電測功機 的英文怎麼說

中文拼音 [diàngōng]
電測功機 英文
electrodynamometer
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
  • : 名詞1 (功勞) exploit; merit; meritorious service [deed]: 戰功 military exploits; 立功 render me...
  • : machineengine
  1. Engine load simulated control system was consisted of two unattached parts of work resistance simulated control subsystem and electric bow wave dynamometer control subsystem. with the mathematic models of engine load simulation controller, which transferred the work resistance ' s change to engine load change immediately, the system can met the need of the simulation control system

    發動負荷模擬加載控制系統包括彼此獨立的作業阻力模擬控制子系統和渦流控制子系統兩部分,應用發動負荷模擬控制器數學模型,使作業阻力的變化及時轉換為發動負荷的變化,能夠滿足模擬系統的控制要求。
  2. Fuzzy control strategy for cjd alternating current electrodynamometer

    交流模糊控制策略
  3. This software can not only measure the real time data of hydroelectric plant, but also carry out the auto generate electricity on the hydroelectric plan t and ordinal startup - stop of the dynamotor. the software also carrys out the functions of alarm disposal, report forms, print and load curve

    該軟體不僅實現了對水站內各種模擬參數和數字信號的實時監能,還實現了對水站的自動發組順序啟停的控制,以及報警處理、報表列印、負荷曲線等能。
  4. There are over 80 sets test apparatus in tech - innovation centre, including : anechoic chamber, vibration tester, vibration measurement analysis, impact instrument, constant temperature and humidity facilities. salt spary test case, circle insulation withstand voltage tester, insulation resistance tester, withstand voltage tester, electric lead tester, electrical leakage tester, earth resistance tester, chassis dynamometer, chassis dynamometer control system, high stability dc resistance tester, electrical capacity tester, temperature rise test system

    中心擁有各類分析試儀器和試驗裝置80餘臺套,包括:消音室振動臺噪聲振動試分析系統沖擊儀恆溫恆濕實驗儀鹽霧試驗箱匝間耐壓分析儀絕緣阻分析儀對地耐壓分析儀泄露試儀對地試儀控制系統高精度直流試儀參數試儀帶溫升試儀復合式三坐標量儀萬分投影儀及試分析系統等。
  5. Based on the demand of power department, a full distributed multifuncitional monitoring device is studied. this instrument not only can measure the data of hydroelectric plant, but also integrate the funcition of control the dynamotor, by cooperate with the program of epigynous system, it can realization the auto generate electricity on the hydroelectric plant and ordinal startup - stop of the dynamotor. 2 furthermore, performance of integrated dft arithmetic enhances the acturacy and reliability of measure. by communication several devices can run online to be controlled dispersedly and managed centrally

    本文分析了國內外水站自動控制裝置的研究和發展狀況,尤其是國內小型水站的自動化現狀,針對現有力部門的需求,設計並實現了一種單元式的微自動監控裝置,該裝置不僅實現了對水站內各種模擬參數和數字信號的實時監能,還對水輪發組進行了調控,通過與上位處理程序的配合,可以實現水站的自動發控制、組順序啟停;在量發壓和流參數的時候,採用32點離散傅立葉演算法( dft ) ,增加了量的準確性和可靠性;通過通訊可以實現裝置的聯網運行,做到「分散控制、集中管理」 。
  6. Electric power ergograph is a load or device of absorbing power, which mainly is used of measuring power for middling torque

    是常用的負載與吸設備,主要用來對中等大小的扭矩
  7. This computer measure and control system of electrical power ergograph not only possesses abroad adjustability and flexibility, but also enhances the reliability and real - time charter of system

    這種計算控技術不僅具有廣泛的適應性和柔性,而且提高了系統的可靠性和實時性。
  8. On the running theory of electrical power ergograph and the basic control theory basis, this paper expatiate on the mathematic model and modulating speed of ergograph, and expounds the principle and ways of design of hardware and software for measure and control system, and describes the hardware and software with some frames and interfaces, and importantly recommends the way of designing software

    本文根據的工作原理和控制理論基礎,主要闡述了的數學模型和調速原理以及整個控系統的硬體和軟體設計的原理和方法,並輔助框圖和界面對軟硬體進行了詳細描述,重點介紹了系統軟體的設計。
  9. This paper, on base of analyzing and comparing the correlational measure and control product of domestic home and overseas, achieves real - timely inspecting and measuring every parameter of ergograph with more advance technology of computer measure and control and a method that software can achieve the function in substitute of complex hardware circuit

    本文在分析和比較國內外相關的控產品的基礎上,採用了較為先進的計算控技術,以軟體方法代替以往需要復雜硬體路才能實現的能,能夠對的各項參數的實時檢
  10. Switching on avr self - detecting fuction : to keep outupt voltage correct, this fuction will avoild any output immediately while the avr just swith on

