靜態放大器 的英文怎麼說

中文拼音 [jìngtàifàngdàqì]
靜態放大器 英文
static amplifier
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 放 : releaseset freelet go
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  • 放大器 : amplifier; pantograph; lawnmower; enlarger; magnifier
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  1. B ) the design of the new valve : for the displacement of the actuator, hydraulic magnify is used, and the stracture that has comparatively motion beteen harness and body and comparatively stillness between harness and body is adopted. the static characteristic of the new valve and also its dynamic characteristic, the factors that affect the valve ' s characteristic are analyzed

    設計新型高速開關閥：對驅動器位移採用了液壓式放大，並採用閥套與閥體之間有相對運動，閥芯相對閥體不動的結構。分析了新型高速開關閥靜動態特性以及影響其性能的主要因素。
  2. There is difference frequency measurement requirement for every part of pid regulating, difference between dynamic quality and static quality in response time and accuracy. according to these, it use the interrupt functions and high - speed counter of the simens s7 - 200 plc cpu226 basic unit and some peripheral circuit to measure frequency ; in software designed, the procedure frame of hydraulic - turbine governor and disperse process of parallel pid are analyzed, an improved pid algorithm is adopted to realize a pid regulation mode with variable structure and parameters ; the mechanical liquid - pressure system of the hydraulic - turbine governor is with electric - hydraulic converter unit of step motor. according to the drive character of five phase of response step motor, a variable frequency regulated voltage driver unit is designed in order to realize interface between plc and driver of step motor

    本文利用s7 - 200plc自身的特點設計了頻率測量單元，根據pid調節各個環節的特點，以及調速器動態特性、靜態特性對頻率測量的實時性和精度要求的不同，利用s7 - 200plc基本單元中內置的高速計數器以及相應的外圍放大整形、分頻電路，實現了水輪發電機組頻率的測量；在軟體上，對微機調速器的整個程序框架、並聯pid的離散化過程進行了分析，選用改進的pid演算法實現了變參數、變結構的pid調節模式；調速器的機械液壓隨動系統具有步進電機電液轉換元件，採用五相反應式步進電機，根據其驅動特性設計了變頻調壓驅動器，實現plc與步進電機驅動器之間數字介面。
  3. By means of resistance and capacitance coupled negative feedback method to control the plasma discharge development process and prevent the transition from glow discharge to spark discharge in a pin - to - plate static air plasma generator, a stable alternative current atmospheric glow discharge is produced successfully

    在靜態大氣壓空氣針板等離子體發生器中，採用阻容耦合負反饋方法控制等離子體放電發展過程，成功地抑制了輝光放電向火花放電的過渡，產生了穩定的交流輝光放電。
  4. After select the most suitable topology structure of circuit, we simulate the biasing circuit, input and output matching circuit

    在選定合適的拓撲結構后，對放大器的靜態偏置點、輸入輸出匹配電路進行模擬。
  5. The chip is accomplished in the full cooperation with other team members, the author pays particular attention to the analysis of the whole chip architecture and three sub - block design : transconductance amplifier ( ota ), voltage reference and current reference. based on existed technologies, a new high order temperature compensated voltage reference and a creative current reference with high order temperature compensation are shown respectively. the author simulated all the sub - block and whole chip by hspice

    該晶元的設計是由小組成員共同完成，本人主要負責了總體電路的分析、聯合模擬驗證及以下三個子電路的設計: 1 、跨導放大器，詳細分析了bandgap跨導放大器輸入級的動靜態特性及其優缺點，並結合系統要求，設計了一種與cmos工藝相兼容、可替代bandgap跨導放大器的低壓共源共柵跨導放大器。
  6. After designing the new - type high - voltage power amplifier, the static and dynamic responses of actuators made from piezoceramic material are studied experimentally, and introduced as actuating device used in active vibration isolation system

    在設計了新型的高壓功率放大器后，對壓電陶瓷作動器的靜態和動態性能進行了實驗研究，並將其作為執行機構引入主動隔振系統。
  7. The disease in jaw surface will be drop the bite force ; the bite force in the patient who disease in temporal jaw joint descent obviously than normal person ; serious mistake in join deformity, the acute damage in the area arthritis can also drop the bite force evidently ; compare to normal children, wenneberg fund that the bite force lower and the duration of the biggest bite force shorter in the children who fall ill of the chronic arthritis ; the bite force also be used in appraise of the recovery condition in surgical operation 、 disorder in jaw arthritis and the serious bone offset in bite lopsided etc. some materials, it will be produce polarization phenomenon inside when suffered some force in certain direction, at the same time, it produce opposite electric charge in two of the surface ; and resume to the station of on - electrification when removed the outside force ; change the direction of the outside force, the polarity of the electric charge also be changed, this kind of phenomenon is called as “ piezoelectric effect ”

