電氣負載 的英文怎麼說

中文拼音 [diànqìfùzǎi]
電氣負載 英文
electrical load
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 電氣 : [電學] electrical; electric電氣安裝 electric mounting; 電氣保護 electric protection; 電氣保護裝置...
  • 負載 : [電學] load
  1. Procreant knowledge expression and forward inference engine are adopted in the method of fault diagnosis based on expert system theory. in the fault diagnosis applying neural network theory, six kinds of improved arithmetic of back - propagation arithmetic, including gradient descent with momentum, variable learning rate back - propagation, resilient back - propagation, quasi - newton, levenberg - marquardt and conjugate gradient, are applied to diagnose the faults of electric load manage center and solid state power controller. different diagnostic results gotten by simulation are compared at last

    在基於專家系統的故障診斷方法中，採用了產生式知識表達和正向推理機制；在基於神經網路的故障診斷方法中，則分別採用了bp神經網路的附加動量法、自適應學習速率、彈性bp演算法、擬牛頓法、共軛梯度法和levenberg - marquardt法對電氣負載管理中心和固態功率控制器的故障進行診斷，並對由模擬得到的不同診斷結果進行比較。
  2. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  3. The sources of these internal transients are everyday items, such as air compressors, arc welders, pumps, elevators, switching power supplies and other inductive loads

    這些內部電涌的根源是每天都會使用的設備，如空氣壓縮機，電弧焊接機，泵，電梯，開關電源和其他的感應負載。
  4. Mjc : the sources of these internal transients are everyday items, such as air compressors, arc welders, pumps, elevators, switching power supplies and other inductive loads

    這些內部電涌的根源是每天都會使用的設備，如空氣壓縮機，電弧焊接機，泵，電梯，開關電源和其他的感應負載。
  5. Road vehicles - electrical heavy - duty connector, 2 to 4 poles with pins and bayonet coupling - dimensions

    道路車輛.帶插銷和卡口耦合器的4至6極高負載電氣連接
  6. Road vehicles - electrical heavy - duty connector, 2 to 4 poles with pins and bayonet coupling - requirements and tests

    道路車輛.帶插銷和卡口耦合器的4至6極高負載電氣連接
  7. Equipped with electronic controller fini tronic and preset for remote control for two or more compressors. it offers working pressure and oil mist separator tank inner pressure indication, separator filter clogging lashing alarm before overpressure e - stop, electric motor temperature control, maximum screw assembly temperature control, air temperature on pressure end indication, electric motor direction of rotation check, time to scheduled maintenance term, total operating hours and operating hours under load, alarm log of last five failure events

    並預設為丙臺以上空壓機聯機遠程控制，有工作壓力和油氣分離器罐內壓指示，分離器過濾器阻塞報警，電機溫控，螺桿總成溫控，壓力端空氣溫度指示，電機轉向檢查，維護周期油，油過濾器，空氣過濾器，分離器過濾器，總運行時間和負載運行時間，記錄上五個報警故障等。
  8. It offers working pressure and oil mist separator tank inner pressure indication, separator filter clogging flashing alarm before overpressure e - stop, electric motor temperature control, maximum screw assembly temperature control, air temperature on pressure and indication, electric motor direction of rotation check, time to scheduled maintenance term, total operating hours and operating hours under load, alarm log of last five failure events

    並預設為丙臺以上空壓機聯機遠程控制可檢測包括操作壓力油氣分離器罐內壓，電機溫度和轉向，螺桿總成溫度過濾器堵塞報警等參數，並可顯示總運行時間和負載運行時間。
  9. Electro - hydraulic servo loading system ( ehsls ) is an important simulation system in hard ware - in - loop flight simulation laboratory, which can simulate aerodynamic loads acting on flight vehicle, such as missiles, planes. its performance of test is important on the design of flight vehicle

    電液伺服負載模擬器是半實物模擬試驗室中模擬飛行器在飛行中舵面所受空氣動力載荷的重要設備，它的試驗能力高低對飛行器設計起著重要作用。
  10. Electricity metering - tariff and load control - particular requirements for electronic ripple control receivers

