電荷差 的英文怎麼說

中文拼音 [diànchā]
電荷差 英文
charge difference
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 荷名詞(蓮) lotus
  • : 差Ⅰ名詞1 (不相同; 不相合) difference; dissimilarity 2 (差錯) mistake 3 [數學] (差數) differ...
  1. A white led driver circuit is presented in this paper. the circuit drives up to four white leds with regulated constant current for uniform intensity. by utilizing proprietary adaptive 1x / 1. 5x modes and ultra - low - dropout current regulators, it maintains the highest possible efficiency over the full 1 - cell li + battery input voltage range

    整體路以恆定流驅動4隻白光led ,利用1倍/ 1 . 5倍分數型泵和低壓流調節器,在整個鋰池供壓范圍內保持最高的效率,並使四個白光led獲得均勻的亮度。
  2. Abstract : this paper, by analyzing the effect of differences of mineral structure of 2 1 layer minerals, the properties of their interlayer charge and changes of some properties caused by weathering on the attractive force for interlayer cation, reached the conclusion that : the fixation capacity is determined by the ratio of the total amount of interlayer charge and that of tetrahedral charges. the relationship of interlayer cation fixation and octahedral structure of secondary minerals is probably different from that of primary minerals. the oxidation and reduction of variable valence cations can greatly influence the cation fixation capacity

    文摘:分析2 1型礦物的結構異、層間性質以及在風化過程中某些性質的變化對層間陽離子吸引力的影響,對已有報道中一些矛盾的結果或不具普遍意義的結論進行了討論.得出幾個較為明確的結論:層間總與四面體所佔比例大小共同決定礦物對層間陽離子的固定能力;原生礦物中八面體結構與層間陽離子固定間的關系對次生礦物而言,也許並不一致;八面體中可變價陽離子的氧化還原,可導致礦物固定陽離子能力發生較大變化
  3. After analyzing the sense principles and calculation expression for piezoelectricity, we compose a sense network, compare the difference between the voltage amplifier and charge amplifier, give out the electric circuit of piezoelectric sensor for measure system

    在分析了壓片對動態應變的傳感原理和計算表達式后,該系統採用壓傳感器組建了一個傳感器網路。並且對比了壓放大器和放大器的異。
  4. The carrier wave is modulated directly by the baseband signal at several frequency point in l band and s band. firstly, this paper clarifies the theory of i / q modulation, elaborates evm and acpl, and analyzes the effect of amplitude and phase unbalance and dc offset on evm. secondly we review the basic principle of phase locked loop and it ’ s composing parts, including the basic conception and design method of pll frequency synthesizer, especially introduce the charge pump pll frequency synthesizer in detail

    首先,在闡述i / q正交調制基本原理的基礎上,通過對誤矢量和鄰近通道功率泄漏的詳細分析,定性、定量地討論了各種非理想路因素(如相位不平衡、幅度不平衡、直流偏等)對調制器性能的影響;其次,介紹了鎖相環的工作原理和基本組成部分,包括鎖相環的設計和環路濾波器的設計,特別詳述了泵鎖相頻率源;第三,介紹了採用直接調制技術模擬衛星信號的射頻前端的設計;最後,對整個直接射頻調制系統進行測試,結果基本上達到了課題要求。
  5. In this paper, based on the amplitude transport equation of fast varying field and the low frequency disturbance equation of electr on density, the evolutions of the density distribution of charged particles and the collapse of electric field have been calculated numerically in two dimensions with three field components under the condition of transverse wave

    所以本文採用了ftcs有限分格式方法,利用二維三分量軸對稱,對空間飛行體與壓縮區內等離子體非穩態相互作用過程進行數值模擬,得到了密度擾動與場的變化情況。
  6. The safety of transmission line plays a important role in power system safety it is not only the requirement of ensure supply power reliability, but also the necessary precondition of enhance power system stabilization, to remove faulty line quickly and accurately, also keep non - faulty line continuous work when some transmission line faults current differential protection is a kind of simple, reliable and good - selective protection manner to any variety of transmission lines, power system development needs current differential protection apply to transmission lines, moreover the advancement of electric and communication technology enable current differential protection apply to transmission lines firstly, the paper discusses, analyses the research and application transmission line protection in detail, compare the principle and realistic presupposition of general line pilot protections secondly, because conventional current vector differential protection are influenced easily by load current and transitional resistance, in order to at the same time quicken protection act, the principle and criterion include work characteristic of differential protect based on fault component sampled values are studied, results shows that differential protect based on fault component sampled values excels general vector current differential protection in reliability, sensitivity and anti - saturation of current transformer in addition, synchronous current sampling methods at all terminals of line is analyzed and estimated lastly, the principle and criterion. also device design about current sampling values differential protection based on optical fiber communication, which apply to short transmission lines are concretely investigated,

    基於基爾霍夫定律的動保護無論對於何種形式的輸線路都是一種簡單、可靠、選擇性強的保護形式,力系統的發展使得動保護應用於線路保護成為需要,而子、通信技術的發展使得動保護應用於輸線路成為可能。首先,本文對目前線路保護的研究和實際應用情況進行了討論和分析,比較了常用線路縱聯保護的實現原理和實現條件及優缺點。其次,針對常規相量動保護易受正常負流和故障過渡阻影響的缺點,同時為加快動保護的動作速度,對基於故障分量瞬時采樣值動保護的原理、判據、動作特性等作了討論和分析,結果表明基於故障分量瞬時采樣值動保護在可靠性、靈敏度、抗流互感器飽和方面明顯優于常規相量動保護,對動保護各端的同步采樣方法和數據通信也進行了分析和評價。
  7. Abstract : three theory problems about technology of leather making are discussed. the first is the difference between surface charge and isoelectric point ( pi ). the second is about the origin of the calculation formula of basicity in making cr3 + liquor. the third is the swelling mechanism of a skin or hide in basic medium

    文摘:本文討論了皮革製造中的三個理論問題,一是表面點( pi )之間別,二是三價鉻鞣液配製中公式的簡單來源,三是生皮在堿液中膨脹的機理。
  8. The ramp - type sustain waveform is featured with the longer rise - time than the conventional waveform and it is a compromise to let gas discharge with lower cell voltage but still helps accumulate enough wall charges to sustain discharge sequence in cells

    斜緩維持波形的特徵為其壓上升時間較傳統波形增加了三倍左右,其有助於降低氣體放時的空間和累積足量的壁以維持腔體中氣體放作用得以連續產生的效果。
  9. Because of differences such as charge, size and shape and mobility, the various complexes of metal behave differently chemically.

