靜態功能試驗 的英文怎麼說
中文拼音 [jìngtàigōngnéngshìyàn]
靜態功能試驗
英文
static functional test- 靜 : Ⅰ形容詞1. (安定不動; 平靜) still; calm; motionless 2. (沒有聲響; 清靜) silent; quiet Ⅱ名詞(姓氏) a surname
- 態 : 名詞1. (形狀; 狀態) form; condition; appearance 2. [物理學] (物質結構的狀態或階段) state 3. [語言學] (一種語法范疇) voice
- 功 : 名詞1 (功勞) exploit; merit; meritorious service [deed]: 戰功 military exploits; 立功 render me...
- 能 : 能名詞(姓氏) a surname
- 試 : 名詞(古代占卜用的器具) astrolabe
- 驗 : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
- 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
- 試驗 : trial; experiment; test
-
Quality evaluation and audit for vehicle samples : the items include paint appearance, sheet metal, interior / exterior trim, static squeak & rattle / function, engine compartment / underbody, drive test, water test and so on
整車抽樣質量評審:項目包括外觀、板金、內外飾、靜態異響/功能、駕駛測試、發動機艙/底盤、淋雨試驗、法規標準符合性等。The author is absorbed in research on technology of coprocessor design. in the floating - point addition the paper proposes a carry chain of dynamic and static mixed circuits and a good balance between speed and area of predicting leading - zero logic circuits, considering algorithm and construction of logic circuits. an approach of micro program controller design for coprocessor is put forward and a test bench is given to verify its function
筆者研究協處理器的設計技術,在浮點加法器中提出動態與靜態結合設計進位鏈的方案以及前導零預測面積與速度的折衷方法;在微程序控制器的設計中提出一種協處理器微程序控制器的設計方法,並且給出其功能驗證的測試平臺。By using inorganic polymer coagulant and automatic dosing method, very good treatment results were obtained. in addition, experiments were conducted on the pre - treatment of source water using kmno4, and very good results were gained. this thesis also did relevant research on the effects of enhanced pre - treatment for organic removal
還進行了試驗室靜態試驗,考察了高錳酸鉀復合藥劑用於化學預氧化的處理效果,試驗結果表明,高錳酸鉀復合藥劑具有優越的強化混凝作用,有助於去除濁度、色度功能,並能降低混凝劑用量。Abstract : the present paper deals with the design principle of the iron - nitride magnetic static sealing device, analyzes the bearingpressure ability and experiment, and states the success of the magnetic fluid safety valve for sealing and the testing results of thefunctional parameters
文摘:敘述了氮化鐵磁性流體靜態密封裝置的設計原理、磁性流體靜態密封承壓能力分析和實驗驗證,成功地研製出"氮化鐵磁性流體密封安全閥" ,並取得磁性流體密封安全閥各種功能參數的測試結果Phase 2 - operational qualification, at - rest testing, or functional approval
第二階段,運行合格驗證,靜態測試或功能審核。分享友人