    電氣測量.資費和負載控制.電子脈動控制接受裝置的特殊要求
  11. Multi - kind of load simulations on the electrical driving exprement study peng an - hong1, liu gang2, meng fan - gang

    電氣傳動實驗研究中多種電機負載模擬方式的探討
  12. Fire protection, and surveillabce works as follows : electrical : 22. 8kv ; 27, 800kva ; three loading centers located in the power house, factory, and office building ; generator 2 800kw

    電氣： 22 . 8kv供電設備容量三處負載及配電中心分佈於動力室與廠房發電機容量2800kw ，供緊急負載使用本配電系統處使用數字式電驛及電表，符臺現代化之電力監控新潮流。
  13. Road vehicles - environmental conditions and testing for electrical and electronic equipment - part 2 : electrical loads

    道路車輛.電氣和電子設備的環境條件和試驗.第2部分:電力負載
  14. Research on automatic management of aircraft electrical power automatic distribution system

    飛機自動配電管理系統電氣負載管理技術的研究
  15. More electric aircraft ( mea ) is a feature of advanced fight plane. it is important to study electric load manage center ( elmc ), which is the key unit of mea

    多電飛機是下一代先進戰斗機的一個重要特徵，而電氣負載管理中心（ elmc ）是多電飛機電氣系統的樞紐部件。
  16. Bus controller ( bc ) is an important component in fulfilling the automation of aviation electrical load control and management, whose primary task is to monitor and control the major bus of aircraft ' s electrical system

    匯流條控制器是實現航空電氣負載控制與管理自動化的重要組成部分，其主要任務是對飛機電氣系統主匯流條進行監測與控制。
  17. Besides fulfilling the essential function of psp, electrical load equation database is added. perfecting and improving the real - time database ' s function is also introduced in this dissertation, which solves the problem of system ' s reconfiguration when it is in fault

    在完成供電系統處理機軟體基本功能的前提下，增加了電氣負載方程庫，改進和完善了實時數據庫系統功能，解決了故障狀態下的系統重構等主要問題，使得電氣系統控制軟體的功能更加完善。
  18. This system uses the means of distributing control and concentrating management. the remote terminal ( rt ) controls electrical loads, meanwhile the power system processor ( psp ) controls the whole electrical system. this power distribution system realizes effectively load automatic management

    該系統採用分散式控制、集中式管理的策略，由各個遠程終端（ rt ）控制電氣負載，而由供電系統處理機（ psp ）負責整個電氣系統的綜合控制，有效地實現了負載的自動化管理。
  19. The fault diagnosis software of power supply system applying the expert system theory is programmed under vb 6. 0. while the fault diagnosis of electric load manage center and solid state power controller is based on the neural network theory, whose software is realized through adopting the neural network toolbox of matlab 6. 1 in vb 6. 0

    對于飛機供電系統，在vb6 . 0中編寫了基於專家系統理論的故障診斷軟體；對于電氣負載管理中心和固態功率控制器，其故障診斷軟體則基於神經網路理論，通過在vb6 . 0中調用matlab6 . 1的神經網路工具箱完成。
  20. In the present paper, according to the characteristics of the dynamic running of the thermoelectric refrigerating devices and its components for the refrigerator is analyzed and the independent components " models are established. the entire model describing the working procedure of the refrigerating system is set up with the method of parameters coupling to combine the models of the refrigerating system, load, cabinet and air in the cabinet. the running characteristics of thermoelectric refrigerators on the effects of received current, load and ambient temperature are investigated using small - signal linearization method

    本文根據熱電製冷系統動態運行的特點，分析了電冰箱製冷系統及各個部件的熱物理過程，運用參數耦合的方法把製冷系統、負載、箱體及箱內空氣模型有機地結合在一起，建立了完整的製冷系統工作過程模型，用小階躍信號線性化法分析了電流、負載功率和環境溫度波動共同作用下的熱電製冷器工作特性。
分享友人
分享到 Line

分享到臉書