靜態試驗臺 的英文怎麼說

中文拼音 [jìngtàishìyàntái]
靜態試驗臺 英文
static test stand
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 臺 : 臺名詞（指臺州） short for taizhou （in zhejiang province）
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  • 試驗 : trial; experiment; test
  1. Design and analysis on high speed static air bearing test - bed

    高速徑向氣體靜態軸承試驗臺的設計與分析
  2. This dissertation applies virtual instruments technique in the field of servo valve cat for the first time and makes a servo valve static and dynamic state characteristic test bedstand based on virtual instruments. relevant theories and methods are also studied

    本文首次將虛擬儀器技術應用在電液伺服閥cat領域，研製出一套基於虛擬儀器的電液伺服閥靜、動態特性測試綜合實驗臺，並對電液伺服閥靜、動態特性測試的有關理論及方法進行了研究和探索。
  3. In addition, resovling the base for fixing actuator in the part of setting and debugging of whole test bench ; indicating performance of the test bench reliability and the test data is accord with correlative standard and may be taken as the bases of trouble shooting and maintain for tractor hydraulic lift system through testing the hydraulic lifter ' s static performance of tractor newholland 110 - 90. postgraduate : shenggang luan major : mechanism design and theory tutor : prof. bolin mi

    試驗臺的安裝與調試主要是完成加載油缸的地基處理，而在試驗部分通過對紐荷蘭110 - 90型拖拉機液壓提升器的靜態性能的檢測，表明本試驗臺性能可靠，所得到的試驗數據滿足相關標準中規定的精度要求，可以作為拖拉機液壓懸掛系統故障診斷和預知維修的依據。
  4. Design of control system of static inclining test table

    靜態傾斜試驗臺控制系統設計
  5. In this paper, three kinds of static test operations are given such as the shovel descended with the front - end of the bulldozer lifted, the ridger descended with the rear - end of the bulldozer lifted, the shovel and the ridger descended with the whole body of the bulldozer lifted the static tests for the frame of ty220 bulldozer are proceeded. the result of finite element analysis is contrasted with that of experiment the mechanical model and the result of finite clement analvsis are verified by experiment and the theoretical bases are provided for the improving design of frames 4 according to the results of calculations and tests, the suggestion is presented for improving the design of the frame of ty220 bulldozer

    給出了鏟刀下移推土機前端抬起，鬆土器下移推土機所端抬起，鏟刀、鬆土器同時下移推土機整機抬起等三種靜態試驗工況，對推土機臺車架進行了靜態試驗，並將實驗結果與有限元計算結果進行了比較，驗證了力學模型及有限元分析結果的正確性，為臺車架的設計提供了一定的理論依據。
  6. The development of the dynamic test - bed for fluid flow machine, one of the sub - projects within the " national 211 project ", can carry out the tests on the static and dynamic properties of not only both the hydraulic turbine units and water pump flits with the types of axial - flow, mixed - flow and inclined - flow, but also the centrifugal pump unit ; of which the testing process is automatically controlled by a pc with higher testing precision

    摘要流體機械動態試驗臺是國家「 211工程」建設項目之一，可以進行軸流式（貫流式） 、混流式、斜流式水輪機組的靜特性、動特性試驗，也可以進行軸流式（貫流式） 、混流式、斜流式、離心式水泵機組的靜特性、動特性試驗，試驗過程由微型計算機自動控制，試驗精度高，操作方便、靈活。
  7. The author is absorbed in research on technology of coprocessor design. in the floating - point addition the paper proposes a carry chain of dynamic and static mixed circuits and a good balance between speed and area of predicting leading - zero logic circuits, considering algorithm and construction of logic circuits. an approach of micro program controller design for coprocessor is put forward and a test bench is given to verify its function

    筆者研究協處理器的設計技術，在浮點加法器中提出動態與靜態結合設計進位鏈的方案以及前導零預測面積與速度的折衷方法；在微程序控制器的設計中提出一種協處理器微程序控制器的設計方法，並且給出其功能驗證的測試平臺。
  8. Therefore, the paper establishes the parallel computing platform and meets the demand of computing resources for large eddy simulation. it also studies the integration of cad / cam, grid generation system and cfd system, and brings the model computed in the paper into this system. on the bases of systematical and thorough numerical simulation researches in circular cylinder and the compares between instantaneous piv metrical results and numerical results of circular cylinder, the paper obtained some problems and several conclusions which should be noticed in les for making correct computatioa finally, by using these experiences and conclusions above and by putting them into an actual problem in engineering - optimized numerical simulation of static mixer, this paper achieved the turbulent high - level numerical simulation technique, i. e., system atical attempt in engineering application by les method

