電測試 的英文怎麼說

中文拼音 [diànshì]
電測試 英文
e-test(electrical test)
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
  • : 名詞(古代占卜用的器具) astrolabe
  • 測試 : test; testing; checkout; measurement
  1. Mobile multifunction optoelectronic testing system

    移動式多功能光電測試系統
  2. Our factory is established in 2004, the existing staff 80 people, workshop area 2000m2, has the production assembly line 3 and thespectrometer, the oscilloscope, the high frequency signal generator, leaks the reflectoscope reflector, the pressure resistancereflectoscope reflector, the overflow welding machine, production, thecheck - out facility and so on led lamps and lanterns simulationreflectoscope reflector

    我們廠成立於2004年,現有員工80餘人,廠房面積2000m2 ,擁有生產流水線3條及頻譜儀、示波器、高頻信號發生器、漏電測試儀、耐壓儀、溢流焊機、 led燈具模擬儀等生產、檢設備。
  3. Di - on electric one of the beijing hi - new - tech enterprise develop and manufacture lots of equipment like sf6 dewpoint meter dp100, cable fault location system cfl6000 and more. di - on electric supply the most advanced technology and equipment on such as gis surge arrestor on line monitoring, resistance measuring, ac dc metrology, thermal - temperature bridge, power transformer diagnostic and testing, cable diagnostic and fault location, sf6and oil moisture measuring, oil treatment and testing, optic fiber temperature monitoring, circuit breaker testing, relay testing and more

    迪揚氣在gis和避雷器的帶電測試與故障診斷分析,纜的故障定位與局放檢,變壓器抗器的各種診斷與溫度監, sf6的水分量與回收,絕緣油的分析與濾油處理,紅外溫與光纖在線溫,以及各種與計量,溫度計量與能計量等方面擁有世界一流的技術與成熟的儀器設備。
  4. Together with undertaking the power cords designing and researching, it usually takes 15 days to do the development for the new products. the project department has advanced testing equipments mainly including bending testing machine, inserting drawing machine, temperature testing machine, standing pulling machine, internet inspecting machine, chromatic testing machine, static testing machine, salt - spraying machine, burning testing machine, non - toxic inspecting machine

    該部門擁有的驗檢儀器包括:搖擺機2臺插拔力驗機1臺高低溫驗箱1臺立式拉力儀2臺網路儀1臺色差儀1臺靜電測試儀1臺鹽霧驗機1臺燃燒驗儀1臺低毒檢儀1臺。
  5. Inspection methods for partial discharge testing system of electric cables

    纜局部放電測試系統檢定方法
  6. Measurement system in pulsed corona discharge in water

    水中脈沖暈放電測試系統
  7. Each unit of transformer is tested in accordance with the following items : winding d. c resistance test. measurement of turn ratio and calibiation of voltage vector relation. measurement of impedance voltage and load loss

    直流匝數比量及壓矢量關系的校定阻抗壓及負載損耗的量空載損耗及空載流的量工頻耐壓感應耐壓絕緣局部放電測試外觀和尺寸的檢驗銘牌的檢驗等。
  8. Windings d. c. resistance measurement, measurement of impedance voltage and on - load loss, measurement of no - load loss and on cload current, power frequency withstand voltage test, inductive voltage with standing test, measurement of partial discharge level, inspection of appearance and dimension inspection of name plate

    直流匝數比量及壓矢量關系的校定阻抗壓及負載損耗的量空載損耗及空載流的量工頻耐壓感應耐壓絕緣局部放電測試外觀和尺寸的檢驗銘牌的檢驗等。
  9. For ensuring correct wiring, a great of active tests on site should be done before the protection is put into operation

    為確保外部接線的正確性,在零序方向保護投入運行時,我們將進行大量的現場帶電測試
  10. This paper briefly introduces the basical principles of finite element method which can be used for analysis of vehicles structure, describes the principles and methods of design optimization for vehicles structure parameters, establishes the finite element models of semi - dragging trucks, which is used to load cement dispersedly and container semi - dragging trucks, applying the ansys software, calculates the static strength, then proves the calculation results to be accurate by means of non - electric charge surveying experiment. at the same time, the author puts forward the model and methods of optimization design for structure parameters of vehicle frames, exploits the applied software of semi - dragging trucks, does optimization design. analyzes the feasibility of the optimization results, then gives the structure improve direction. besides this, the author has had initiative research about interface software, etc

