equipment and the regulations of reasonable state repair, is the work which the department of power supply and operation make much of

    針對對現有電氣設備的監測大都還處于傳統的預防性試驗（離線監測） 、文字報表、手工操作的管理方式的現狀，加強對電力設備的運行狀態進行實時的監測（在線監測） ，及時發現設備的異常徵兆、對故障進行診斷分析，並採取相應措施，把故障損失降低到最低水平，進而將目前實行的設備定期檢修制過渡到更為合理的狀態檢修制，一直是供電和運行部門十分重視的工作。
  3. General letter symbols in electrotechnology for relays, protection and automation equipment of power system

    電力系統繼電器保護及自動化裝置常用電氣技術的文字元號
  4. Air temperature, dew point and relative humidity : digital thermometers with platinum resistance sensors have been used since 1982. mercury - in - glass thermometers are used for back - up purposes

    氣溫露點及相對濕度：天文臺自一九八二年開始使用配備白金電阻感應元件的數字溫度表，水銀溫度表則用作后備。
  5. The comprehensive geological characteristic has been fully studied in this paper. on the basis of this, closely combining production practice, the favorable gas developing regions have been determined with the methods of sedimentary facies and combination of generation, reservoir and caprock, and logging parameters interpretation maps and regression formulas have been established with logging data, as well as reprocessing, interpretation and identification of gas reservoir have been done with computer. integrating the information and results of geology, logging, testing and geophysics, the gas reservoir distribution regularity of structure of no. 1 sebei has been described and reserves in place of no. 1 ' sebei gas field have been recalculated, which have provided a basis for next step of development in research area

    在近十多年，通過提高地震資料處理精度、淡水聚合物泥漿的應用、數字測井技術的運用、並加強了低電阻層和差物性層的試氣及氣田擴邊鉆探，大大提高了對氣層的識別，大量增加了氣層的層數和厚度，擴大了氣田的含氣面積，使氣田儲量通過多次復查核算仍在不斷增加本論文充分研究了青海澀北一號氣田天然氣地質綜合特徵，並以此為基礎緊密結合生產實踐，應用沉積相與生儲蓋組合等方法確定氣藏有利發育區帶，應用測井資料建立測井參數解釋圖版並回歸公式，應用計算機重新處理、解釋和識別氣層，綜合地質、測井、試井、物探等多方面信息與成果，描述了澀北一號構造的氣層分佈規律，重新計算了澀北一號氣田的地質儲量，為研究區下一步開發提供了依據。
  6. Due to the sole - designed of the low voltage startup and power testing, for combined with the other four modules, we built the hardware and software flats, it was also convenient for continued extension. but, if there was different system wanted to combined in this system, we must redesigned all the hardware and software, it was a very hard work and could bring incompatibility. for this instance, the text designed a suit of number discriminating embedding system

    但是如果有不同類型的系統也要增加到本系統中的話，就需要重新設計軟硬體，工作量很大，還容易產生不兼容等問題，針對這種情況，本文設計了一套數字識別的電器安全測試嵌入式系統，可以面向多臺儀器裝置，不採用電氣的連接，即是不改變原來的儀器裝置，通過電壓耦合元件攝像頭和視頻捕獲卡從測量儀器的顯示屏幕獲取測試信息，再把信息傳送到原來系統，從而組成了一個新的系統。
  7. Children will play with dolls equipped with personality chips, computers with in ? built personalities will be regarded as workmates rather than tools, relaxation will be in front of smell ? television, and digital age will have arrived

    參考譯文兒童將與裝有個性化晶元的玩具娃娃玩耍，具有個性內置的計算機將被視為工作夥伴而不是工具，人們將在氣味電視機前休閑，那時數字化時代就來到了。
  8. Delay is obvious in large body because of its inertia, moment force, stress and gearing. transfer of electical cell increases the delay. this paper points out that the delay can be compensated by using the smith control algorithm. the result of computer emulation proved that a better quality is gained by using the algorithm on heavy nc machine