    為此，搭建了微機并行計算平臺，解決了大渦模擬對計算資源要求；對cad cam 、網格生成與cfd系統集成進行研究，並將論文中所要計算的模型納入到此系統內；在對圓柱繞流問題進行了系統和深入的數值模擬研究和對圓柱繞流瞬態piv測量結果與數值計算結果進行比較工作基礎上，得到大渦模擬方法正確計算所需要注意問題和若干結論；最後利用以上得出的計算經驗和結論，通過對一個實際工程問題? ?靜態混合器優化的數值計算，完成了cfd中湍流高級數值模擬技術? ?大渦模擬方法工程應用的系統嘗試。
  9. An experimental apparatus of falling film absorption in a vacillating is set up to check the reliability of theoretical model and to have a deep understanding of heat and transfer of practical falling film absorption ; falling film absorption with tfe / nmp solution in a static vertical tube and that in a vacillating tube are investigated respectively

    為驗證理論模型的可靠性並進一步深入了解實際搖擺降膜吸收過程中熱、質傳遞規律，自建了搖擺振動單管吸收試驗臺；分別對靜止和搖擺狀態下tfe / nmp垂直管內降膜吸收進行實驗研究。
  10. In this paper, based on the theory of radial - thrust floating ring hybrid bearing, the dynamic characteristic test for this kind of hybrid bearing is accomplished on the self - made test stand, the dynamic characteristics of the testing bearing are got, and the dynamic characteristic coefficients of the thrust part of the bearing are measured for the first time, the result of the test is compared with the theoretical calculation

    本文是在徑向?推力聯合浮環動靜壓軸承理論研究的基礎上，利用自製的實驗臺完成了對該軸承的動特性試驗研究，首次得到了測試軸承的動態特性，並將實驗結果和理論計算進行了對比。
  11. The paper investigates deeply the loading effect and a variety of dynamic testing technique, suggests the reasonable design - size of the flattened brazilian disc ( fbd ) based on the successful experience in static loading. connecting with strain - gage method, a quick loading test is applied on the fbd on the material testing machine. the experiment obtains the elastic modulus and tensile strength of marble, the results show marble ' s properties be effected by loading, contracting which in static loading

    在靜態實驗成功的基礎上，提出了平臺巴西圓盤試樣（ flattenedbraziliandisc ? fbd ）較為合理的設計尺寸，並結合應變片技術，利用材料伺服實驗機對大理巖平臺巴西圓盤試樣進行了快速加載實驗，測得了大理巖在快速加載（ 10 ~ 2mpa s ）下的抗拉強度和彈性模量，並與靜態結果做了比較。
  12. In order to carry out the acoustic and aerodynamics performances tests, seven resonators are designed and made, and a specialized engine intake silencer and exhaust silencers test bench was designed. the tests and analysis are performed as well. on the basis of the intake noise spectrum of sc7080a, a three - parallel - connected resonant silencer is designed, and that has efficiently controlled the acceleration noise of sc7080a

    在此基礎上設計並加工了兩類七個共振型進氣消聲器，研製了發動機進排氣消聲器性能測試實驗臺，開發了發動機進排氣消聲器聲學性能測試軟體，並在該實驗臺上測試了所設計的進氣消聲器靜態工況下的傳聲損失，從實驗的角度研究了共振腔的尺寸、形狀對其共振頻率的影響及其趨勢。
  13. The static and dynamic characteristic models of stage are built by ansys, which analyses the displacement, stress, natural frequency and vibration model of stage. furthermore, the influence of primary structural parameters on static and dynamic characteristic is analyzed by orthogonal experimental scheme comprehensively and the numerical results from experiment are regressed by stepwise regression method, thus the optimization regression equation is obtained. meanwhile, the neural network model is built and validates the regression model

    應用ansys軟體建立了工作臺靜、動態特性的分析模型，並分析了工作臺的位移、應力以及振動的固有頻率和振型，而且還應用正交試驗表安排參數全面分析了結構參數對微位移工作臺的靜、動態特性的影響，並用逐步回歸分析方法對數值計算結果進行回歸，獲得了微動工作臺的最優回歸方程，同時建立了人工神經網路模型並對回歸模型進行了驗證。
分享友人
分享到 Line

分享到臉書