靜態特性曲線 的英文怎麼說

中文拼音 [jìngtàixìngxiàn]
靜態特性曲線 英文
static characteristic curve
  • : Ⅰ形容詞1. (安定不動; 平靜) still; calm; motionless 2. (沒有聲響; 清靜) silent; quiet Ⅱ名詞(姓氏) a surname
  • : 名詞1. (形狀; 狀態) form; condition; appearance 2. [物理學] (物質結構的狀態或階段) state 3. [語言學] (一種語法范疇) voice
  • : Ⅰ形容詞(特殊; 超出一般) particular; special; exceptional; unusual Ⅱ副詞1 (特別) especially; v...
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • : 曲名詞1 (一種韻文形式) qu a type of verse for singing which emerged in the southern song and ji...
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  • 特性 : characteristic(s); character; performance; features; properties; behaviour; response; character...
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  1. This paper deriving the theory work inflection point in the static stage characteristics curve of small measurement range linear dimension measurement. by the way of high pressure and back pressure pneumatic measure and designed the parameter of the mainly and measure spray head, which are the key component in the spray head - baffle pneumatic sensor. the different groups for the main - spray head and the measure spray head, will effect the dynamic and static stage characteristic parameter. the author have done contrast experiment and optimization design to test and verify the theory derivation whereby made the rang of show valve of pneumatic measure system measure range up to 40 u m, the sensitivity up to 100mv / u m, resolution up to 0. 05 p m, the uncertainly of measure is less than 0. o2 u m, satisfaction of requirement of groups the carboy hatch thickness size precise measure of soft shims

    對高壓背壓式氣動測量用於小量程尺寸測量的靜態特性曲線的理論工作拐點進行了推導,對氣動測量系統中的噴嘴-擋板型氣動傳感器中的關鍵部件? ?主噴嘴和測量噴嘴的參數進行了理論設計,對主噴嘴和測量噴嘴的不同組合,將影響測量系統、動指標的噴嘴參數進行了對比實驗和優化設計,並通過實驗驗證了理論推導,從而使氣動測量系統量程的示值范圍達到40 m ,靈敏度達到100mv m ,解析度達到0 . 05 m ,測量不確定度小於0 . 2 m ,滿足了壓縮機缸蓋軟體墊片厚度尺寸精密測量分組的要求。
  2. Measurements of the electrical properties of transmitting tubes - measuring methods of static characteristic curve for common grid circuit

    發射管電能測試方法共柵電路靜態特性曲線的測試方法
  3. Measurements of the electrical properties of transmitting tubes - measuring methods of static characteristic curve for common cathode circuit

    發射管電能測試方法共陰電路靜態特性曲線的測試方法
  4. Static characteristic corve

    靜態特性曲線
  5. Static power convertors ; semiconductor rectifier equipment with i characteristic for charging of batteries ; requirements

    電源轉換器.蓄電池充電用具有i的半導體
  6. It makes finite element analysis for no - load motor, full - load motor and armature magnetic field singly acting motor, and it gets distributing map of magnetic field and static characteristics curve as different rotor angle and different armature current in a permanent magnet circle for the motor, it analyzes and explains influences of armature magnetic field on the inductance characteristics of windings

    分別對電機空載、負載以及電樞磁場單獨作用3種情況下進行了有限元分析,得出在1個永磁磁鏈周期內不同轉子位置角和不同電樞電流作用下的磁場分布圖以及參數
  7. In sum, the main contents of the thesis include : 1. analyses of the impact of different load characteristics on static voltage stability with the v - p - and - v - q curves of power system loads

    歸納起來,本文的主要內容包括: 1 .應用電力系統負荷的電壓-功率,分析了不同負荷的負荷電壓穩定的影響。
  8. The deh system can easily changes the static curve, and makes the transfer from difference to non - difference control. that the pid controller coefficient of deh system can easily adjust according to the experiment make dynamic characteristic better, and can make a brief overopen for good first frequency modulation ability

    Deh系統的調節能與傳統的調速系統相比有了極大的改善。 deh系統可方便地改變調節,並實現無差和有差調節的轉換。
  9. In the traditional way, the servo valve static characteristics tests are done by the signal generator and the x - y recorder

    傳統的能試驗通過信號發生器產生測試信號, x - y記錄儀繪完成。
  10. This thesis carries out studies around the impact of load characteristics on voltage stability - the key problem of power system voltage stability analysis. the impact of load characteristics on static voltage stability is analyzed with the methods based on v - p - and - v - q curves, and the dynamic voltage stability of different loads in the context of both small disturbances and large disturbances is studied with the method of time domain simulation