    大慣量物體，由於其慣性，加之傳動鏈長，所需的扭矩大，引起的應變大，加上電氣轉換元件的滯后，故滯後效應明顯.該文提出用史密斯控制演算法將滯后進行補償.計算機數字模擬結果說明，對大慣量有滯后的重型數控機床，應用該演算法能得到較好的控製品質
  9. The dissertation presents the combined theoretical, numerical and experimental studies on the experimental modeling of the actuator, the design of test rig and control system, the modeling of two - dimensional airfoil aeroelastic system, the control design of active flutter suppression, and the effect of group delay in the digital filter on the stability of aeroelastic closed - loop system

    本文通過理論分析、數值模擬與風洞實驗相結合的方法，研究了超聲電機作動器建模、翼段顫振實驗裝置和控制系統設計、二維翼段氣動彈性系統建模、顫振抑制控制律設計以及數字濾波器群時延對顫振抑制閉環系統穩定性影響等問題。
  10. It can also determine the fault spot and reason. this technology has been used in some technological fields and proved efficient. it has promoted the revolution of maintance system and the historial protection is replaced by preventive maintenance. with this technology, we can improve the reliability of machine and decrease the maintance fee. recently, reserch has pick up a fervent pace in the area of fault diagnosis of electrical machines. the paper simply analyzes the fault reason of electrical machines, stressly describes and explores the methods of condition monitoring and fault diagnosis such as partial discharge, stator current, rotating speed, vibration etc. fault prognosis is now include diagnostic feature, reason, spot. prodigious improvement in signal processing hardware and software has made this possible. primarily, these techniques depend on locating specific harmonic components of the fault. these harmonic components are usually diffirent for diffirent types of faults. automated tools such as fuzzy logic based system is also simply presented in the paper

    本文從絕緣結構的故障機理入手，以絕緣結構故障的典型特徵? ?局部放電為研究對象，重點討論局部放電的在線監測方法、適用場合併比較它們的優缺點；在分析籠型異步電機轉子斷條在線監測的定子電流監測方法后，根據其缺陷，本文探討了溫升不平衡法、希爾伯特變換數字濾波、小波包分析法的原理及優點；以電機軸承、氣隙偏心等故障為研究對象，通過對電機振動和轉速頻率的檢測，診斷電機的故障類型；本文的重點工作是將人工智慧技術中的模糊技術應用於電機的狀態監測和故障診斷中，力求使電機故障診斷更接近人工智慧化；最後，本文對電機狀態監測和故障診斷系統進行了硬體和軟體初步設計，為實現預測維修提供了有效的技術手段。
  11. The background of rapidly developed uhsm ( ultra high speed machining ) technology is introduced and the key function of the uhs ( ultra high speed ) motorized spindle to uhsm is discussed in the thesis. after analyzing international technology status and trend of the uhs motorized spindle study, we research the core technologies related to the uhs motorized spindle in detail, such as optimized design of the motorized spindle structure, high speed bearing technologies, oil - gas lubication technologies, precision machining and assembly technologies, design and manufacture technologies of the built - in frameless motor etc. then the digital simulation of the motorized spindle sensor - less vector control system is studied thoroughly

    本文從超高速加工技術飛速發展的背景出發，討論了超高速電主軸對超高速加工技術發展的重要作用和意義；分析了超高速電主軸研究的國內外現狀及發展趨勢；詳細論述了超高速電主軸的關鍵技術，包括電主軸結構優化設計、高速軸承技術、油氣潤滑技術、精密加工與精密裝配技術以及內裝式電機設計製造技術等，並深入研究了超高速電主軸無速度傳感器矢量控制系統的數字模擬技術。
  12. At the end of the paper, the conceived design for the next generation of electric parameter measurement system based on digital signal processor and wavelet transform is provided

    在本文的最後，提出了以數字信號處理器為硬體基礎、以小波變換理論為數學基礎的下一代電氣參數自動測試系統的設計構想。
  13. During the ceremony, mr. c y lam, director of the hong kong observatory, recalled that the gathering of meteorological observational data from the mainland relied upon the reception of short wave radio broadcast by mtc colleagues. the morse code broadcasts were skillfully decoded into textual messages, and which were kept in good conditions

    天文臺臺長林超英于會上憶述：從前接收中國內地氣象觀測數據，是依靠氣象電信中心同事細心收聽短波無線電廣播，把資料從摩斯電碼morse code一一編譯成文字報文，並完好的保存下來。
分享友人
分享到 Line

分享到臉書