靜態模擬 的英文怎麼說

中文拼音 [jìngtàimónǐ]
靜態模擬 英文
static simulation
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 擬 : 動詞1. （設計; 起草） draw up; draft 2. （打算; 想要） intend; plan 3. （模仿） imitate
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  1. The result of simulation is applied to develop the static model, and a 3d model of residual oil distribution in different period is obtained

    將模擬結果返回到靜態模型中進行循環建模，從而建立了不同時期的剩餘油定量分佈的三維模型。
  2. The subject of this thesis is to study ironless moving coil linear permanent magnet synchronous motor and the major works in this thesis are summarized as follows : 1 ) two analytical formulas are derived by concentrated current method and distributed current method to determine the magnetic field due to pm, based on the current model of pm. besides, two method ( magnetic charge method and solution by laplace equation method ) are also introduced with comparing their advantages and disadvantages. then the effects of the motor parameters on the flux distribution are discussed

    本文對空芯動圈式直線同步電動機進行了深入細致的研究，內容包括： （ 1 ）採用電流模型推導出兩種計算永磁磁極二維氣隙磁場的解析公式（集中電流法、分佈電流法） ，同時介紹了兩種永磁電機氣隙磁場計算方法（磁荷法，直接求解拉氏方程法） ，分析各種方法的優缺點，討論電機參數對氣隙磁密的影響； （ 2 ）介紹了單層同心繞組的布置方式，根據安培定律推導出空芯動圈式直線永磁同步電動機的靜推力計算公式，分析靜態力?位移特性； （ 3 ）建立空芯動圈式直線永磁同步電動機動態模擬模型，模擬不同驅動方式下電動機起動、穩態運行時電磁力、速度、位移的變化情況。
  3. An approach of static simulation of altitude measurement using a kgw - xx radio altimeter installed in a target drone model is introduced, experimental data are presented, and testing results are analyzed in theory

    摘要介紹某型拖靶使用的kgw - xx型無線電高度表靜態模擬測高試驗方法，給出了試驗數據，並對試驗結果進行了理論分析。
  4. Experimental result indicates that the kgw - xx radio altimeter can provide steady height data at ultra - low altitude, so it can be used as an altitude sensor of a tow target system, and the height data shows a bigger ladder error that affects the precision of the tow target system

    靜態模擬測高試驗結果表明：該高度表可在超低空狀態下提供穩定的高度數據，可以作為某型拖靶系統的高度傳感器；該高度表提供的高度數據存在著較大的階梯誤差，將影響拖靶系統的恆高精度。
  5. Considering slpmu - 025a produced by japan shinko motor company ltd. as our study project, this thesis presents a study on two - phase hybrid lsm, the study objects and some conclusions presented in the thesis are : ( l ) the 3d model of slpmu - 025a is formed by software maxwell 3d. then, the 3d magnetic field of the motor is analyzed by fem ( fenite element method ) analysis. here, the analysis of the magnetic field is in focus on the region of tooth - layer

    本文以日本神鋼電機株式會社生產的slpmu - 025a為研究樣機，對二相混合式直線步進電動機進行了研究，內容包括： （ 1 ）用maxwell3d軟體建立了slpmu - 025a的三維模型，通過有限元分析計算了電機的三維磁場，重點分析了電機齒層區域的磁場； （ 2 ）應用maxwell3d的后處理計算得到了電機的靜推力? ?位移特性，並與實驗進行了比較； （ 3 ）利用matlab中的simulink建立了動態模擬模塊，模擬了電機的部分動態特性，並用實驗進行了驗證。
  6. At first, the recent development of the simulation to cargo system of chemical ship is introduced. the significant of the research, methods and the characteristics of system simulation are also discussed. the model of cargo liquid and ballasting pipeline network is then simulated by the methods of predecessors

    文章首先介紹了散裝化學品船液貨系統模擬發展的現狀，闡述了化學品船液貨系統模擬研究的意義，以及模擬的方法和特點；之後運用前人的管網有限元方法對母型船液貨、壓載管網進行模擬建模，在系統地考慮了多種因素的前提下，實現了化學品船液貨系統操作動態模擬和靜態模擬。
  7. Offers information about model trains. the site has sections about cleaning, smoking, buying and frequently asked questions

    -靜態模擬動態遙控模型，飛機坦克直升機汽車艦船模型。
  8. Compared with the static model in errors, dynamic degrees and response curves, dynamic model is better. when voltage is above 0. 6 pu, the karlsson - hill model is suitable. when below, with air conditioner stalled, a new subsection model is established

    先分析比較靜態模型和動態模型，通過辨識的誤差、動態程度d以及響應曲線分析，發現採用動態模型更為合適； u 0 . 6u _ n時採用karlsson - hill模型； u 0 . 6u _ n時空調停機，構造一分段的模型，結果表明該負荷模型可以很好的擬合空調的動態響應。
  9. It designed a microwave measuring system and built a static and simulative apparatus. furthermore, a large amount of experimental work was carried out and the feasibility of microwave measuring system was proved

