電源電阻 的英文怎麼說

中文拼音 [diànyuándiànzǔ]
電源電阻 英文
mains resistance
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 源 : 名詞1. （水流起頭的地方） source （of a river）; fountainhead 2. （來源） source; cause 3. （姓氏） a surname
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 電源 : source; current source; electric source; power pack; power supply; power source; source of power ...
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. 2000hours low impedance, suit for use in switching power supplies and high frequence circuit

    2000小時，低阻抗，適用於開關電源及高頻電路
  2. Traveling cranes, drying furnaces, transformer wiring facilities, transformer automatic inspection machines, pressure meters, insulation resistance meters, ac dc stabilized power sources, memory high coder brightness meters, light meters, film thickness meters, noise meters, hand thermometers

    起重機，乾燥爐，變壓器卷線設備，變壓器自動檢查機，耐壓計，絕緣電阻計，交流直流穩定性電源，內存快速編碼器亮度計，光度計，膜厚計，噪音計，手指尖溫度計
  3. Mining type flameproof supply and control units for use on systems up to 1100 v. specification for direct - on - line motor starters

    電壓可達1100v的系統用礦山型阻燃式電源和控制裝置.第1部分:直接起動器規范
  4. First, passive resistance network was selected as direct current biasing network, which offered direct voltage for base through the resistance voltage divider composed of two resistances, among them the upper resistance connected from the dc to base, the lower resistance connected from the base to ground. the collector connected with dc directly

    直流偏置網路採用無源電阻網路，通過由兩個電阻組成的電阻分壓器為基極提供直流電壓，上偏電阻從電源串聯到基極，下偏電阻從基極到地，集電極直接加電。
  5. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  6. Guide on the prediction, measurement and analysis of am broadcast reradiation by power lines

    電源線am廣播阻滯預測測量和分析指南
  7. Physically, the resistor is effectively the source of noise.

    從物理上來說，電阻器等效于噪聲源。
  8. In general, a precise resistor is in series with one of the resistors in wheatstone bridge to compensate the zero offset, and the other one is in parallel with another arm of the wheatstone bridge to compensate thermal zero drift. based on this principle, in this paper, a compensation method based on virtual instrument technology has been put forward. actuated by current source, a good calculation method of compensation resistors and their position in the bridge is deduced

    本文基於串並聯電阻補償法的原理，提出了一種基於虛擬儀器的誤差補償方案，推導了在恆流源供電下可以精確的計算出補償電阻大小和補償位置的演算法，並且在虛擬儀器軟體平臺labview上完成了數據採集、處理、顯示等軟體的設計，經過實驗的驗證，對傳感器的零點溫度漂移補償取得較好的效果，而對靈敏度溫度漂移的工藝補償亦有一定的效果。
  9. A model of the interface state density distribution near by valence band is presented, and the dependence of the threshold voltage on temperature, the c - v characteristics and the subthreshold characteristics are predicted exactly with this model ; the effects of s / d series resistance on the output characteristics, transfer characteristics and effective mobility of sic pmosfets are analyzed. thirdly, the output characteristics and the drain breakdown characteristics are modeled with the procedure medici. the output characteristics in the room temperature and 300 ? are simulated, and the effects of gate voltage. contact resistance, interface state and other factors on sic pmos drain breakdown characteristics are analyzed

    提出了一個價帶附近的界面態分佈模型，用該模型較好地描述了sicpmos器件閾值電壓隨溫度的變化關系、 c - v特性曲線以及亞閾特性曲線；分析了源漏寄生電阻對sicpmos器件輸出特性、轉移特性以及有效遷移率的影響；論文中用模擬軟體medici模擬了sicpmos器件的輸出特性和漏擊穿特性，分別模擬了室溫下和300時sicpmos器件的輸出特性，分析了柵電壓、接觸電阻、界面態以及其他因素對sicpmos擊穿特性的影響。
  10. Railway applications - electric equipment for rolling stock - rules for power resistors of open construction

