電流調節器 的英文怎麼說

中文拼音 [diànliúdiàojié]
電流調節器 英文
curl regulator
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • 調 : Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : 節構詞成分。
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. A white led driver circuit is presented in this paper. the circuit drives up to four white leds with regulated constant current for uniform intensity. by utilizing proprietary adaptive 1x / 1. 5x modes and ultra - low - dropout current regulators, it maintains the highest possible efficiency over the full 1 - cell li + battery input voltage range

    整體路以恆定驅動4隻白光led ,利用1倍/ 1 . 5倍分數型荷泵和低壓差電流調節器,在整個鋰池供壓范圍內保持最高的效率,並使四個白光led獲得均勻的亮度。
  2. Plug the flow regulator into the wall and attach the nebulizer.

    將氣調插頭接通墻上源,並連接噴霧
  3. Current regulator contact bracket

    電流調節器接角點托架
  4. Voltage regulators for direct current generators. overall dimensions and method of fixing of base

    調.底座安裝方法和外形尺寸
  5. A method of fuzzy optimization design based on genetic algorithm is presented as a new method of parameter optimization design for dc double closed loop speed adjusting system. the method covers three steps. firstly, speed overshoot rate and settling time are chosen as performance indice according to the demand of engineering. these indice are normalized by using fuzzy membership function and then weighted to form objective function of optimization model of the system. secondly, the dynamic response curve of the system with corresponding parameters and peoformance indice are obtained by computerized numerical calculation and simulation. finally, parameters of engineering design are expanded as searching space ; and parameters of speed regulator and current regulator are taken as genes in chromosome. these genes in searching space are optimized to get best solution by way of genetic algorithm. as shown by experimental results, the parameters designed by this method are capable of significantly improving performance indice of the system, which proves that it is a practical and effective method

    提出一種基於遺傳演算法的直雙閉環調速系統參數優化設計方法.根據工程技術的要求,選用速度超調量和過渡時間作為參數優化性能指標.將該指標用模糊隸屬度函數歸一化,再加權平均形成系統優化模型的目標函數.採用計算機數值計算方法,通過模擬獲得系統對應參數的動態響應曲線及其性能指標.最後以工程設計的參數為搜索范圍,以速度調電流調節器的參數為染色體中的基因,通過遺傳演算法在搜索范圍中優化這些基因,獲得優化解.實驗結果表明,所設計的參數能使系統性能指標有顯著提高
  6. The steady - state errors of current closed loop system with pi current regulator in stationary and synchronous frames are compared using complex vectors. also, the corrector of rotor displacement control is studied by the root locus method

    應用復合矢量概念,對比了靜止坐標系和同步旋轉坐標系pi電流調節器組成閉環系統的穩態誤差,並用根軌跡法對轉子位移控制系統的校正環進行了研究。
  7. For a class of shunt - wound active power line conditioner, based on analysis of mathematical model of system and target of control, the algorithm of fuzzy variable structure sliding mode control is presented. the control algorithm can avoid complicated calculation of harmonic electric current in traditional control algorithm, and realize the feedback control of electric current. the algorithm is simple and easily implemented

    針對一類並聯型有源調在分析系統數學模型和控制目標的基礎浙江大學博士學位論文上,提出了模糊滑模控制策略,避免了傳統控制方法中復雜的諧波計算,實現對的閉環控制,該演算法簡單、易於實現,模擬結果證實了變結構滑模控制的有效性。
  8. Electrical installations for lighting and beaconing of aerodromes - constant current regulator iec 61822 : 2002, modified ; german version en 61822 : 2003

    機場照明和航路信標用氣裝置.恆調
  9. Carbon - pile type current regulator

    碳堆式電流調節器
  10. It can generate high - stable and linear current signal and utilize butterworth low pass filter to eliminate the noise and ripple in the signal. according to the different functions of different pins, this circuit can modulate and control the output power of the laser diode and modulate the laser signal, which makes this laser diode driver have more valuable application. in the last part of the paper, the feasibility of the theory is validated by experiment data

