電流絲 的英文怎麼說

中文拼音 [diànliú]
電流絲 英文
current filament
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Units with amperage draw of 48 amps or more require factory installed internal fusing

    安培數超過48安培的熱水器需要在工廠安裝內置保險
  2. Secondly the major mechanisms of degeneration of pcss are caused by both the filamentary nature of the current in high - gain pcss damage to the chip of the switch and the charge domain reached the anticathode causes the erosion of metal interface

    開關退化的主要原因是:開關體內的對開關晶元的損傷;以及荷疇到達陽極時來不及放而產生的荷擁擠現象對開關極接觸表面的損壞。
  3. Gas burners are ignited by a high-voltage spark in a pilot gas stream or by an electrically heated wire.

    煤氣燒嘴可在引火煤氣中用高壓火花點火,亦可用點火。
  4. Study on optimal current density to annealing fe - based amorphous wire by pulse current

    鐵基納米非晶脈沖退火的最佳密度研究
  5. We make an electron gun which consists of a tungsten wire heated by an electric current.

    我們製造了一把子槍,它包括一根用加熱的鎢
  6. Measuring methods of the heater or filament current and voltage for electronic tubes

    子管熱或燈壓的測試方法
  7. Measurements of the electrical properties of electronic tubes. part 2 : measurement of heater or filament current

    子管性能的測量.第2部分:熱或燈的測量
  8. The plasma boundary can be identified by filament current method with the magnetic signals from probes around the plasma

    摘要根據等離子體邊界附近的磁場測量信號,利用電流絲模型快速識別了等離子體的邊界。
  9. This article introduces briefly the process of design and characteristic of structure of db930 tube and discusses the main problems of technology and technique which was met during the manufacture and the measures having been adopted are emphatically. it discusses the solve measures in following six aspects : the filament current is too large, carbon deposits during the carbonizing of cathode, the capacitance between the first grid and the second grid is too large, transpiring happens inside the tube, the insulation resistance between the electrodes is too lower when the filament is on and the ability of bearing high voltage is too lower

    本文簡略地介紹了db930的設計過程及其結構特點,重點論述了在試制過程中遇到的主要工藝技術問題及解決問題的措施,圍繞解決燈大、陰極碳化時積碳、一柵和二柵之間的容大、管內蒸散、熱態時極間絕緣低、耐高壓的能力差等六個方面的問題進行了論述。
  10. When circuitry malfunction happens, the current is so strong that the fuse wire melts and breaks, and the active joint is released, as a result, the fuse tube falls and the electrical circuit is shut off

    當線路發生故障時,故障使熔熔斷,活動關節被釋放,熔管迅速跌落,將路切斷。
  11. Induction heated oil tempered spring wire is a kind of new technical material which has been developed since 1980s. it can be heated by means of eddy induced into itself through electromagnetic coil and this method is mainly used in surface quenching. with correct designing and reasonable current frequency, induction coil and heat treatment process selected, as well as plc controlling applied, the wire can be uniform heated along cross - sectional and longitudinal direction and can be quenched and tempered continuously

    應加熱油淬火-回火彈簧鋼,是二十世紀八十年代發展起來的新技術材料,在國外稱為itw induction heat oil tempered spring wire 。是通過線圈磁感應鋼本身產生的渦進行加熱,通常主要用於表面淬火。經正確設計,選擇頻率,合理的感應線圈及熱處理工藝,並實施plc控制,可使鋼整個截面及長度上得到均勻加熱,進行連續整體淬火和回火。
  12. A light bulb a filament inert gas glass bulb electric current

    燈泡燈惰性氣體玻璃燈泡
  13. Comparing to gearless traction machines, kaide series enjoy 40 % less starting current, 12 % more efficiency and physical size installation, which offer lower cost of the overall elevator configurations, such as reduced number of pilot wheels and steel ropes, and associated installation cost and trouble

    相較無齒輪曳引機,啟動降低40 % ,效率提高12 % ,又可1 : 1安裝,降低了整梯的配置成本(減少導向輪、鋼繩的數量) ,節省了安裝費用及相應麻煩。
  14. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、氣強度、絕緣阻、接地連續性、泄漏、微波泄漏、功率、溫升、濕熱試驗、灼熱、水平燃燒、垂直燃燒、漏起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性(壽命)試驗、機負載試驗、源線彎折、源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  15. The transport of reb is examined by 2d3v particle simulation in the xy plane. the filamentation and coalescence of currents and related magnetic field pattern, caused by the two - dimensional electromagnetic - beam - plasma ( embp ) instability, are observed

    在xy平面上對輸運過程進行了2d3v粒子模擬,觀察到電流絲的形成、聚合和磁場產生。
  16. Backing weld procedure technique of all - position narrow gap and thick - walled pipe welding is developed about all - position single - pass welding section analysis, wire feeding behavior, weld arc length, welding current analysis, procedure and joint test. the achievement has general guide meaning to producing and testing all - position welder

    從單焊道全位置區段、送行為、焊接弧長(壓) 、行為分析、工藝試驗和接頭檢驗等幾方面介紹管道全位置打底焊工藝特點,其研究成果對全位置焊接機的製造和調試具有普遍指導意義。
  17. Abstract : backing weld procedure technique of all - position narrow gap and thick - walled pipe welding is developed about all - position single - pass welding section analysis, wire feeding behavior, weld arc length, welding current analysis, procedure and joint test. the achievement has general guide meaning to producing and testing all - position welder

    文摘:從單焊道全位置區段、送行為、焊接弧長(壓) 、行為分析、工藝試驗和接頭檢驗等幾方面介紹管道全位置打底焊工藝特點,其研究成果對全位置焊接機的製造和調試具有普遍指導意義。
  18. The third model was designed to investigate atom diffusion at contacting point. fe was sintered at 500, 550 > 600, 650 > 700 under bpec and radiation heating. the test results of image processing indicated that the average pore size took on wavelike with temperature under bpec heating

    脈沖大加熱條件下,其它條件相同時,分別在800 、 900的溫度武漢理土大學碩士學位論文下擴散連接cu和ni,結果表明接觸線處cu和ni的擴散系數隨溫度的升高而增大。
  19. Those filaments self - organize in coaxial structures where the relativistic current in the center is surrounded by intense magnetic field and the return current sheath, and the magnetic field decreases abruptly to zero outside the relativistic current

    電流絲自組織形成同軸結構,束被強磁場和迴鞘層包圍,磁場在電流絲外迅速衰減到0 。
  20. A large number of current filaments emerge in the system

    觀察到電流絲形成、聚合和磁場產生。
分享友人