    本文簡要介紹了可用於汽車結構分析的有限元法的基本理論,闡述了汽車結構參數優化設計的原理和方法,建立了散裝水泥罐式半掛車和集裝箱式半掛車車架的有限元計算模型,利用有限元軟體? ansys進行了強度分析,並對罐式半掛車通過電測試驗驗證了計算模型和計算結果的正確性;論文還提出了半掛車車架結構參數優化設計的模型和方法,開發出了半掛汽車的結構優化設計軟體,調用了ansys軟體對其進行了優化設計,分析了優化結果的可行性,並給出了該半掛車的結構改進的方向。
  11. Transient influence electricity test 12kv

    瞬態感應電測試: 12kv
  12. Standard test method for continuity of coatings in glassed steel equipment by electrical testing

    鋼制設備玻璃塗層的連續性電測試的標準驗方法
  13. Test methods for preparation and electrical testing of insulating paper and board impregnated with a liquid dielectric

    浸透液態介質的紙及紙板絕緣性電測試和制備的驗方法
  14. Functional test : the electrical testing of an assembled electronic device with simulated function generated by the test hardware and software

    功能:通過硬體和軟體對組裝子器件進行的摸擬功能電測試
  15. Aiming at the athletes in jiangsu province female weightlifting team, using the myoelectricity tester, this article analyzes the technique of this sport

    摘要針對江蘇省女子舉重隊的現役隊員,運用肌電測試儀對抓舉的技術動作進行分析。
  16. Secondly, analog eeg detecting system of higher cmrr is designed and gets well effect. thirdly, we analyzed the principle of adaptive filter, whose superiority and flexibility are proved by simulation

    其主要工作和結論如下:首先,根據腦電測試中干擾的特點,對固定濾波器的結構及性能進行了分析和模擬研究。
  17. According to this, the research of the fatigue properties of the ferroelectric films was proposed. the lead zirconate titanate ( pzt ) film was prepared by a metal - organic decomposition method. the films " physical properties were analysed by x - ray diffraction ( xrd ), scanning electron microscopy ( sem ) and hysteresis loops

    然後採用金屬有機物熱分解法制備出作為研究對象的鋯鈦酸鉛pb ( zr , ti ) o _ 3 ( pzt )薄膜,用x射線衍射儀、掃描鏡和rt6000s鐵電測試量表徵鐵薄膜。
  18. Lastly, the hardware circuit of digital acquisition system is designed, and the programs for system controlling and adaptive filter arithmetic are designed. eeg can be observed clearly after d / a switching. at the same time, eeg data is transmitted to the upper machine by serial communication, so we can see eeg waveform by virtual instrumentation

    在此基礎上,針對固定濾波器存在的問題,提出了將自適應濾波技術應用於腦電測試中,並進行了理論研究和模擬研究,設計出了能較好地濾除50hz強干擾的自適應陷波濾波器和去基線漂移的自適應濾波器。
  19. In chapter 4, the paper introduces the intensity electric test of bulk - cement delivery semi - trailer. analyzes and compares the result of experimental test and finite element calculate and educes the conclusion of which the two results are identical under the permission range of engineering error

    本文在第四章介紹了cxq9160gsn型散裝水泥半掛車的強度電測試驗,分析和比較了結果與有限元計算結果,得出在工程誤差控制范圍內兩者的結果是基本一致的結論,從而驗證了有限元計算結果的正確性,保證了將計算結果用於指導生產的可靠性; 4
  20. In the master thesis, the fatigue characteristics of the ferroelectric films under thermal load and electrical load were investigated. the thermal load was induced by a pulse laser beam of nd : yag and the electrical load was made by rt6000s ferroelectric tester t o act on the films respectively. the effect of thermal or electric loads on the films properties was discussed

    本文對鐵薄膜在循環的熱載荷和載荷作用下的疲勞特性進行了研究,分別用nd : yag脈沖激光器模擬熱載荷、用rt6000s鐵電測試儀模擬載荷作用於鐵薄膜,根據實驗結果探討了這兩種載荷對鐵薄膜性能的影響。
分享友人