    本文圍繞電力系統電壓穩定分析中的關鍵問題-負荷對電壓穩定的影響這一問題展開研究,採用v - p , v - q分析法分析了負荷電壓穩定的影響,並採用時域模擬法研究了大擾動和小擾動下負荷的動電壓穩定
  11. Static power convertors ; semiconductor rectifier equipment, shapes and letter symbols of characteristic curves

    功率轉換器.半導體整流設備.形狀和字母
  12. This paper focuses on the research of fuzzy control, especially rule self - adjusting fuzzy control method. by theoretic analysis and simulations, the influences of parameters and system performance characteristic of some kinds of rule on - line self - regulating fuzzy control methods are discussed, and a novel real - time self - adjusting fuzzy control method ( vsrsafc ) is proposed from the diagrammatic point of view. in vsrsafc, the slope of the rectifying curve of rule scaling factor a is altered by the fine - tuning and coarse tuning combined mechanism to adjust the fuzzy control rules according to error e and error change ec, which more coincides with characteristic of system response than the conventional self - adjusting method that adjusts rule scaling factor only according to the error e, and has better static and dynamic performances than the latter

    其中變斜率規則自調整模糊控制的效果較為明顯,它是基於插值的非規則自調整模糊控制的引申以及常規全論域規則自調整模糊控制的改進,該方法採用粗、細調結合機制,通過改變規則調整因子的修正斜率,使系統同時根據誤差e以及誤差變化ec在調整模糊控制規則,比傳統的僅基於系統誤差e的自調整方法更符合系統響應,可獲得更好的動控制能,別是對于系統參數發生改變、控制參數選取不當等不良狀況,控制器仍能較快自調整,具有較強的在自適應能力。
  13. In this paper, the pressure field and static characteristic of bearings are simulated by fluent. the pressure contours of restrictors and shaft are acquired as well as the load capacity and static stiffness curves versus eccentricity ratio

    本文首次應用它對軸承的壓力場和進行了模擬分析,得出了氣體流經小孔、多孔柱塞和全多孔質的壓力變化以及軸上壓力沿軸向和圓周方向上的變化趨勢,並給出了軸承的承載能力和剛度
  14. This essay has touched upon the following work : 1. has built up theoretic models including static mathematic models of air compressor, combustion chamber, gas turbine, waste heat recovery boiler and steam turbine which are deduced according to the feature and theory of the equipment of the object of study. upon establishment of each model based on the actual conditions, a method of multiple imitation and combination is applied to parts which have already got characteristic curves to have achieved quite accurate curves whilst the method of neural net is applied to the parts which have no characteristic curves for establishment of models

    本文進行了以下的主要工作:建立理論模型,根據對象的實際設備的點和理論關系推導壓氣機、燃燒室、燃氣輪機、余熱鍋爐、汽輪機的數學模型;根據本研究的實際情況,在建立各部件模型時,對已有的部件,採用多項式擬合的方法,得到較為準確的,而對部分沒有,則採用神經網路的方法建立模型。
  15. In chapter 2, the actuator ' s design is addressed particularly, which concerns three main aspects : 1. the mechanical structure analysis and design ; 2. the electrical structure design ; 3. the driving method and control. chapter 2 also discusses the problems mentioned above deeply and systematically. specifically, in the mechanical structure, a new type of structure for heat compensation are presented and validated by relevant experiments

    浙江大學碩士學位論文第三章是對gma的定理論分析,論述了超磁致伸縮電一機械轉換器的各利『模型,包括、動及機械模型、電磁模型等等,還就有限元法、有限差分法等數值計算方法在gma研究中的應用作了理論探討,得出了一些相關的磁場分佈
  16. For the pin diode, its major transient behaviors are forward voltage recovery and reverse current recovery. this dissertation describes these performances by lumped - charge approach, and then developed an improved lumped - charge model for pin diode and a corresponding parameter extraction approach, which can reduce parameter measurement and enhance parameter accuracy

    Pin二極體中主要的瞬現象是正向電壓恢復和反向電流恢復,本文採用集總電荷的方法描述了它的動、,提出了改進的集總電荷的pin二極體高頻模型,同時提出了改進的擬合模型參數抽取方法,減少了所需的參數測量實驗並提高了參數抽取的精度。
  17. The impact of load characteristics and on load tap changer on static voltage stability is analyzed with the methods based on v - q and v - p curves, and the phenomenon of voltage stability voltage instability and voltage collapse are studied with steady - state simulation. finally the thesis presents the essential explanations of both voltage stability and the mechanism of voltage collapse. xu yonghua ( electrical engineering ) directed by prof

    通過電壓?功率分析法定分析了不同負荷和有載調壓變壓器對電壓穩定的影響,並通過模擬法從物理現象上研究了電壓失穩和電壓崩潰現象,最後針對這些現象給出了關于電壓穩定、以及電壓崩潰的本質解釋。
分享友人