電池供電管 的英文怎麼說

中文拼音 [diànchígōngdiànguǎn]
電池供電管 英文
battery valve
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 池 : 名詞1 （池塘） pool; pond 2 （旁邊高中間窪的地方） an enclosed space with raised sides 3 （舊指劇...
  • 供 : 供Ⅰ名詞1 （供品） offerings 2 （口供; 供詞） confession; deposition Ⅱ動詞1 （供奉） lay （offerin...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 電池 : [電學] cell; battery; element; electric battery
  1. Finally, because high - speed power solenoid valve is one of the most important executive parts in the electronic control diesel engine and the performances of diesel engine are strongly related to the solenoid valve, the response performance of the solenoid valve is investigated. the response performance of the solenoid is influenced by many factors, such as driving voltage, electric driving unit etc. in order to have high excitation voltage and in low maintaining voltage, a high - low voltage electric driving unit is designed, and in order to make the solenoid valve close more rapidly, an active free - wheeling circuit and a bootstrapping circuit are designed in the electric driving unit, too. in the high - low electric driving unit, high voltage and low voltage are supplied by the dc - dc device and by the accumulator respectively

    高速強力電磁閥的響應性能除了與閥本身的結構和材料有關外，與驅動電壓、驅動電路的設計密切相關，本文通過分析，首先開發出一種高低壓驅動電路，高壓電源是山升壓式dc - dc原理獲取的，低壓由蓄電池本身提供，實現高壓強激和低壓維持的功能，電路中採用有源續流電柴汕機中卜軌知介系統的設訓及其七川j敝略的叭究路進行續流，加誣了電磁閥的關閉速度；採用自舉吐路，降低了場效應管對驅動電壓的要求。
  2. And a intelligent battery management system with full functions has been designed, which improved the management of charge and the estimation of residual capacity. the paper changed the current value of constant current charge - state, which current seems not constant during the working time, based on the three mice laws about battery charge. this change would increase the speed of charge, without harm to the battery

    同時本論文還設計了一套功能齊備的蓄電池智能管理系統，針對蓄電池管理中的充電管理和剩餘時間預測進行了改進，提出：在恆流充電時，根據麥斯三大定律，改變恆流充電時的恆流值，使恆流充電「不恆流」 ，而是根據放電的不同情況進行充電，充分提高充電速度，同時又不損傷電池活性物質；不再進行剩餘容量預測，而是進行剩餘時間預測，提供更加切實可行的信息，並且提出了一種簡單易行的剩餘時間預測的方法，給出了預測實驗的結果。
  3. The electrolyser is switched off by active solenoid valves during periods of low insolation, with the pv power then fed directly to the consumers and the batteries

    當太陽輻射量較小的時候，電解器由自動控制的螺線管閥關閉，由pv板直接向用戶和蓄電池組供電。
  4. This puts the miracle battery to the back burner, a battery was supposed to power a laptop for days and enable heated clothing for north pole expeditions

    因而電池這種近乎萬能的東西就不得不退居二線，盡管電池可以支持筆記本電腦待機數天，甚至為北極考察人員的衣服供暖。
  5. The innovation in this paper is list below ( 1 ) use rectangle - shape pipeline so that the inducing electromotive force could be enhanced ; ( 2 ) use alternating current whose frequency is adjustable to induce the magnetic ; ( 3 ) make the flowmeter intelligent by use the microprocessor ; ( 4 ) finish designing the ls flowmeter with utra - low power consumption

    本文的創新之處在於採用矩形測量導管大大增加微流量條件下的感應電動勢；採用輸出頻率可調的正弦波電流作為勵磁電流達到消除50hz頻干擾和減少正交干擾的目的；利用單片機等高端現代電子產品實現了電磁流量計的高度智能化及設計出真正的超低功耗的、可用干電池長期供電的ls旋轉流量計。
  6. Shaoyang dali power co. ltd carries out the quality management system in all aspects and emphasizes on the development of high - tech products, it promotes initially the li - ion double gap coater and li - ion electrode - plate continuous slitting in china, the company also devotes himself fully to supplying high quality and automatic battery equipment and offering the most satisfying after - sales service, the company also can transfer battery manufacture technique

    邵陽達力全面實施質量管理體系，注重高、新、優產品開發，在國內推出雙面間隙鋰離子塗布機，連續鋰電分切機等高新技術產品，致力向用戶提供高品質、自動化程度高電池設備，提供最滿意的售後服務及技術轉讓。
  7. Fortune semiconductor corp. ( fsc ), founded in 1995, positioned as an ic - supplier in the field of mixed signal processing technology, whose products ' main application fields are battery management, power management, electronic scales, digital multimeters, health - care products, and energy utilization measurement

