電流上升時間 的英文怎麼說

中文拼音 [diànliúshàngshēngshíjiān]
電流上升時間 英文
current rise time
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : 上名詞[語言學] (指上聲) falling-rising tone
  • : Ⅰ動詞1 (由低往高移動) rise; hoist; go up; ascend 2 (等級提高) promote Ⅱ量詞1 (容量單位) lit...
  • : shí]Ⅰ名1 (比較長的一段時間)time; times; days:當時at that time; in those days; 古時 ancient tim...
  • : 間Ⅰ名詞1 (中間) between; among 2 (一定的空間或時間里) with a definite time or space 3 (一間...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  • 時間 : time; hour; 北京時間十九點整19 hours beijing time; 上課時間school hours; 時間與空間 time and spac...
  1. Multiple functions available : start / crater arc current, increase / decrease time, base / crest value current, pulse frequency, pulse rate, post flow time, hf welding

    功能豐富:起始/收弧/下降、基值、峰直、脈沖頻率、占空比、滯后關氣分別可調,高頻引弧。
  2. Multiple funcyions available : start / crater arc current, increase / decrease time, base, crest value current, pulse frequency, pulse rate, post flow time, hf / friction welding, water / gas cooling

    功能豐富:起始/收弧/下降、基值、峰值、脈沖頻率、占空比、滯后關氣分別可調,高頻/接觸引弧、水冷/氣冷可供選用。
  3. Under the control of a current loop, the system can make advantage of the motor ' s ability of over - current with a maximum limit, as a result, the motor can implement constant - current staring under a maximum let - through current. therefore, the motor ' s rotational speed can rise at a maximum acceleration and reach the given speed within the shortest time

    環的控制下,系統在起動的候能夠最大限度的發揮機的過能力,使機以最大允許的起動起動,則機轉速可以以最大的加速度,並且以最快的達到給定轉速。
  4. Then these separated interferograms can be recorded by ccd camera the experiments with the multi - frame interferometer was carried out on a small gas - puff z - pinch device with 23 kv working voltage and 210 ka peak current and about 2 risetime, and good results were obtained

    該套干涉儀在小型噴氣式z箍縮裝置進行了實驗, z裝置的工作壓23kv 、峰值210ka 、電流上升時間約2 。根據干涉圖條紋的移動數,可以計算出等離子體的子密度和運動速度。
  5. In this circuit, reference current sources are used to charge and discharge capacitors. this oscillator ’ s output is very ideal through control circuit under 5. 7v reference voltage, and oscillator ’ s frequency and duty - cycle could be adjusted if reference current source or capacitors in the circuit was adjusted. and the changes of temperature and voltage affect stabilize of the frequency little

    路利用系統內部基準源產生的信號來對容進行充放,然後經過控制路作用后,產生的輸出振蕩波形的和下降非常小,更接近理想矩形波形;通過調節基準源信號或者容值大小,可調節振蕩波形的頻率和占空比,同溫度和壓的變化對振蕩器輸出波形頻率穩定度的影響很小。
  6. On - line monitoring of hvcb is the precondition of predicting maintenance, is the key element of reliable run, and is the important supplement to the traditional off - line preventive maintenance in fact, the faults are made by hvcb, no matter in number or in times, is over 60 % of total faults so it has determinative importance for improving the reliability of power supply and this can greatly decrease the capital waste used by - dating overhaul in this paper, the inspecting way of hvcb mechanism characteristic is discussed the concept of sub - circuit protector is presented, the scheme that we offered has been combined with sub - circuit integrality monitoring theory, to ensure that it has the two functions as a whole according the shut - off times at rated short circuit given by hvcb manufacturer, the electricity longevity loss can be calculated in each operation, and the remained longevity can be forecast too an indirect way for calculating main touch ' s temperature by using breaker shell temperature, air circumference temperature and breaker ' s heat resistance is improved in this paper, and main touch resistance can be calculated if providing the load current msp430, a new single chip microcomputer made by ti company, is engaged to develop the hardware system of the on - line monitoring device, and special problem brought by the lower supply voltage range of this chip is considered fully

    高壓斷路器所造成的事故無論是在次數,還是在事故所造成的停都占據總量60以。因此,及了解斷路器的工作狀態對提高供可靠性有決定性意義;並可以大大減少盲目定期檢修帶來的資金浪費。本文論述了斷路器機械特性參數監測方法;提出了二次迴路保護器的概念,並將跳、合閘線圈完整性監視和二次迴路保護結合起來,給出具有完整性監視功能的二次迴路保護器實現方案;根據斷路器生產廠家提供的斷路器額定短路分斷次數,計算每次分閘對應的觸頭壽命損耗,預測觸頭壽命;提出根據斷路器殼體溫度和斷路器周圍空氣溫度結合斷路器熱阻來計算斷路器主觸頭穩態溫的方法,並根據此的負荷接計算主觸頭迴路的阻;在硬體路設計,採用美國ti公司最新推出的一種功能強大的單片機msp430 ,並充分考慮該晶元的適用壓范圍給設計帶來的特殊問題;在通信模塊的設計中,解決了不同工作壓晶元之的介面問題,並給出了直接聯接的接線方案。
  7. Isobaric identification with gf - tof method is based on the different time of flight caused by the different energy loss. the resolution of gf - tof is mainly affected by two factors. first, the rises time of current pulse from start and stop detector

    Gf - tof方法對同量異位素的分辨取決于e的不同而產生的不同,分辨僅來源於定探測器脈沖的快慢和離子在氣體介質中的能量離散。
  8. Setting the current rising and reducing device. the time can be adjusted

    設有衰減自動裝置,長短可調。
  9. In order to drive a high impedance load such as hpm sources, it is necessary to commutate fcg ' s long pulse width, high - current and low voltage pulse to a short pulse with high voltage

    為用fcg驅動象hpm源這樣較高阻抗的負載,必須使用脈沖功率調制路把fcg產生的低壓、大長的壓脈沖轉化為高壓、短的脈沖。
分享友人