靜壓力 的英文怎麼說

中文拼音 [jìng]
靜壓力 英文
at-rest pressure
  • : Ⅰ形容詞1. (安定不動; 平靜) still; calm; motionless 2. (沒有聲響; 清靜) silent; quiet Ⅱ名詞(姓氏) a surname
  • : 壓構詞成分。
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  1. Artesian hydrostatic pressure

    自流水靜壓力
  2. We possess accurate processing equipments, such as hydrogen making equipment, reducing furnace, isocratic press machine, 500t capacity hydraulic machine, intermediate frequency induction furnace, high or low temperature fritting durance and forging equipment, which forms whole production line

    公司擁有制氫裝置、系列制粉還原爐、等靜壓力機、 500噸油機、中頻感應爐、高低溫燒結爐、鍛造設備及精密加工設備。
  3. The velocities are independent of hydrostatic pressures.

    速度與流體靜壓力無關。
  4. Spherulites dimension also decreases due to the chemical changes occurred during pan - milling. viscosity test shows that chain scission occurred during pan - milling, which caused slight reduction of mechanical properties. polypropylene / polyamide 6 ( pp / pa6 ) ultra - fine powder was prepared through pan - milling at ambient temperature

    通過磨盤碾磨在常溫下制備了聚丙烯/尼龍6 ( pp / pa6 )超細復合粉體,其粒徑可通過碾磨時間、磨盤轉速、磨面靜壓力、碾磨溫度等工藝參數控s摘要一制。
  5. The formation of crannies of the vermiculate reticulate clay results from the stratigraphical pressure and the seasonal fluctuating of the groundwater level. the formation of holes of the rhizomatic reticulate clay results from the decomposition of the botanic roots

    蠕蟲狀網紋孔隙空間的產生是由於地層靜壓力和地下水位季節性變化造成的,而根狀網紋的孔隙空間則是植物根系腐爛分解后提供的。
  6. It has a long history using a throttle device to measure the flow volume of fluid in pipe the method has formed normalization at home and abroad the principle is to make the flow bunch form the particial shrink at the place where the throttle part is located so as to produce a static pressure difference then measure and calculate the flow volume at the moment when the fluid is flowing through the throttle device by the static pressure measured this method is based on the law of conservation of energy and the equation of flow continuity

    用節流裝置測量管道中流體流量已歷史悠久,在國內、國際上都已標準化,其原理是使流束在節流件處形成局部收縮,產生靜壓力差,通過測量靜壓力差來衡量流體流過節流裝置時的流量大小,這種測量方法是以能量守恆定律和流動連續性方程為基礎的。
  7. Static pressure regulator

    靜壓力調整器
  8. Textiles. determination of resistance to water penetration. hydrostatic pressure test

    紡織品.耐滲水性的測定.液靜壓力試驗
  9. Test method for hydrostatic compressive strength of glass - reinforced plastic cylinders

    玻璃增強塑料圓筒液體靜壓力強度的試驗方法
  10. Reading methods of the vacuum gauges by means of the head difference in the hydrostatic pressure

    通過液體靜壓力頭差讀取真空計的方法
  11. Explosives for civil uses - high explosives - determination of resistance to hydrostatic pressure

    民用爆炸物.烈性炸藥.測定抗液體靜壓力
  12. Explosives for civil uses - high explosives - part 6 : determination of resistance to hydrostatic pressure

    民用炸藥.高爆炸藥.第6部分:耐液體靜壓力的測定
  13. Standard practice for resistance to hydrostatic pressure for coatings used in below grade applications applied to masonry

    磚石工程用地下設施塗層的抗流體靜壓力的標準規程
  14. Explosives for civil uses - detonators and relays - part 12 : determination of resistance to hydrostatic pressure

    民用爆炸物.雷管和傳爆管.第12部分:雷管抗流體靜壓力的測定
  15. Erosion damage decreases rock load area, after defining damage variable, the damage stress in rock can be calculated by the method bring forward by lemaitre conveniently. for surrounding rock of a deep buried tunnel under the condition of drained, its seepage character is not only controlled by the high stress in rock, but also influenced by the development of erosion damage. in the whole course of rock " s deformation and failure, its seepage character decreases with the increment of stress in elastic stage, while " increases with the development of failure

    巖樣中全應?應變三軸滲透試驗過程中的典型表現為隨著應的增加,巖體內的空隙和裂紋受載閉合,滲透性降低,應達到一定閾西南交通大學鷹士研究生學位論文第11頁值后,巖體內部裂紋發生擴展和歸並,滲透性增強;同樣,地下水的動、靜壓力作用對裂紋的擴展和歸並也起著促進作用。
  16. Explosives for civil uses - high explosives - part 6 : determination of resistance to hydrostatic pressure ; german version en 13631 - 6 : 2002

    民用爆炸物.高級炸藥.第6部分:抗流體靜壓力的測定
  17. Explosives for civil uses - detonators and relays - part 12 : determination of resistance to hydrostatic pressure ; german version en 13763 - 12 : 2003

    民用爆炸物.雷管和傳爆管.第12部分:雷管抗流體靜壓力
  18. Thermoplastics piping systems - non - end - load - bearing elastomeric sealing ring type joints between pressure pipes and moulded fittings - test method for leaktightness under internal hydrostatic pressure without end thrust

    熱塑管道系統.管和模塑管件的無端負荷彈性密封環型連接件.在無軸向推時內部流體靜壓力下密封性的試驗方法
  19. For the first current plateau , two kinds of sequential resonant tunneling of - process and - x process are observed in the wide barrier gaas / alas superlattice under various pressures for p < 2kbar , the high field domain is formed by - process , while for p > 2kbar , the high field domain is formed by - x process when the barrier width was decreased to 2nm, we found that ground - state -

    對于寬壘( > 3 . 5nm )的gaaa / alas超晶格,當流體靜壓力超過臨界2kbar后,平臺寬度隨的升高而收縮。對于窄壘( 2nm ) gaaa / alas超晶格, u - i曲線上的平臺將不隨變窄。
  20. Thirdly, the structure of ejecting in the base region with unmatched pressure ( sebup ) is introduced. the sebup can produce a high average pressure in the laser chamber, while the low pressure which is needed by the active medium is set up locally too. the steady flowfields and the unsteady flowfields in start - up course of sebup are also simulated with cfd method, and the experiment of sebup is made. the

    在本文最後,根據以上研究的結果,提出了「基區非匹配引射結構」 。這一結構的特點是,它能夠在提高光學諧振腔的平均靜壓力的同時,建立出有利於出光的局部低區。本文用cfd技術對它的穩態和啟動的瞬態流場進行了模擬,並實施了實驗。
分享友人