    富晶半導體股份有限公司成立於1995年，定位在混合信號處理技術領域的ic供應商，產品主要應用領域為電池管理、電源管理、電子秤、耳溫槍、多用途電表、健康保健、能源量測等。
  8. According to the test conditions, the double polarity inputting mode is adopted in the circuit of voltage - frequency converting part ; storage batteries are used in the optical emission part of optical fibre isolating and transmitting device, that can guarantee isolation between the main circuit and the testing system ; the 89c51 singlechip is used in the singlechip testing - controlling unit, the peripheral circuits are extended, data are transmitted through the serial port in this part ; the p opular software delphi5. 0 is used in the pc part, the communication between singlechip and pc by serial port, plotting of current wave, regulation of data ; the optical - electrical isolating and triggering are used in the controlling part, this can guarantee the veracity and reliability of breakers triggered, this triggering mode is also used in the triggering of the main closing breaker, the tested breaker and the assistant breaker, the triggering signals are sent out by a singlechip

    壓頻轉換部分電路中根據實際情況採用了雙極性輸入方式；光纖隔離傳輸裝置的光發射部分電源採用了蓄電池供電，確保了主迴路與測試迴路的完全隔離；單片機測控部分採用了89c51單片機，擴充了外圍電路，通過串口向pc機傳送數據； pc機與單片機之間的串口通訊、波形繪制、數據管理等都採用了軟體delphi5 . 0編寫。該測試系統中預留了輸出口，可以對合成迴路中的主合閘開關、被試開關、輔助開關進行觸發，信號由單片機發出，控制部分採用了光電耦合隔離觸發的方法。軟體設計主要集中在對電流信號的數據採集、數據處理、數據傳送、人機界面、波形繪制和數據管理，軟體部分又可分為單片機和pc機程序設計兩大部分。
  9. The main results of this paper are as fellows f 1 ) illtroducing the ultrasonic technology to the rigid measurement, successful1y exploits the practical small intellectualized ultrasonic device of measuring rigidity by applying mechanical technology, electronic technology and computer science 2 ) reading clearcf displaying more various, applying more information, being easiest to accept by user because of adopting liquid crystal display ( lcd ) 3 ) theorizing the mathematical model between the signal of frequency and the rigid value on the device, possessing very importan practical significance 4 ) optimizing the every parts of the device, achieving the goals of lower wastage of energy, smaller, lighter and inexpensive 5 ) taking the measure to reduce the wastage of energy and adopting reasonable management in power supply for the device, making the device skimp more energy, prolonging the life - span of battery 6 ) utilizing the interface of rs - 232, discussing the communication between the ultrasonic device of measuring rigidity and computef, and also forecasting the foreground of advanced exploitation by user

    本文工作的主要成果是： 1 ）將超聲波技術引入零件表面硬度的檢測當中。應用機、電、計算機技術，研製成功較為實用的小型智能超聲波硬度檢測儀2 ）採用lcd （ liquidcrystaldisplay ）液晶顯示，使讀數更清晰、顯示多樣化、信息量多、易於為用戶接受3 ）在理論上建立了該系統的頻率信號與硬度值的數學模型，具有非常重要的實踐意義4 ）對各元器件進行優選，達到低能耗、體積小、重量輕、價格便宜等目的5 ）採取措施降低整個系統的能耗並對系統的供電進行了合理的管理，使其進一步達到低能耗，延長了電池的使用壽命。 6 ）利用rs - 232標準介面，討論了該超聲波智能硬度測量儀與系統機進行通訊以及用戶進行二次開發的前景
  10. The artificial neural network ( ann ) method, which can be used to approach non - linear function with many input / output parameters, is originally used to estimate the discharge capacity of mh / ni batteries when changing the discharge current and voltage. the satisfactory result has been obtained from comparison of simulation results

    並對鎳氫蓄電池soc的預測進行了模擬，結果表明，通過該網路模型可以方便快速的得到電池的soc值，所得結果滿足要求，為電池管理系統提供了一種新的電池soc的預測方法。
  11. 3. empirical analysis with the examples of tcl battery, walmart and pgl in different stages of supply chain, the author introduces what they do to manage the supply chain risk, corresponding to the theoretics mentioned above

    3 .實證分析以tcl電池、沃爾瑪、寶供三個位於供應鏈不同位置的企業為例，著重介紹他們在供應鏈風險管理方面所做的工作及經驗，和前面的理論部分相對應。
  12. Ample space is provided on the radio tray for modern batteries, switches, amplifiers, governors, regulators, receivers, and wiring

    空間提供現代托盤上電臺電池、開關、放大器、州長監管接收機、電線
  13. With the development of the consumer electronics, automobile electronics and communication electronics, power management ics have been more and more important, especially in the battery - operated portable systems. the topic about the thesis is the corporation with an abroad company

    隨著消費類電子、汽車電子和通信電子的不斷發展，電源管理晶元的重要性日益突出，在以電池為供電主體的便攜式電子產品中更是如此。
  14. The paper describes a capacity predicting method : combining the open circuit voltage prediction with the fuzzy prediction of the " storage batteries health ". and the method does not only increase the prediction speed but also improve the prediction precision, so it can offer credible data to charging management. 8

    提出了在獨立光伏系統中採用開路電壓預測和基於蓄電池「健康狀態」的模糊預測相結合的容量預測方法，使容量預測速度和精度比傳統的預測方法都得到提高，為充電管理提供可靠的充電依據。
分享友人
分享到 Line

分享到臉書