電路功率因數 的英文怎麼說

中文拼音 [diànlùgōnglǜyīnshǔ]
電路功率因數 英文
circuit power factor
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 功 : 名詞1 （功勞） exploit; merit; meritorious service [deed]: 戰功 military exploits; 立功 render me...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 因 : Ⅰ動詞[書面語] （沿襲） follow; carry on Ⅱ介詞1 [書面語] （憑借; 根據） on the basis of; in accord...
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. Monitor apparatus can measure valid value of three phase voltage and current, power factor, three phase disequilibrium, instant flecker of short time and harmonic without twenty, degree and harmonic distortion total. the paper are laid on the following. ( 1 ) master plan and function of circuit, ( 2 ) hardware design including circuit and principle of a / d conversion, phase lock, liquid crystal display and keystroke and so on, ( 3 ) design of system software including digital filtering, fft, a / d conversion and monitor interface of pc, ( 4 ) system test

    監測儀能夠完成包括三相電壓、三相電流的有效值、功率因數、三相不平衡、電壓短期閃變、以及20次內的諧波、諧波相位、諧波失真總量等的測量。論文重點介紹了以下幾部分： （ 1 ）電路的總體設計和功能； （ 2 ）硬體設計，包括a d轉換、鎖相環、液晶顯示和按鍵輸入等原理和電路。 （ 3 ）系統軟體設計，包括a d轉換、 fft 、數字濾波等程序的原理和演算法以及上位機監控界面的設計； （ 4 ）系統測試。
  2. Heating principle of intermediate frequency induction furnace and some factors affecting its power factor are discussed, some betterments that parallel connection spacer circuit is replaced by interfusion connection spacer circuit are put in practice

    摘要對中頻感應爐的加熱原理以及其功率因數的影響因數進行了探討，並將不能恆功率輸出的並聯逆變電路改進為混聯逆變電路。
  3. Intelligent electricity quantity concentration display instrument is a kind of intelligent instrument used to measure combined parameter of ac electricity quantity, which can simultaneously measure each phase electricity parameter in the tri - phase ac loop such as voltage, current, active power, reactive power, apparent power, power factor, frequency, active kilowatt hour, reactive kilovolt ampere - hour and so on

    智能電量集中顯示儀是一種用於交流電量綜合參數測量的智能儀表，它可以同時測量三相交流迴路的每一相電壓電流有功功率無功功率視在功率功率因數頻率有功電度無功電度等參數。
  4. Texas instruments incorporated, “ understanding buck - boost power stages in switchmode power supplies ”, march 1999

    宋自恆、林慶仁」功率因數修正電路之原理與常用元件規格」 ，新電子科技雜志第217期， 2004年4月號。
  5. Two circuits, characterized by high power factor and low output voltage, are proposed. one is originated from the concept of charge pump, and the other functions in the same principle with so - called buck - boost circuits

    最後提出了兩種功率因數校正的電路拓撲：一種是由電荷泵原理引出的；另一種是基於buck - boost原理工作的電路。
  6. And at this foundation through the dispersed domine analyse the paper makes a great emphasis on the application of computer aided design and simulation, then designs a series of apfc design and simulation software. this paper takes out a set of designation and simulation on base of actual circuit. the reliable result, output voltage and inductance current which are got from this software are the same as the actual value

    本文在對一系列apfc電路設計、模擬分析方法討論比較的基礎上，著重應用離散時域法進行了計算機輔助電路設計和模擬方法的應用探索，以此為基礎設計了pfcexpert功率因數校正電路設計、模擬軟體，針對實際電路給出了整個設計和模擬全過程，通過實驗驗證了該軟體所得到的精確穩態解、瞬態輸出電壓和電感電流，與實際電路輸出基本相同，所建立的電路模型重現了電路的運行過程，反映了電路的實際工作機理。
  7. It not only solves the problem of optimized control of the reactive current exchanging among branches, in other words, realizes the auto - tracking to the reactance factor, but also greatly improved the reliability of the system. to design the high voltage line wireless signal acquisition device with self - feed source, we applied electromagnet induction principle and digital communication technique

    系統在優化控制技術中採用了電容器補償控制的兩段控制模型，不僅解決了分支線路之問穿越無功電流的最優控制問題，實現了功率因數的自動跟蹤，而且使整個系統的可靠性大大提高。
  8. Under the result of the inverter ' s steady sate study, the limitation limited by two factors : the minimum time of opposing voltage and the ajustive range of power factor can be gained. a qualitative analysis method based on energy decomposing is applied to study the initialized energy

    在討論串並聯逆變器穩態工況的基礎上，從最小反壓時間和功率因數調節范圍兩個限制條件，求出允許的穩態運行極限負載，啟動電路在此極限負載下能可靠地啟動就足夠了，追求更高的啟動能力沒有實際意義。
  9. It can acquire the voltage on the test appliance and current in the circuit. and it can see these electrical signals as its input and calculates based on the data and gives the parameters and waveform that user needed. the parameters we can get through calculation include power factor, joule ' s integral, available value, maximal value, minimum value, time constant etc. recently, there are many scholar is studying the algorithm that calculate the parameter using test data, but many of them adopt the heuristic method, not using the test data directly