    鐵路應用.鐵道車輛用電氣設備.開式結構的電源電阻器的規則
  11. Harmonized system of quality assessment for electronic components - sectional specification : fixed power resistors - capability approval

    電子元器件質量評定協調體系.固定電源電阻器分規范.性能認可
  12. We take advantage of the method of trying and supposing to finish the experiment. for example, we firstly compute the number of the led regarding perfect situation, then finish the experiment and rectify the numerical value. for another example, we firstly compute the resistance under the desiring situation, secondly choose appropriate resistances according to the debug result

    在試驗過程中，採用了假設法，在光源強度的選擇中，首先將led看作理想點光源，然後對其光路進行分析，計算出led需要的個數，最後在試驗中對結果進行修正;在確定光源驅動電路電阻時，也是考慮各種器件都工作在理想狀態下，然後計算出其值，最後在調試的過程中對其進行修改。
  13. After introduction of the tranlinear loop principal, the bjt current controlled conveyor has been designed by using mixed tranlinear loop voltage follower. as for modern integrated circuit, the model of mos transistor, the active resistance and the current mirror integrated circuit formed by mos transistor are introduced. the cmos current controlled conveyor has been derived from mixed tranlinear loop cmos voltage follower based on weak inversion operation

    針對現代集成電路的工藝，本文對mos晶體管的工作原理進行了簡要的敘述，討論了有源電阻和電流鏡的實現方法，並利用mos晶體管的亞閾值特性組成混合跨導線性迴路完成對應的電壓跟隨器的設計，推導出了基於cmos技術的電流控制傳送器。
  14. Design the good - working signal processing circuit of the sensor, including the signal collecting circuit of three output polars the coupling circuit using capacitance and resistance the alternating amplify processing circuit and the stabilization voltage supply circuit

    設計了性能良好的信號處理電路（包括銻化銦磁阻三端輸出型信號採集電路、阻容耦合型交流濾波放大電路和穩壓電源電路三個部分） 。
  15. Also, we select the signal collecting circuit of three output polars, the coupling circuit using capacitance and resistance, the alternating amplify processing circuit, the positive feedback retardation comparsion, the driving circuit of output current and the stabilization voltage supply circuit

    選擇了insb磁阻三端輸出型信號採集電路，阻容耦合型交流放大電路，正反饋遲滯型電壓比較器和大電流推挽驅動電路及穩壓電源電路。
  16. Developing the intelligent instrument of measuring internal resistance of dc power supply with constant voltage

    智能直流穩壓電源內阻測量裝置的研製
  17. In this paper, basic circuit models of cc - current mirror and active impedance are analysed and a new active feedback current mirror is proposed which can achieve larger output impedance, higher current transfer precision, lower power and wider signal dynamic swing

    系統地分析了電流傳送器的組成模塊? ?電流鏡和有源電阻，同時提出了一種改進型有源反饋電流鏡電路。該電路能大大提高輸出電阻，同時能保持原電路的電流轉換高精度、低功耗、更寬更良好的輸出電壓動態范圍。
  18. Quantitative analysis of the action of electronic filter resistance in power source

    電源電子濾波電阻作用的定量分析
  19. Constant stator magnetic linkage control frequency converter includes power devices utilizing igbt, drive circuit using three - phase drive ic with multiple protection functions. pwm signal formation circuit in the way of voltage space vector control and realized with pld ( programmable logic device ) devices and compensation for the influence of supply voltage variation and stator resistance voltage drop

    其中，恆定子磁鏈控制變頻器的設計中主電路採用功率器件igbt ；驅動電路採用三相多功能集成驅動晶元； pwm脈寬調制信號產生電路採用電壓空間矢量控制方式，由pld器件實現；對電源電壓變化及電阻壓降造成的影響進行了補償。
  20. Flame - retardant and fire resistant flexible cables for power supply system of communication

    通信電源用阻燃耐火軟電纜
分享友人
分享到 Line

分享到臉書