露點腐蝕 的英文怎麼說

中文拼音 [lòudiǎnfǔshí]
露點腐蝕 英文
dew point corrosion
  • 露 : 露動詞[口語] （顯露; 表現） reveal; show
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 露點 : [氣象學] dew point; dew-point temperature
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  1. Because calculated dew point of gas is about from 85 to 110, so we should consider low temperature corrosion

    計算了陜北天然氣露點為85 ? 110 。因此將排煙溫度降低到60后，考慮了低溫腐蝕的問題。
  2. Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  3. The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  4. The heat pipe exchanger has the advantages of compact, controlling erode of acid dew point, high efficiency, low pressure drop loss and reliability, so they are used widely in heat energy utilization and waste heat recovery. it is also helpful to recover the waste heat, save the raw materials and reduce the production costs. economic benefit from application is obvious

    以熱管為傳熱元件的熱管換熱器具有下列特點：傳熱效率高，壓力損失小，工作可靠，結構緊湊，有利於控制露點腐蝕等，這些獨特的優點是它在解決能源問題，如：利用熱能、節約原料、降低成本等方面，特別是在工業余熱利用中發揮了越來越多重要的作用。
  5. It tell us : the abrasive capability of fly ash ; the similar calculation of ash erosion ; the calculation of ash erosion in the tube in turn and tube out of turn ; the reason of tube abrasion for gas flue ; the influence of air parameter for fly ash erosion ; the influence of changing temperature ; the influence of the flue gas composition, etc. next, it advances the solving measure ; reduce the flue gas velocity ; reduce the concentration of fly ash ; responsible construction : replace smooth tube with spiral tube ; use the new material of abrasion ; fuel desulfurization ; reduce so3 of flue gas ; raise flue gas temperature, making it up the dew point ; use the abrasion - resistance material to resist abrasion

    討論了飛灰磨損性能、管壁受飛灰沖蝕的近似計算、灰粒對順列管和錯列管的磨損計算、煙氣走廊引起對流管束的磨損機理、空氣動力參數對飛灰沖蝕的影響以及受熱面壁溫變化及煙氣成份對飛灰磨損的影響等問題。接著提出了解決的措施：降低平均煙氣流速；降低飛灰濃度；使用鰭片管、螺旋翅片管代替光管；選擇合適的結構及排列方式，減少煙氣中so3的含量；提高受熱面壁溫使之大於煙氣的露點溫度；採用抗腐蝕材料作受熱面等防腐蝕的措施。
  6. Acid dew point corrosion

    酸露點腐蝕
  7. The results are follows : chemical composition, tensile strength, yield strength and elongation accord with standard, part corrosion of outside is dew point corrosion, equable corrosion of inside is brought by deoxidized water

    結果表明：其化學成份、抗拉強度、屈服強度、延伸率均符合標準要求，管材外表面局部腐蝕是因露點腐蝕造成，管材內表面受除氧水的作用均勻腐蝕。
分享友人
分享到 Line

分享到臉書