    由於諸如、大小、形狀及淌度的別,各類金屬混合物呈現不同的化學性質。
  10. Based on the theory of charge calibration and sample and reconstruction of frequency limited signal, the scheme of adopting direct digital synthesizing technology and technology of computer is put forward in the paper. the design of hardware and software is described in detail, the error of the outputs signals of the high precision charge calibrator has been analyzed in theory

    文中基於校準的原理及帶限信號的抽樣與重構理論,提出了採用直接數字合成技術與計算機技術的整體設計方案,詳細講述了硬體路與系統軟體的設計過程,並對高精度校準儀輸出信號的誤進行了理論分析。
  11. The measurement system consist of computer, 16 - channel high speed data acquisition board, spark plug pressure sensor, crank angle signal generator, charge amplifier and oscillograph. the max acquisition frequency of this system is 1mhz

    由通用微機、 16通道無相高速數據採集卡、火花塞式壓力傳感器、角標信號發生器、放大器、示波器組成的高速數據採集系統,最高總采樣頻率為1mhz 。
  12. This article uses the law of electricity image, the differences of the intensity of electric field of some electric charges under not changing the distribution with electric conductor ball electric charge and changing with distribution of electric conductor ball of change are studied

    摘要運用像法,研究了任一點在不改變帶導體球的分佈及改變帶導體球的分佈兩種情況下所形成的場強度的異。
  13. A new novel fully - differential charge pump was designed in this paper, differential input and differential output was used in this circuit

    摘要採用分輸入和分輸出方案,設計了一種新型的全泵。
  14. After the discussion of the numerical simulation method based on the fdtd method and the pml technique, the motions of the charges and the electrical field lines were first employed to describe the radiation procedures of the pulse electromagnetic waves. then the causes of how the charges are accelerated and how the motion status of the charges are maintained were further studied from the angle of interaction of charge and field. after these analyses, it was pointed out that the pulse radiation is due to the suddenly occurred time - varying electrical field ( displacement current ) in the open space. this view was further evidenced by two examples : one is the partly resistance loaded antenna, the other is the partly curved antenna. the radiation procedures of the pulse electromagnetic waves of many different situations were simulated throughout this paper with the contours and waveforms of electric field given. these figures are very helpful to the understanding of the radiation mechanism of the pulse electromagnetic waves

    在討論了基於時域有限分法和完全匹配層技術的數值模擬方法之後,首先從運動力線的角度直觀地描述了脈沖磁波的輻射過程,然後進一步從場與相互作用的角度分析了天線上是如何被加速以及如何維持其運動狀態的,指出了開放空間中突然出現的時變場(位移流)是脈沖磁波輻射的根本原因.文中還對局部阻加載的天線和局部彎曲的天線進行了研究,以進一步說明上述觀點.對多種情況下的脈沖輻射過程進行了數值模擬,並給出了場的等高線和空間波形圖,這些圖形對理解脈沖磁波的輻射機理非常有益
  15. Ambient temperature range in which the force transducer may be stored free of mechanical or electrical loading, without the error limits being exceeded on subsequent use of the transducer within the nominal temperature range

    力傳感器不受機械或載時,在標準溫度范圍內,傳感器在後續使用中不超出誤標準的情況下的儲藏環境溫度。
  16. A difference of statcoulombs existed between the magnitudes of each changes.

    這兩種的大小存在著靜庫的別。
  17. < uk > a difference of statcoulombs existed between the magnitudes of each changes. < / uk >

    < uk >這兩種的大小存在著靜庫的別。 < / uk >
  18. The platform is widely applied in precision engineering, ultraprecision machining and et al, which consists of a mechanical elastomer, two piezoelectric actuators, two driving circuits based on charge - feedback, two linear variable differential transformers, and a numerical control device based on c8051f021

    該平臺主要由機械彈性體、壓作動器、壓作動器驅動路及反饋迴路、動變壓器測微儀和c8051f021單片機控制裝置等構成。
  19. Unlike the traditional single mode of charge pump structure, the paper adopted 1x / 1. 5x fractional adaptive charge pump, which can automatically convert working mode with the change of input voltage, and utilized ultra - low - dropout current regulators to make 0. 15v led _ minimum regulation voltage in order to remain the charge pump working mostly in higher - efficiency 1x mode

    與傳統的單一轉換模式的泵結構不同,本文採用了1倍/ 1 . 5倍分數型自適應泵技術,可隨輸入壓的變化自行轉換工作模式;採用低壓流調節器使led陰極最小調節壓僅為0 . 15v ,使泵更多地工作在效率更高的1倍模式。
  20. This can be reduced by borrowing close loop feedback which cost great and make the system more complex. with charge driver the pizeo acuter works under ideal linear. but charge driver is lack of low frequency stability

    而採用壓驅動方法控制壓陶瓷,開環時存在遲滯、蠕變和位移非線性;採用驅動方法,開環控制線性良好,但低頻穩定性
分享友人