    完成了微波收發裝置和系統的構成，搭建了靜態模擬的實驗裝置，開展了大量的實驗研究工作，驗證了微波測量系統的可行性。
  10. This paper offers a method that can avoid the incorrect or rough methods mostly accepted now, and this method considers the temperature change along pipeline, the difference of friction loss in turbulence zone and the throttle effect in cross - section of reduced pipe

    針對現有的靜態模擬演算法存在的錯誤和不足，提出了一種更為精確的模擬演算法，該演算法除考慮了管道沿線的溫度變化、處于不同的紊流區摩阻損失的大小不同之外，還考慮了變徑管道在變截面處存在節流效應等問題。
  11. This new method can simulate the process states of visual display unit in actual scene, and would help designers improve the design level from static state up to dynamic simulative state

    模擬視覺顯示器實際現場過程狀態，將有助於設計者在設計時，由靜態性設計提高到動態模擬性設計的水平。
  12. The system uses an electric - hydraulic proportional control to implement the self - walking function of cannon

    通過對閉式系統進行分析，提出泵控馬達系統的數學模型，並進行動態模擬，研究了靜壓驅動系統的動態特性。
  13. A batch least - squares maximum likelihood estimator is employed to calibrate the model coefficients of accelerometer and a polynomial post - fit method is used to establish temperature models of these coefficients. the temperature models of accelerometer bias and scale factor of accelerometer are established between - 20oc and 50 oc. after compensating the temperature error by using these models, the post - fit residuals of the accelerometer output have been improved to 10 ? 5 g, and the trend term of accelerometer changing with temperature basically vanished

    採用最小二乘極大似然估計和多項式擬合的方法，分析加速度計靜態模型系數隨加速度計殼體溫度變化的規律，建立了- 20oc 50oc之間加速度計零偏和標度因數誤差的溫度模型，應用該模型對加速度計溫度干擾進行補償，補償后，加速度計輸出的擬合均方根誤差一到二個數量級，並且基本上消除了加速度計輸出隨溫度變化的趨勢項，使得加速度計測量精度得到了明顯提高。
  14. The emphases is put on the operator staffing problem in semiconductor wafer fabrication and the decisions in two situations long - term and short - term using simulation method not traditional static model were brought forward

    摘要對半導體製造中員工人數的配置問題進行了研究，提出了操作工人數的長期決策和短期決策兩種情況，並用模擬模擬的方法對操作工數量需求進行動態研究，而非傳統的靜態模型。
  15. Power system static modeling and computer monitoring of the model system

    雙側電源電力系統的靜態模擬及其計算機監控
  16. The reason why ladder error exists in the height data, and an approach for reducing the ladder error are given

    通過分析靜態模擬測高試驗結果，指出了該高度表提供的高度數據存在較大階梯誤差的原因及解決途徑。
  17. Abstract : the basic principle of out - of - step protection is presented in this paper. the test method that is used in testing out - of - step protective equipment is proposed and proved by test

    文摘:介紹了失步保護的基本原理，提出了用於檢驗失步保護裝置的靜態模擬試驗方法，並通過試驗進行驗證，取得了滿意的試驗結果。
  18. The optics propagation characteristics of lcd for realizing static simulation of lcd are calculated and analyzed by 2x2 extended jones matrix methods. the factors impacting display quality of lcd are discussed and some improved processes control and designing methods are presented too

    詳細推導了在研究液晶材料及器件光學性質中廣泛應用的2 2jones延伸式矩陣法，計算了液晶顯示器件的光學傳播特性，為實現液晶顯示器件的靜態模擬提供了理論依據。
  19. Through static emulating calculation of the high - pressure heater, the influence of high - pressure heater leakage upon its operation paeameters, such as outlet temperature of the feed - water, pressure loss of the steam extraction pipeline, and temperature of the drain, has been analysed

    摘要通過對高壓加熱器的靜態模擬計算，分析了高壓加熱器?漏對其運行參數，如給水出口溫度、抽汽管道壓損、疏水溫度的影響。
  20. The impact of load characteristics and on load tap changer on static voltage stability is analyzed with the methods based on v - q and v - p curves, and the phenomenon of voltage stability voltage instability and voltage collapse are studied with steady - state simulation. finally the thesis presents the essential explanations of both voltage stability and the mechanism of voltage collapse. xu yonghua ( electrical engineering ) directed by prof

    通過電壓?功率曲線分析法定性分析了不同負荷特性和有載調壓變壓器對靜態電壓穩定性的影響，並通過靜態模擬法從物理現象上研究了電壓失穩和電壓崩潰現象，最後針對這些現象給出了關于電壓穩定、以及電壓崩潰的本質解釋。
分享友人
分享到 Line

分享到臉書