電流峰值 的英文怎麼說

中文拼音 [diànliúfēngzhí]
電流峰值 英文
peak current
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 峰 : Ⅰ名詞1. （山的突出的尖頂） peak; summit 2. （形狀像山峰的事物） peak-like thing Ⅱ量詞（用於駱駝）
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Parallel wiring quad current for a 2 - pin tube

    保證開機后啟動電流峰值與撞擊數據測量
  2. Multiple funcyions available : start / crater arc current, increase / decrease time, base, crest value current, pulse frequency, pulse rate, post flow time, hf / friction welding, water / gas cooling

    功能豐富：起始/收弧電流、上升/下降時間、基值電流、峰值電流、脈沖頻率、占空比、滯后關氣時間分別可調，高頻/接觸引弧、水冷/氣冷可供選用。
  3. The axial magnetic field distribution on center surface of contact gap and contact piece are calculated when the current is at peak. it can be found that the intensity of axial magnetic field and radial magnetic field uniformity are strengthened after the iron core is put into, this helps to improve the stability of the vacuum arc

    計算了電流峰值時觸頭間隙中心平面和觸頭片上的縱向磁場分佈，可以看出加入鐵芯后縱向磁場強度和徑向磁場均勻性增強，這有利於提高真空電弧的穩定性。
  4. We calculate the regression curve about length of erased magnetic record and lightning current peak. we analyze the error of recording data and find a new means about direct measurement of the max lightning steepness with magnetic tapes

    作出磁帶消磁長度與霄電流峰值的擬合曲線，對測量數據進行誤差分析，找到利用磁帶直接測量靂電流最大陡度的新方潔。
  5. This paper deeply discussed the mechanism of magnetic tape detector, mainly focused on the tape detector appliance in engineering fields, making it not only measure the lightning current peak but also its supreme deepness. my paper is mainly made up of the following parts

    本論文對雷電參數測量磁帶法的機理進行了較為深入的探討，著重於開拓磁帶測量雷電參數應用領域方面的研究，使磁帶既能測量雷電流峰值又能測量雷電流最大陡度。
  6. Rated short - circuit controlling current peak 50 63

    額定短路關合電流峰值ka 50 63
  7. Ratio of peak lamp current to rms or average lamp operating current

    燈電流峰值與rms （均方根值）或平均工作電流的比值。
  8. Under some conditions, short - circuit test on balanced transformers can be performed by means of 1. 5 phase supply. it is proved to be equivalent to the short - circuit fault during their operation. the test results comply with gb1094. 5 - 1985

    建立一定的試驗條件，在1 . 5相電源雙臂預先短路情況下進行短路試驗，使短路試驗能夠同時滿足實際運行中發生短路時的短路電流有效值和短路電流峰值的要求，並進行試驗驗證。
  9. Meanwhile it can filter the waveform and gather the envelope and calculation the current peak and max steepness of lightning by length of erased magnetic record. thirdly we need analyze the difference of length of erased magnetic record between kinds magnetic tape or pre - recorded sine wave on magnetic tape, and finding the min and max lightning current that can be recorded by magnetic tape. then we confirm the type of the magnetic tapes and the way of installing which fit to the line towers

    同時對該波形進行濾波消噪，提取包絡線計算磁帶消磁長度和雷電流峰值及最大陡度第三部分根據mtlcd得出的數據分析不同雷電流通道下不同磁帶、不同預錄正弦波消磁長度的差異及磁帶可以記錄的最小雷電流和最大雷電流，找到可以在輸電鐵塔角鋼上安裝使用的磁帶及其放置方式。
  10. Pointing to the measurement of pulse current ' s peak value and frequency generated in the discharge circuit the article gives an analysis on its principle, correspondingly, the article introduces how to measure the peak value of pulse magnetic field and magnetic suction of the permanent magnet

    對放電迴路產生的脈沖電流峰值以及其波形的檢測進行了原理上的分析，對永磁吸盤里永磁體中產生的脈沖磁場峰值的檢測以及永磁吸盤所產生的永磁吸力的檢測也作了相應的介紹。
  11. The distinct anodic current peak was observed in the seawater containing srb. it was presumed that it was the result of electrochemical oxidation of sulfide

    在接近自然腐蝕電位（ ecorr ）附近，出現了顯著的陽極電流峰值，電流峰值是硫化物氧化的結果。
  12. This is significant for analyzing lightning accident completely and accurately and finding out the cause of lightning accident as aspect of lightning current peak and lightning steepness. magnetic tape detector can offer a new way for developing highly precise lightning census in large region from lightning current peak and lightning steepness

    這對于全面、準確的記錄雷電參數，從留電流峰值與靂電流最大陡度兩個方面綜合分析與確定靂擊事故的原由具有非常重要的意義，並為從雷電流峰值與靂電流最大陡度兩個方面開展大范圍高精度的雷電普查工作提供新的手段。
  13. Rated short - circuit controlling current peak 50 ; 63

    額定短路關合電流峰值ka 50 63
  14. Rated machine stabling current maximum : 50 63

    額定動穩定電流峰值ka 50 63
  15. Rated machine stabling current maximum : 50 ; 63

    額定動穩定電流峰值ka 50 63
  16. Rated short - circuit controlling current 31. 5 rated short - time resisting current 12. 5

    額定短路關合電流峰值ka 31 . 5
  17. Due to these attributes these capacitors can supply extreme peak currents

    由於這些貢獻，使得這些電解電容能供應極端的電流峰值
  18. Moreover, chloride channel blockers, dids and sits, also significantly prevented sts - induced neuronal cell death. with whole - cell patch - clamp recordings, we found chloride channel currents increased significantly with time when holding potential at 60mv and 80mv after 5min and 10 min of sts exposure. these results indicate that potassium channel, especially bk channels, and chloride channel contribute to sts - induced neuronal apoptosis and apoptotic volume decrease, which is probably one of the mechanisms underlying mediation of neuronal apoptosis by potassium channel

    用斜坡電壓模式記錄的結果顯示， 10min內正常細胞在鉗制電壓下電流未發生明顯變化，氯通道阻斷劑dids可以抑制所記錄到的電流，加藥10mln就使電流峰值降低到原來的36 % ，向浴槽液中加凋亡誘導劑stssmin后， + 8伽mv鉗制電壓下電流即增大，為加藥前的131 . 3 % ，加藥后10min電流進一步增大，是加藥前的巧5 . 9 % ，而且電流隨時間延長具有繼續增大的趨勢。
  19. At first, the development and fundamental of monolithic switching power supply are presented in this thesis. then a novel monolithic switching power supply circuit only with four terminals is analyzed at detail. it uses pulse skip modulation and current - mode topology

    論文研究了一種作為psoc原型電路的四端單片開關電源電路，此電路採用新型的跨周期調制模式，與傳統的脈寬調制模式相比，提高了輕負載下的工作效率;整體控制迴路採用電流峰值控制模式。
  20. Different distribution of power loss can be worked out by mathcad software based on the formula reasoning. the result of calculation is consistent with that of the experiment, which proves that this method is right. it is pointed out through the analysis of calculating data that the key to improve efficiency at the same output power is to decrease the peak current and rms current of power switches or the on - resistance of mosfet and windings

    由推導可得損耗計算公式，利用數學計算軟體計算出電路輸出從空載到410w阻性負載時損耗分佈變化，該結果與實驗數據基本相吻合，證實了這種方法的正確性；通過對計算數據的分析，指出了進一步提高效率的關鍵在於輸出相同功率時降低功率管的電流峰值和有效值，減小繞組和mosfet的導通電阻。
分享友人
分享到 Line

分享到臉書