電源電壓 的英文怎麼說

中文拼音 [diànyuándiànyā]
電源電壓 英文
anschluspannung
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 源 : 名詞1. （水流起頭的地方） source （of a river）; fountainhead 2. （來源） source; cause 3. （姓氏） a surname
  • 壓 : 壓構詞成分。
  • 電源 : source; current source; electric source; power pack; power supply; power source; source of power ...
  • 電壓 : voltage; electric tension; electric voltage
  1. When your voltage drops more than 10 % below what it ' s meant to be, it ' s a brownout

    當你的電源電壓跌倒正常值10 %以下時，則稱為電燈暗淡。
  2. Contrapose to the instability of the third - order charge - pump pll system, the loop optimization method is employed in system level design to decide the bandwidth and phase margin, therefore the loop bandwidth locates at the maximum phase margin to guarantee the stability of the system. according to tsmc 0. 35 m sige bicmos model, the sub - circuits in the designed pll and the whole system are simulated and verified by the cadence spectre

    5 .根據tsmc0 . 35 msigebicmos工藝模型，利用cadencespectre模擬軟體對所設計的電荷泵鎖相環路中各個模塊及整個系統進行了模擬模擬，模擬結果顯示，在1 . 5v電源電壓下，頻率為200mhz的參考輸入信號，輸出中心頻率為800mhz ，分頻電路採用4分頻，環路帶寬為10mhz ，捕獲時間大約為0 . 92 s ，功耗大約為15mw ，達到了設計指標。
  3. Hand - held electric mains voltage operated circular saws. methods for measuring the performance

    手提式電源電壓驅動式鋸床.性能測量方法
  4. Hand - held electric mains voltage operated circular saws - methods for measuring the performance iec 61176 : 1993 ; german version en 61176 : 1993

    手握式電源電壓操作的圓鋸性能測量方法
  5. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    在子電路設計中，作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;振蕩器和控制電路中尖峰脈沖噪聲抑制、兩分頻電路及死區時間設定;驅動及模式選擇電路中開關管的寬長比的選擇及模式轉換點的設計。
  6. Effect of the power supply voltage on the dynamic performance of servo amplifier

    電源電壓對伺服放大器動態特性的影響
  7. Three parameters, the fractional temperature coefficient, the sensitivity of transconductance to voltage supply and improvement factor, are introduced

    在分析中，本論文引入並使用了跨導的相對溫度系數、跨導對電源電壓的敏感度、跨導穩定性改善因子三項指標。
  8. Charge pump circuits that make use of charge accumulation in the capacitor can pump charge upward to produce voltage higher than the regular supply voltage, and they are widely used in memory circuits, such as flash memory, for the programming and erasing of the floating - gate devices

    電荷泵是一種運用電荷在電容中的積累來產生高壓（高於電源電壓）的電路，它廣泛應用在存儲器電路中，諸如flashmemory ，用於對懸浮柵器件進行寫或擦除操作。
  9. This will avoid the trouble of hand operation and protect people ' s eyes by its special fuction of maintaining the light stability under fluctuate voltage

    即可減少手動調光的麻煩，又可以保護視力，同時，它具有穩光功能，當電源電壓波動時，臺燈亮度保持不變。
  10. As the experiment results show, multiple reasons led to the offset of oscillating frequency, including diode ’ s nonlinear characteristic, fluctuation of electrical source voltage, traction of load impedance, change of environmental temperature and humidity and the design of circuit

    實驗結果表明多種因素引起了振蕩頻率的偏移，包括二極體的非線性、電源電壓的波動、負載的牽引、環境溫度濕度變化以及電路板設計方面的因素等。
  11. 50hz or 60hz independent by line voltage

    50hz或60hz independent視電源電壓而定
  12. Breadth power supply electric voltage, short circuit auto protect

    寬電源電壓，短路自動保護。
  13. Supple voltages for industrial process measurement and control instruments

    工業自動化儀表用電源電壓
  14. Effect of power voltage variation

    電源電壓變動的影響
  15. Ivpwr internal power supply voltage

    內部電源電壓
  16. Vpwr vehicle power supply voltage

    汽車電源電壓
  17. Minimum power supply voltage

    最低電源電壓
  18. Maximum power supply voltage

    最高電源電壓
  19. Analyze item by item the position of unintact cycle, the running clearance of unintact cycle, locking - deform, datum dimension regulating, repeatly install, power voltage wave and marking running etc. at the same time, we give the calculating formula to calculating the running marking random error, and use it to calculate the system error of big diameter measure instrument - - datum dimension frame error, gyro - wheel diameter error, error caused by circumstance temperature, error caused by backing distance, angle error, delay error of data collecting circuit, lathe main shaft running error, workpiece install partial error

    對不完整圓的位置、不完整圓的轉動間隙、鎖緊變形、基準尺調整、重復安裝、電源電壓波動、標記轉動等隨機誤差進行了逐項分析，並給出轉動標記隨機誤差的計算公式。對大直徑測量儀的系統誤差?基準尺尺架誤差、滾輪直徑誤差、環境溫度引起的誤差、後退距離引起的誤差、角度誤差、數據採集電路延時誤差、車床主軸回轉誤差、工件安裝偏心誤差分別進行了計算，最後對誤差進行合成。
  20. After carefully analyzed the principle of standard svpwm and traditional overmodulation methods, this paper proposed one simple and effective overmodulation scheme. experiments were carried out in one 1. 5kw induction motor and its results were recorded and analyzed by pz4000 power analyzer and the proposed scheme were proved to be effective. although there are many sensorless control methods for induction motor control, many of which are either too complicated or too sensitive to the motor ? parameter to be put into practice

    在分析了標準svpwm演算法和常見各種過調演算法的原理的基礎上，提出了一種簡單有效的演算法滿足過調控制的要求，在1 . 5kw異步電機上進行了實驗並使用pz4000功率分析儀對其結果進行了準確測量與分析，證明了本文提出的svpwm演算法可以有效地提高電源電壓的利用率。
分享友人
分享到 Line

分享到臉書