靜態網格模型 的英文怎麼說

中文拼音 [jìngtàiwǎnggémóxíng]
靜態網格模型 英文
static mesh models
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 網 : Ⅰ名詞1 （捕魚捉鳥的器具） net 2 （像網的東西） thing which looks like a net 3 （像網一樣的組織或...
  • 格 : 格象聲詞rattle; gurgle
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  • 網格 : cancellus
  • 模型 : 1 （仿製實物） model; pattern 2 （制砂型的工具） mould; pattern3 （模子） model set; mould patter...
  1. Theoretical research on the type and mainframe tripled frequency converter : on the basis of building finite element models, dividing grid, application of load in the software of ansys, the dynamic and static performances are calculated, the value of the deformation, the first natural frequency and corresponding mode of the frequency converter are obtained, finally, the dynamic performances of the frequency converter are analyzed

    對型三倍頻組件和主機三倍頻組件的理論研究:採用通用ansys軟體對組件進行合理建模，劃分網格，施加載荷，在此基礎上對它們進行了靜態分析和動態分析，得到最大變形量、低階固有頻率和相應的振型，並對組件的動態性能進行了分析。
  2. Therefore, the paper establishes the parallel computing platform and meets the demand of computing resources for large eddy simulation. it also studies the integration of cad / cam, grid generation system and cfd system, and brings the model computed in the paper into this system. on the bases of systematical and thorough numerical simulation researches in circular cylinder and the compares between instantaneous piv metrical results and numerical results of circular cylinder, the paper obtained some problems and several conclusions which should be noticed in les for making correct computatioa finally, by using these experiences and conclusions above and by putting them into an actual problem in engineering - optimized numerical simulation of static mixer, this paper achieved the turbulent high - level numerical simulation technique, i. e., system atical attempt in engineering application by les method

    為此，搭建了微機并行計算平臺，解決了大渦模擬對計算資源要求；對cad cam 、網格生成與cfd系統集成進行研究，並將論文中所要計算的模型納入到此系統內；在對圓柱繞流問題進行了系統和深入的數值模擬研究和對圓柱繞流瞬態piv測量結果與數值計算結果進行比較工作基礎上，得到大渦模擬方法正確計算所需要注意問題和若干結論；最後利用以上得出的計算經驗和結論，通過對一個實際工程問題? ?靜態混合器優化的數值計算，完成了cfd中湍流高級數值模擬技術? ?大渦模擬方法工程應用的系統嘗試。
  3. The mesh data of these two models comes from static and modal finite element analysis respectively, and their load data possesses internal successivity. according to the correlation, finite element models support me parallel and cooperative processing of static, modal and dynamic response analysis

    其中的結構瞬態響應有限元分析模型分為兩個層次的模型，其網格數據分別來自於靜態和模態分析有限元模型，在載荷數據上具備內在繼承連續性。
分享友人
分享到 Line

分享到臉書