電鏡復制技術 的英文怎麼說

中文拼音 [diànjìngfùzhìjìshù]
電鏡復制技術 英文
replication technique for electron microscopy
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 鏡 : Ⅰ名詞1 （鏡子） looking glass; mirror 2 （幫助視力或做光學實驗的器具） lens; glass 3 （姓氏） a s...
  • 復 : Ⅰ形容詞1 （重復） repeated; double; duplicate 2 （繁復） complex; compound Ⅱ動詞1 （轉過去或轉過...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 技 : 名詞（技能; 本領） skill; ability; trick; technique
  • 術 : 術名詞1. （技藝; 技術; 學術） art; skill; technique 2. （方法; 策略） method; tactics 3. （姓氏） a surname
  1. Therefore, in this paper, two directional solidification methods, czochralski method and electron - beam floating zone melting method, were used to obtain such material. the directional solidifition microstructures of si - tasi2 system was performed using neophot - 1, amray - 100b sem and jem - 2000cx tem analysis technique

    本文採用切克拉斯基法（ cz法）和電子束區熔法（ ebfzm ）兩種定向凝固方法制備該共晶自生復合材料；藉助金相技術、電鏡技術、圖象處理技術等多種分析測試手段，考察了si - tasi _ 2共晶定向凝固組織和及其相應的工藝規范。
  2. The composition, structure, and properties of the as prepared composite films have been characterized in detail by uv - vis, ftir, and x - ray photoelectron spectra, ellipsometry, scanning electron microscopy, atomic force microscopy, transmission electron microscopy, fluorescence spectroscopy, and standard four - probe technique

    採用uv - vis光譜、 ftir光譜、 x -射線光電子能譜、橢圓光度法、掃描電子顯微鏡、原子力顯微鏡、透射電子顯微鏡、熒光光譜和標準四探針技術對所制備的納米復合膜進行了組成、結構和性能表徵。
  3. Light microtechnique and sa - galactosidase method was used to study the effects of super - high - concentration of glucose on the senescence of human diploid fibroblast 2bs cells, ros and the membrane potential of mitochondria during this process were measured. our results showed that 200 mmol l of glucose inhibited the growth of 2bs cells, led to the changes of reactive oxygen species and decrease of mitochondrial membrane potential, and caused senescence of 2bs cells rapidly. it supports the hypothesis of oxidative damage of senescence. moreover it is a better system for the study of the effects of ros during the process of replicative senescence

    利用光學顯微鏡觀察和酸性-半乳糖苷酶染色技術研究了高濃度葡萄糖對人二倍體成纖維細胞2bs細胞衰老進程的影響，並用流式細胞儀檢測了此過程中活性氧和線粒體膜電位差的變化。結果表明： 200 mmol l的葡萄糖對2bs細胞有生長抑制作用，能引起活性氧含量的變化，導致線粒體膜電位差顯著下降，並誘導了細胞的衰老。這為氧化損傷假說提供了新的證據，並為研究活性氧和復制衰老之間的關系提供了較好的體系。
  4. In this work, using elemental powders as starting reactant materials several carbide powders such as wc, sic, tic, zrc and corresponding alloys had been fabricated by ball - milling technique. x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), transmission electron microscopy ( tem ) and other measurement techniques had been used to monitor the structural changes of powders after some ball milling time and the properties of the cemented tungsten carbides. and the mechanism for the formation of matal carbides by ma has also been discussed

    本文主要對機械合金化（ ma ）技術在碳化物制備中的應用進行了研究，利用高能球磨，以元素粉末為原料，制備出wc 、 sic 、 tic 、 zrc的粉體以及wc基硬質復合材料，並利用x射線衍射、掃描電鏡、透射電鏡等方法分析和研究了球磨過程粉體的變化以及燒結后硬質合金的性能，對機械合金化制備碳化物的有關機理進行了研究和探索。
  5. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    該系統可通過沉積參數的精確控制，以控制沉積過程，減少金剛石膜生長過程中的缺陷，並採用光纖光譜儀檢測分析等離子體的可見光光譜以監測微波等離體化學氣相沉積過程；利用微波對材料的選擇加熱特性，通過構造等效方程，並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中，建立了非均勻等離子體溫度場綜合模型、復合介質基片材料的復合溫度場模型及復合介質材料溫度場攝動模型，為mpcvd的基片加熱系統設計提供了一條全新的技術路線以指導基片加熱材料的制備，並對基片加熱材料進行了設計和優選，以獲取大面積均勻的溫度場區，甚至獲得大於基片臺尺寸的均勻溫度區；作為研究重點之一，開展了微波等離體化學氣相沉積金剛石的成核與生長研究，系統地研究了在（ 100 ）單晶硅基片上mpcvd沉積金剛石膜的實驗過程中，基片預處理、甲烷濃度、沉積氣壓、基體溫度等不同實驗工藝參數對金剛石薄膜質量的影響，分別用raman光譜、 x射線衍射（ xrd ） 、掃描電鏡（ sem ） 、紅外透射光譜（ ir ） 、原子力顯微鏡（ afm ）對薄膜進行了表徵，確立了該系統上mpcvd金剛石膜的最佳的實驗工藝參數。
  6. About image capturing, based on other researchers " study, an optical - electronic imaging equipment, ring aperture microscope ( ram ), is designed, including its fabrication method and corresponding image restoration technique

    在圖像輸入設備和技術的研究方面，在借鑒前人研究成果的基礎上，本文研究了環形編碼顯微鏡? ?一種新的光電成像裝置的制備方法和相應的圖像恢復技術。
  7. In the present dissertation, nanocomposite thin films and extended molecular devices were prepared via the electrostatic self - assembly monolayer technique. the structures and the properties of the thin films were studied by uv - vis spectroscopy, x - ray diffraction spectroscopy, x - ray photoelectron spectroscopy, laser raman spectroscopy, atomic force microscopy, fiber optic experimental setups and so on. a novel fiber optic humidity sensor based on the self - assembled polyelectrolyte multilayer thin films was presented, and other thin film devices were also described

    在對納米復合薄膜研究的重要性及自組裝薄膜技術的發展動態進行綜合分析的基礎上，開展了利用靜電吸附自組裝技術制備納米復合薄膜及廣義的分子器件的研究，採用紫外-可見光光譜儀、 x射線衍射儀、 x射線光電子能譜儀、激光拉曼光譜儀、原子力顯微鏡、光纖光學系統等研究了復合薄膜的結構與性能，研製了一種光纖濕度傳感器和其他薄膜器件。
  8. The tio2, cds and cds - tio2 films on the common glass substrate were prepared, respectively, using ti ( oc4h9 ) 4, cd ( cooch3 ) 2 and scn2h4 as raw materials by sol - gel method. the influences of manifold preparing parameters ( such as the concentration of sol, the amount of the peg. the number of coatings, the heat - treated temperature and time ) on the structure and performance were studied

    本文採用溶膠-凝膠技術，以鈦酸丁酯、乙酸鎘和硫脲為原料，以普通玻璃片為載體，制備了納米tio _ 2薄膜、 cds薄膜和cds - tio _ 2復合半導體薄膜，研究了制備過程中多種制備參數（如溶膠的濃度，聚乙二醇（ peg ）的加入量，鍍膜層數，熱處理溫度及時間）對薄膜結構和性能的影響，採用x -射線衍射（ xrd ） 、掃描電鏡（ sem ） 、能譜分析（ edxa ） 、紫外-可見吸收光譜（ uv - vis ）等測試手段對各薄膜進行了結構和物性表徵。
分享友人
分享到 Line

分享到臉書