電流強度 的英文怎麼說

中文拼音 [diànliúqiángdù]
電流強度 英文
amperage
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 強 : 強形容詞（強硬不屈;固執） stubborn; unyielding
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Value, and the current density and intensity versus the substorm phases. moreover, the characteristics of substorm current wedge are given special attention. it is found that the density and intensity of facs reach their peak during the expansion phase, the onset of the expansion phase is triggered when imf is changed to southward from northward or the southward imf decreases, and the positions of onset are most likely to be at the edge of plasma sheet near the earth

    值分佈以及場向電流強度和密度隨亞暴位相的變化，並著重分析了亞暴電流楔的特徵。結果表明，亞暴膨脹相的場向電流強度和密度都達到極大值亞暴的膨脹相是由行星際磁場轉向或南向分量變小觸發的，其起始位置很可能位於近地等離子體片內邊緣。
  2. This experiment studies the relation of ionic current signals and a / f ratio on different premixed pressure

    通過控制預混壓力和空燃比兩個參數變化，消除了由於發動機循環變動對燃燒狀態和離子電流強度的不穩定影響。
  3. After that, we give the regions of the dynamic instability on the parameters of stationaray current, magnitude of pulse current, and duration of the pulse

    在此基礎上，給出了關于穩態工作電流、脈沖電流強度和脈沖持續時間等參數的磁彈性動力穩定性參數范圍。
  4. Current carrying connection bolts up to 1600 a ; design and assignment of current intensities

    ?以下導電連接螺栓.電流強度的設計和給定
  5. Hf - current generates warmth in tissues. this warmth rises proportionally to electrical resistance and superproportionally to the square of current density

    高頻電流流過組織時產生熱量，這些熱量和電阻抗、電流強度的平方成正比。
  6. Monthly change of positive mean current is similar to that of percentage of positive cg lightning, whereas the monthly change of negative lightning is relatively small

    正地閃的月平均電流強度變化基本與正地閃所佔比例的月變化相似，而負地閃強度變化相對較小。
  7. Multifunction of testing voltage value, current value, rf value and transient current strength

    多用途測試電壓值，電流值，射頻值及瞬變電流強度等。
  8. If a current with proper intensity has been switched on, the goal of controlling the melting and welding dimension effectively around the crack tip can be obtained

    文中給出的算例表明，適當控制通入的電流強度，可以達到有效控制裂尖熔化區尺寸以及形成焊口的目的。
  9. As the partial pressure of o2 increases the cathode voltage of the target increases in order to maintain the same current intensity and the sedimentation rate gradually decreases

    氧氣分壓的增大，維持同樣濺射電流強度的靶陰極電壓增大，薄膜的沉積速率逐漸減小。
  10. In the hall effect, hall electromotive force is not only related to the current density, magnetic field and the distance of the poles, but also to hall coefficient directly

    據知，霍耳效應中輸出的霍耳電動勢除了跟輸入的電流強度、磁場強度及輸出電極的間距有關外，還與霍耳系數成正比。
  11. The finite element method ( fe '. i ) is adopted to analyze the effects of the numbers of coil turns, current intensity and current frequency upon the rate of joule heat generation in details. the thermo - radiation analytical countermeasures of various types are adopted to carry out the numerical analysis of the effects of the crucible with different shapes and sizes and the blind holes with different depths opened in the tops of crucibles as well as coil positions upon the thermal field distribution whereby solving the main problem of field the thermo - field design of the induction - heating sic crystal growth system. a new combination idea of the thermo - field design obtained by means of the united design of the thermo - insulator and blind holes has been presented

    採用有限元分析方法對線圈匝數、電流強度、電流頻率等對焦耳熱產生速率的影響進行了詳細的分析討論；採用不同的熱輻射分析策略，對不同坩堝形狀、坩堝頂部開設不同深度的盲孔以及線圈的位置等對熱場分佈的影響進行了數值分析，解決了感應加熱碳化硅晶體生長系統熱場設計的主要問題，提出了通過絕熱層與盲孔的聯合設計獲得所需熱場設計的思路，給出了根據軸向溫度梯度的波動對線圈位置實行動態調節以控制熱場的理論依據。
  12. We also performed a nonlinear curve fitting to the intensity relation curve between pumped light and upconversion emission light, and knew that the upconversion luminescence belonged to three - photon absorption

    通過對上轉換發光強度與泵浦源電流強度關系曲線的擬合，看到這種上轉換是三光子吸收過程，這與通過能級圖分析得到的結果相同。
  13. Low - voltage switchgear and controlgear assemblies ; a method for assessing the short - circuit withstand strength of partially typetested assemblies ; identical with report iec 61117 : 1992

    低壓開關和控制組件.部分定型試驗組件耐短路電流強度
  14. Current density doubles when the area of effective contact between tissue and electrode is halved, provided that hf current remains contant

    如果高頻電流強度保持不變，那麼人體組織和電極之間的有效接觸面積減半將會使電流密度增大一倍，這將產生四倍的熱量。
  15. At last, the application of mechano - electric effect on smart concrete structures is discussed. the following conclusions can be obtained : ( 1 ) the stress induced electrical current increases with stress increasing, and decreases with stress decreasing

    取得了如下成果： （ 1 ）揭示了碳纖維混凝土和素混凝土所受載荷和由此產生的電流強度之間的一一對應關系。
  16. A method for assessing the short - circuit withstand strength of partially type - tested assemblies

    便攜式檢驗組合裝置耐短路電流強度的評定方法
  17. The phenomena and reasons of hystersis a7nd nonliearity existing in control model and driving approach on account of current, which are universally used at present, are pointed out

    指出了目前普遍採用的基於電流強度的控制模型及驅動方法存在的遲滯和非線性嚴重的現象及產生原因。
  18. Multifunction of testing voltage value, current value, rf value and transient current strength. it also acts as soldering station with option soldering pen

    多用途測試電壓值，電流值，射頻值及瞬變電流強度等外，並設置焊筆介面，可選購焊筆作為焊臺使用。
  19. The simulation results indicate that the two circuits " currents have the same frequency and the inductive current is at the same quantity class as the discharging current

    Ansys模擬的結果表明：兩個迴路的電流的頻率相同，感應迴路的電流強度非常大，與初級迴路處于同一數量級，只是落後一個相位角。
  20. Experimental results show that that the best process conditions are following : the weight ratio of nitric acid and acetic anhydride is 5 : 1, the current intensity is 500 ma, voltage is 150v, the reaction time is 30 min, then, the graphite compounds are cleaned with water till the ph = 6 - 7 and dried at 60

    實驗表明，硝酸：乙酸酐為1 5 、電流強度為500ma ，電壓為150v ，反應30分鐘后，水洗至中性後於60下烘乾，制得可膨脹石墨，經900高溫處理后，可獲得性能良好的膨脹石墨製品。
分享友人
分享到 Line

分享到臉書