電燈燈絲 的英文怎麼說

中文拼音 [diàndēngdēng]
電燈燈絲 英文
electric lamp filament
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 名詞1. (照明等用的發光器具) lamp; lantern; light 2. (燃燒液體或氣體用來對別的東西加熱的器具) burner 3. (俗稱電子管) valve; tube
  • 電燈 : [電學] electric lamp; electric light電燈插頭 lamp plug; 電燈電流 lamp current; 電燈電路 lighting ...
  1. The cathode at the left is raised to a high temperature by the heater, and electrons evaporate from its surface.

    左邊的陰極被加熱到高溫,同時子從陰極表面蒸發出來。
  2. 14. no warranty will be delivered to such consumables as nozzle, cylinder body caulking, washer, seal ring, o - ring, motor brush, capacitor, bulb, fuse, battery, fan, belt, paper filter element, glass sheet, fuel and lubricant

    下列消耗品:噴油嘴缸體堵頭,墊片密封圈o型圈機刷泡保險熔池風扇皮帶紙濾蕊玻璃板燃油和潤滑劑。
  3. The source of electrons in an electron microscope is a heated filament.

    子顯微鏡中的子源,是一加熱的
  4. Series of filament voltage and heater voltage for electron tubes

    子管與熱壓系列
  5. The liberation of electrons from a hot wire is called thermionic emission.

    子從熱逸出,叫做熱子發射。
  6. The effect is caused by the escape of electrons from the hot filament.

    這個效應是由於子從熱逸出而引起的。
  7. Measuring methods of the heater or filament current and voltage for electronic tubes

    子管熱流和壓的測試方法
  8. Measurements of the electrical properties of electronic tubes. part 2 : measurement of heater or filament current

    子管性能的測量.第2部分:熱流的測量
  9. This article introduces briefly the process of design and characteristic of structure of db930 tube and discusses the main problems of technology and technique which was met during the manufacture and the measures having been adopted are emphatically. it discusses the solve measures in following six aspects : the filament current is too large, carbon deposits during the carbonizing of cathode, the capacitance between the first grid and the second grid is too large, transpiring happens inside the tube, the insulation resistance between the electrodes is too lower when the filament is on and the ability of bearing high voltage is too lower

    本文簡略地介紹了db930的設計過程及其結構特點,重點論述了在試制過程中遇到的主要工藝技術問題及解決問題的措施,圍繞解決流大、陰極碳化時積碳、一柵和二柵之間的容大、管內蒸散、熱態時極間絕緣低、耐高壓的能力差等六個方面的問題進行了論述。
  10. All the lights have fused.

    由於保險燒斷,都滅了。
  11. Each electrode is a filament for providing electrons to maintain an electric discharge through an inert gas.

    每一極是一,它發射子,以通過惰性氣體來維持放
  12. A light bulb a filament inert gas glass bulb electric current

    惰性氣體玻璃
  13. When lights fuse, furniture gets rickety, pipes get clogged

    保險斷了,傢具因榫頭運動而東倒西歪了,水管堵塞了。
  14. Is a hard, brittle, corrosion - resistant, gray to white metallic element extracted from wolframite, scheelite, and other minerals, having the highest melting point and lowest vapor pressure of any metal

    顏色呈灰色或棕黑色,硬度高,延性強,熔點極高,常溫下不受空氣侵蝕主要用途是製造和高速切削合金鋼,各種鎢極,也用於光學儀器,化學儀器方面。
  15. " it used to be that biologists worked so intimately with their date that it allowed for out - of - the - blue moments, such as the discovery of penicillin or the light bulb, " said genome center of wisconsin mathematician christine heitsch

    為美國威斯康辛基因研究中心數學家克莉汀海契說:以往生物學家做研究時多半很貼近數據和資料,因而偶有意外的收獲,如發現盤尼西林或泡。
  16. Edison ' s efforts to invent an electric light bulb did not pan out until he used tungsten wires

    愛迪生發明泡的努力直到使用鎢才獲得成功。
  17. Fire hazard testing for electrotechnical products - test methods - glow - wire test

    工產品的火災試驗.試驗方法.熱試驗
  18. Grid filament capacitance

    柵極
  19. The filament circuit analysis and wrong check of the tem

    透射子顯微鏡路分析和故障檢修
  20. The electricity makes the filament burn and produce light

    使發熱產生光。
分享友人