    本課題研製一套電器試驗參數高速採集系統，能夠檢測試驗迴路中試品上的電壓信號和迴路中的電流信號，並根據這些電信號的數值利用計算機進行在線計算，並給出用戶需要的各種電參數值和用戶需要的波形圖，通過計算得到的電器參數有功率因數、焦耳積分、有效值、最大最小值、時間常數等。
  10. With an aim at this problem, this paper suggests the modulation scheme with dc bus voltage ripple by using the front - end active power factor correct circuit based on the analysis of necessary conditions of producing acoustic resonances

    針對這一現象，在分析產生聲諧振的必要條件的基礎上，重點提出了利用前級有源功率因數校正電路的直流母線脈動電壓的調制方案。
  11. The basic theory for all sorts of power factor correction is analyzed, and the topology and control circuit are studied

    分析了各種功率因數校正的基本工作原理，並從主電路的拓撲形式和控制方式分析了各類有源功率因數校正的方法。
  12. This thesis describes the main characters and development of pfc technology, analyzes the means and basal theory of all kinds of pfc technologies on structure of the main circuit and control mode, and illustrates the necessary and importance of the digital pfc

    本文主要介紹了功率因數校正技術的發展及主要特點，從主電路的拓撲形式和控制方式分析了各類有源功率因數校正的方法和基本原理，闡明了數字控制pfc技術研究的必要性和重要性。
  13. It is linked serially to rotor of wound - type electromotor and can enhance power factor of electromotor

    它串接于交流繞線式異步電機的轉子迴路，用以提高電動機的功率因數。
  14. Quick and frequent cutting for a few sets of capacitors shall be carried out, of which the factors of electric power shall be maitained in optimum condition so as to minimize the line loss, increase effective output capacity of distrubuting transformer and optimize the quality of power demand

    對多組電容器進行快速而頻繁的投切，使受電功率因數始終保持在最佳狀態，從而最大限度地降低線路損耗和增加配電變壓器的有效輸出容量，優化用電質量。
  15. With promulgation and obliging actualization of iec 1000 - 3 - 2 etc. international standards, power factor correction ( pfc ) technique become a hotspot of research in power electronics field. based on average current mode, the paper introduce the design and implementation of a fully digital controlled single - phase boost power factor corrector with fast response. the control - loop circuit is realized using digital control and the corrector can tend to unity power factor, lower current harmonics and high transfer efficiency

    本文在平均電流模式控制的有源功率因數校正技術的基礎上，設計了一種控制電路基於數字信號處理器（ dsp ） 、主電路採用boost變換器拓撲結構的全數字單相功率因數校正器，用數字電路代替傳統的模擬電路來實現對整個迴路的控制，最終使得校正器具有輸入功率因數接近於1 、低電流諧波以及高轉換效率的特性。
  16. Methods of power - factor - measurement for low - voltage inductive test circuits

    低壓感應測試電路功率因數的測量方法
  17. Guide for methods of power factor measurement for low - voltage inductive test circuits

    低壓電感試驗電路功率因數的測量方法指南
  18. According to the fact that power factor of low voltage power networks is very low in china and field bus technology is developing in the world, in order to enhance power factor of low voltage power networks, on the basis of central transmitting and controlling information among every compensation equipment, the author of this dissertation studies systematically the design principles of power factor dynamic compensation system. based on analyzing structure of control system at present, the author of the dissertation puts forward a distributed completely and multi - layer structure framework based on field bus technology and builds a power factor intelligent dynamic compensation system. the functions of compensation unit, intelligent node, host computer, are presented

    根據目前低壓電網用電負載功率因數偏低和國內外現場總線技術的應用現狀，立足於提高交流電機的功率因數，基於將每個補償裝置進行集中監控、信息集中傳遞的思路，本文作者在分析現有的控制系統體系結構的基礎上，提出了基於現場總線技術的全分散式多層控制系統的體系結構，構建了功率因素智能動態補償系統；對補償執行單元子系統、智能節點子系統、上位機子系統三部分進行了功能分析。
  19. It is one of the most important works to run economically in today and future. the system of electric control automation in zhao zhaou is open, it bases on the net of rs485 bus control and centrally manages substation by control the main machine. the system controls the run parameter of electric equipment and the run environment by using the computer measure, communication and automation technology, it can realize measure, communicate, control and allocate in the remote area, transmit data and control through collect data and automatic count parameter

    肇州縣電力調度自動化系統是以rs485總線工業現場控制網路為基礎，通過監控主機對變電站進行集中管理的完全開放式系統，該系統綜合了計算機、測量、通訊和自動化的專業技術來監控電力設備的運行參數、監控運行環境，通過對輸變電線路及設備的交流電壓、電流的數據採集，自動計算出功率、電量、功率因數、頻率等參數，實現四遙：遙測、遙信、遙控、遙調及數據傳輸和監控功能。
  20. Fuses for voltages exceeding 1000 v a. c. guide to the determination of short circuit power factor

    1000v以上交流電熔斷器.第3部分:短路功率因數測定指南
分享友人
分享到 Line

分享到臉書