電磁感應輸入 的英文怎麼說

中文拼音 [diàncígǎnyīngshūrù]
電磁感應輸入 英文
electromagnetic induction input
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 感 : Ⅰ動詞1 （覺得） feel; sense 2 （懷有謝意） be grateful; be obliged; appreciate 3 （感動） move; t...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 電磁 : [電學] [物理學] electromagnetism電磁安（培） abampere （電磁系電流單位）; 電磁泵 electromagnetic ...
  • 輸入 : 1 （從外部送到內部） import 2 [電學] input; entry; entering; in fan; fan in; 輸入變壓器 input tra...
  1. The low - melting - point sn - pb - bi alloy was used as simulacrum to investigate the distortion of meniscus

    結果表明：當電源輸入頻率增大時，結晶器內的磁感應強度減小。
  2. The distribution of magnetic induction in rectangular soft - contact mold during electromagnetic continuous casting ( emcc ) was investigated considering the electric frequency

    摘要研究了在電磁軟接觸連鑄過程中，電源輸入頻率的變化對矩形電磁軟接觸結晶器內的磁感應強度分佈規律和彎月面變化情況的影響。
  3. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  4. The control tactics of space voltage vector are investigated, and the simplified algorithm which judges the sector location of reference vector and calculates switch operation time is put forward. by analyzing the current hysteresis control, the relation between switch frequency, and hysteresis bandwidth and input inductance of pwm rectifier is deduced. by applying instantaneous power theory, the principle of pwm rectifier power control is analyzed, and the direct power control by matlab toolbox through estimating active power and reactive power with virtual flux is realized, and the simulation results prove that it is correct

    對常用空間電壓矢量控制策略進行分析，提出了給定參考矢量所在區間判斷的簡化方法，以及電壓矢量作用時間的求取方法；分析了電流滯環控制策略，推導出開關頻率與滯環帶寬以及整流器輸入電感之間的關系；應用瞬時功率理論分析pwm整流器功率控制原理，通過虛擬磁鏈估計有功功率和無功功率，用matlab實現了直接功率控制，並驗證了該控制方法的正確性。
  5. The structure of this magnetic inducting crankshaft position sensor assembly is simple, reliable easy for installation and use, being a crucial part of electronically controlled engine. as one of the important input signal of ecu controller, the sensor assembly can transmit stable cranking signal under any rotating speed of engine and ensures the stability of the performance of electronically controlled engine in respect of oil consumption, exhaust and output

    該磁感應式曲軸位置傳感器總成結構簡單，工作可靠，安裝使用方便，是電控發動機重要關鍵的部件作為ecu控制器重要的輸入信號之一，該傳感器總成能在發動機任何轉速輸出穩定的曲軸角度信號，可確保電控發動機在油耗排放輸出功率方面的性能保持穩定。
  6. The steady state and transient characteristics of the aceg system are simulated, the harmonics of the emf and stator current and rotor current as well as mc ' s input current are researched. the operation characteristics of aceg with mc as an exciter are compared to those of aceg with ac - dc - ac converter and cycloconverter as an exciter. the results in this thesis will be helpful to the design of the aceg excitation control system

    利用所建模型，對交流勵磁發電機系統的穩態調節特性、暫態特性進行了模擬研究；模擬研究了發電機定、轉子電流和感應電勢及變頻器輸入電流波形，並作了相應的諧波分析；與交-直-交變頻器和交-交變頻器作勵磁電源時發電機的運行特性進行了對比分析。
分享友人
分享到 Line

分享到臉書