    自我檢能:可防止開馬上送輸出,以確保輸出壓之正確性。
  11. The system uses the pc and the at89c52 as the control center of the system. the pc optimizes the control parameters as the calculation control unit. the at89c52 receives the various parameters by serial communication with the power measurement system and the fuel consume measurement system and the emission measurement system and the ecu and so on, then sends into pc by sharing the ram with the pc as the communication control unit

    該系統採用pc和單片at89c52為上位,以pc作為計算控制單元,對發動控制參數進行優化;單片作為通訊控制單元,與作為下位器加載系統、油耗量系統、排放量系統以及發動控單元ecu等子系統進行串列通訊接收各參數,並通過與pc共享ram送入pc
  12. It can directly control and drive the stepmotor and dc servomotor, and it can control the ac servomotor by controlling the ac transducer, and it also has the function of detecting the feedback position signal of photoelectric coder and induction phase shifter

    它能直接控制和驅動步進和直流伺服,並可通過控制交流變頻器對交流伺服進行控制,而且具有光編碼器和感應移相器位置反饋信號檢能。
  13. 5. according to the requirement of amt start up experiment, using dynamic link library to program for different kinds of data acquisition card and transferring data between pc and multi scm. in this way data can be acquired successfully and engine throttle 、 clutch locking speed and eddycurrent dynamometer torque were controlled by pc programs

    根據試驗要求,採用動態鏈接庫的方法對不同數據採集卡進行混合編程,順利地採集參數和控制發動節氣門開度及離合器結合速度,利用上下位通信,使上位控制渦流,實現了模擬加載。
  14. Engine load simulated control system was consisted of two unattached parts of work resistance simulated control subsystem and electric eddycurrent dynamometer control subsystem

    發動負荷模擬加載控制系統包括彼此獨立的作業阻力模擬控制子系統和渦流控制子系統兩部分。
  15. Reecat company adapts dc - power test system, go on speed performance test, load test, heat circulation test, durability test. use in motorcycle matching test, catalyst performance aging test

    利凱特使用的是直流系統,可進行速度特性試驗負荷特性試驗熱磨合循環試驗強化耐久試驗,主要用於摩托車匹配試驗和催化劑性能及老化試驗。
  16. Reecat company adapts dc - power test system, go on speed performance test, load test, heat circulation test, durability test. use in motorcycle matching test, catalyst performance & aging test

    利凱特使用的是直流系統,可進行速度特性試驗、負荷特性試驗、熱磨合循環試驗、強化耐久試驗,主要用於摩托車匹配試驗和催化劑性能及老化試驗。
  17. The simulation study of a ac vf asynchronous dynomometer is presented in this paper

    本文對交流變頻異步系統進行了模擬研究。
  18. Virtual instrument, which is the offspring of the computer technology and the test technology, makes full use of the resources of software and hardware of pc. it is a kind of novel intelligentized instrument systems substituting traditional instruments. it consists of hardware modules and software modules

    虛擬儀器是計算技術與試技術相結合和發展的產物,是充分利用計算的軟、硬體資源,藉助一定的硬體模塊和軟體模塊來完成傳統能的一類全新概念的智能化儀器系統。
  19. Eddy current dynamometer

    渦流
  20. According to a real ac vf asynchronous dynomometer system, first step, the paper deducts the mathematic model of the system, and analyzes the system stability on the basis of the ? irst method ? of lyapunov stability, then draws the eigenvalues of the system under the situation of the variation of different parameters, and results in finding the changing regularity of the system stability caused by varitation of variant system parameter ; secondly, sets up a system simulation model in terms of a real power feedback ac vf asynchronous dynomometer system, and emulates different running states of the system, not only analyzes methods of adjusting parameters to improve the working performance in the field of weak flux of the system, but also proves the effectiveness of the methods via simulation ; at last, compares the simulation results of the model with the experiment results of the real system, and show the nearly correctness of simulation system, and also confirms the practical usage of the simulation system as an effectively assistant tool in the process of developing and design a real dynomometer system

    首先根據實際系統工作原理推導出系統的數學模型,在系統數學模型的基礎上依據李雅普諾夫穩定性判別第一法進行了系統穩定性分析,繪制了系統不同參數變化時的系統特徵值變化圖,從而得到系統部分參數變化對系統穩定性的影響規律,為實際系統的參數設計提供了參考;然後又以系統數學模型為基礎,依據實際的封閉交流變頻異步系統建立系統模擬模型,模擬不同工況下系統運行情況,分析了改善弱磁區系統性能的某些系統參數調節方法,通過模擬證明了此類方法的有效性;最後將系統模型與實際系統的實驗結果進行了比較,驗證了模擬系統模型的基本正確性,也肯定了這一模擬系統在實際系統設計中作為輔助工具的實用性。
分享友人