    其次,根據ic - wkn的內部路和不同引腳的功能,設計了一套由d / a轉換和單片機組成的信號調路,使之能夠輸出具有良好的穩定性和線性特性的調信號,並選擇巴特沃茲低通濾波來濾除信號中的紋波和干擾。
  11. It has better output current accurate than normal 8 - channel - led driver ic with constant current, more output channels and better output current regulate accurate

    它相比以往常用的8通道led恆驅動,具有更強的多通道驅動能力、更優的輸出調精度以及更高的匹配精度。
  12. Unlike the traditional single mode of charge pump structure, the paper adopted 1x / 1. 5x fractional adaptive charge pump, which can automatically convert working mode with the change of input voltage, and utilized ultra - low - dropout current regulators to make 0. 15v led _ minimum regulation voltage in order to remain the charge pump working mostly in higher - efficiency 1x mode

    與傳統的單一轉換模式的荷泵結構不同,本文採用了1倍/ 1 . 5倍分數型自適應荷泵技術,可隨輸入壓的變化自行轉換工作模式;採用低壓差電流調節器使led陰極最小調壓僅為0 . 15v ,使荷泵更多地工作在效率更高的1倍模式。
  13. This paper studies on used the ac servo system based on ti dsp ( lf2407a ) and the foc and digital signal processing thorem, achieves following results : algorithm. we employ svpwm ( space voltage pwm ) algorithm, improve the efficiency of the electric source, and decrease the harmonious elements. we build the mathematic model of the system and simulate it on matlab platform, dsigne segmented pid regulator to adapt variable speed and widen the speed range. measurement. the velocity and electric current measuring, we adopt multi - sampling - rate and digital filter principles. as more improvements we make, the whole system gets a good results. pc control. the complete controlling system can be controlled remotely. so we develop the pc controlling program.

    採用磁場定向脈寬調制演算法,提高了源利用率,降低了逆變壓的諧波,改善了機的運行特性,降低了對網的污染;在matlab平臺上建立了交永磁同步伺服機和壓空間矢量脈寬調制控制系統的數學模型,在模擬的基礎上,對傳統pid調進行了改進,提出轉速調電流調節器採用分段pid結構,根據給定轉速所處的區間,自動選擇相應pid調的參數,拓寬了調速范圍,提高了控制精度。
  14. The general transfer functions of pwm converter are developed and the small - signal transfer functions controlled by the duty cycle are given using matlab. the voltage adjuster and the current regulator of the control circuit are designed. the isolated cuk converter is analyzed and the features and the description of the uc3854 are presented in detail

    論文分析了帶隔離變壓的cuk變換路,介紹了平均型功率因數校正晶元uc3854的結構、功能;根據uc3854的具體特點與要求,以設計一個具體、實用的帶pfc功能的開關源為例,設計、計算了主感l1 、 l2 、 c1 、 c2 、隔離變壓以及壓、電流調節器路的參數及要求。
  15. These two methods can alleviate the inrush current. this paper research voltage and current close - loop control flyback converter and isolated boost converter with peak current mode pwm controller. the start process of flyback converter is divided into three stages : inrush current, current regulating and voltage regulating stages

    分析了兩個起動過程: 1 )雙閉環控制flyback變換的起動過程,可分為過沖階段,電流調節器調階段和調調階段三個階段。
  16. Each module is controlled by voltage - current two closed - loops. the common voltage loop controls system output voltage & frequency, and generates a common reference current signal

    每臺航空靜止變模塊均為壓、雙環控制,通過公用調穩定並聯系統的輸出壓及頻率,同時產生統一的模塊給定信號。
  17. Aeronautical ground lighting electrical installation. constant current regulator. equipment specifications and tests

    航空用地面照明氣設備.恆定電流調節器的設備規范和試驗
  18. Aeronautical ground lighting electrical installation - constant current regulator - equipment specifications and tests

    航空用地面照明氣設施.恆定電流調節器.設備規范和試驗
  19. Current regulator armature spring

    電流調節器轉子彈簧
  20. Current regulator armature

    電流調節器附件
分享友人