電路恢復信號 的英文怎麼說

中文拼音 [diànlùhuīfùxìnháo]
電路恢復信號 英文
reset circuit signal
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 復 : Ⅰ形容詞1 （重復） repeated; double; duplicate 2 （繁復） complex; compound Ⅱ動詞1 （轉過去或轉過...
  • 號 : 號Ⅰ名1 （名稱） name 2 （別號; 字） assumed name; alternative name3 （商店） business house 4 （...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. The clock recovery block of usb2. 0 transceiver macrocell consists of phase locked circuit, such as pll and dll ( delay locked loop ). this block use external crystal 12mhz sin signal to produce 60mhz, 120mhz, 480mhz clock signal, and can recover colock signal form date wave. it can support 480mbps ( hs ) and 12mbps ( fs ) word speeds as defined in usb2. 0 specification.

    目的是用鎖相環電路? pll和dll （延遲鎖相環）實現usb2 . 0收發器宏單元utm的時鐘恢復模塊。其中pll環路構成的時鐘發生器將外部晶振的12mhz正弦信號生成60mhz 、 120mhz 、 480mhz等本地時鐘信號。 dll環路依據本地時鐘信號對外部數據信號進行時鐘恢復。
  2. Chapter 3 treats the algorithm implementation of demodulator in the receiving asic of dvb - s. in detail, demodulation includes carrier recovery and symbol synchronization. together with the transmission characterization of band - limited input signals the chapter proposes a scheme for implementing carrier recovery loop

    解調具體分為載波恢復、時鐘同步兩大部分，本章著重論述了載波恢復的原理並結合dvb - s輸入信號傳輸特性，提出了相應的實現方案，對部分電路進行了性能分析。
  3. According to the effect mechanism of mutual coupling on the system, a method of mutual coupling compensation in antenna arrays is proposed, a comparison of compensation results between the proposed method and the conventional method is made

    根據互耦對系統的作用機制，給出了補償互耦影響的方法，把用此方法和用開路電壓補償法得出的恢復期望信號做了比較，補償效果明顯優于開路電壓法。
  4. The demodulation circuit interfaced with the local bus, demodulates the signals transmitted on the pstn and restores the acquired data. in order to work nomally, hardware needs cooperation with software. the driver for pci demodulator has been developed

    本地總線上掛接解調電路，對傳輸來的信號進行解調，恢復採集的數據。硬體需有軟體的配合才能正常的工作，因此為pci解調器設計了驅動程序。
  5. Abstract : the rechargeble batteries are used for backup power internal electrically equipments and instruments. but batteries lifetime usually is shorten by overwork and then malfunctions of equipment are induced. to avoid the complexion described above, the protection circuit against overwork is designed. it is based upon the voltage comparator and regulator. it will light up a red led when the volume of the batteries discharged close upon 50 % ; it will switch off the load automatically when it discharged closing to 80 % of their energy capacity, thus overwork of batteries can be avoided and lifetime may be extended

    文摘:用蓄電池做后備電源的系統（或設備） ，常因過放電導致電池提前報廢而造成設備故障.根據電池電壓隨容量變化的規律，利用電壓比較器和電壓基準源設計製作了電池放電保護電路，當電池放電量接近容量的50 %時，啟動預警信號；當電池放電量達到容量的80 %時，電路自動切斷負載，防止電池過度放電，延長電池壽命，保證系統（或設備）在供電恢復正常后能正常運行
  6. The logical architecture, protocol, the encoder algorithm, the decoder algorithm and the electronics specification of the tmds which is the core of the dvi and means transition minimized differential signal are described in particular in this paper. and the synchronization and data recovering which mean the central problem in the high speed serial data communications are also analyzed

    本文以dvi介面通訊協議為主線，詳細介紹和分析了作為介面核心內容的tmds ? ?最小變化差分信號的邏輯架構、通訊協議的編碼演算法、解碼演算法、 tmds信號的電氣規范等問題，並著重分析了作為高速串列通訊的關鍵問題的鏈路時鐘同步與數據恢復問題。
分享友人
分享到 Line

分享到臉書