    本文設計了石英晶體壓電傳感器，以它作為傳感元件把咬合力信號轉變成電信號;利用ts5860型準靜態電荷放大器把傳感器的電荷信號轉變成電壓信號;選用usb7822數據採集卡，編寫該數據採集卡的驅動程序，採集該電壓信號並送到計算機里;編寫labview程序對該信號進行處理，得出咬合力值和咬合力曲線，並把測量結果以電子表格的形式保存，以便做進一步的分析和研究。通過對該測量儀的靜態標定、動態標定、溫度漂移標定以及實際測量試驗，證實了本測量儀具有較高的靈敏度、受動態力和溫度變化的影響比較小、能實時地顯示咬合力曲線和較準確地顯示咬合力值，滿足了咬合力測量的要求。
  8. In the fifth chapter, a new fully differential operational amplifier with voltage and current - mode negative feedback has been proposed, which can stabilize its quiescent operation point, using the characteristic of mos transistors which operate in the triode region acting as active variable resistor, a fully differential fourth - order chebyshev low - pass filter with tunable frequency and bessel low - pass filter with accurate group delay based on r - mosfet - c and operational amplifier has been designed

    第五章：提出了一種新的既具有電壓共模負反饋又同時具有電流共模負反饋的全差分運算放大器電路，能較好地穩定電路的靜態工作點，並應用mos管工作在線性區可作有源可變電阻用的特性設計得到了截止頻率可連續調節的高性能r - mosfet - c 、運放結構切比雪夫（ chebyshev ）和精確群時延值貝塞爾（ bessel ）低通濾波器。
  9. In order to satisfy definition of dynamic picture in endoscope system and detail expressive force of static image smoothness and amplification, we introduce 3d dynamic optimized technique for this kind of display

    為了滿足內窺鏡系統其動態畫面的清晰度以及靜態圖像平滑放大的細節表現力，我們針對內窺鏡系統獨特的顯示要求為該類顯示器導入了3d動態優化技術。
  10. Usually the low power operational amplifier is designed with rail to rail output stage, whose signal dynamirange is small, its output driving force is not strong, here it is designed with voltage displacement stage, and the strong driving force and the low power consumption in this circuit are achieved. with 5v single power, this amplifier consumes only several a, 100khz unity - gain frequency, achieves 80db dc open gain and 55 phase margin for a 100pf load capacitance and a 1m load resistance and other advantages

    通常設計的低功耗軌對軌輸出運算放大器中，由於信號的動態范圍比較小，它的輸出驅動能力不強，這里設計的是採用電平位移電路同時實現了電路的強驅動能力與低功耗，它具有在單電源電壓5v的條件下，靜態工作電流只有幾微安，單位增益帶寬達100k ，開環增益能達80db以上，相位裕度也能達55度，輸出源沉電流達500微安以上等優點。
  11. The structure and character of deformable mirror were analyzed, and the conflict between the deformation band and the pitch of deformable cells was pointed out. the " two - time compensation " wave - front correct mode was introduced to settle that conflict. the method for allocating wave - front aberration and designing static corrector was found, and the " two - time compensation " wave - front correct mode was validated by simulation

    分析了變形鏡的結構特點，初步給出了變形鏡本身驅動單元數與校正量之間的制約關系；引入「二次補償」波前校正方案，解決了變形鏡校正量有限與高功率固體激光系統波前誤差起伏量大的矛盾，建立了波前校正對象優化分配、靜態校正器優化設計等細節過程所需要的方法，通過模擬模擬驗證了「二次補償」波前校正方案對于降低變形鏡校正量要求和放寬光學元件加工精度的作用； 5
  12. Expect for the design of the amplifier, the emphases is to test the static state and dynamic characteristic of the control system and provide a great deal reference data so that the system can work well

    論文中除了對放大器的電路做了介紹外，重點是對放大器在比例控制系統的運行中做了大量的靜態、動態參數測試，為比例電磁閥的良好工作提供了一系列的參考數據。
分享友人
分享到 Line

分享到臉書