靜態輸出電壓 的英文怎麼說

中文拼音 [jìngtàishūchūdiànyā]
靜態輸出電壓 英文
quiescent output voltage
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 壓 : 壓構詞成分。
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  • 電壓 : voltage; electric tension; electric voltage
  1. Experimental results certify that the proposed flyback inverter features small thd in the output sinusoid voltage, small size, light weight and fast dynamic response

    研製的100va原理樣機實驗結果表明，該逆變電路輸出正弦電壓失真度小，體積小，輸出動態及靜態性能良好。
  2. With the development of the electric power system, static - state reactive power compensators ca n ' t have met the requirements of the actual production and operation, and the trend to the fast and dynamic compensation for reactive power become greater and greater. since ertan hydroplant and 500kv transmission systems in sichuan power system have been operated, many power plants of load center are forced to halt during the high - water period, because the great deal of power is transmitted to far - distance load center. thus the load center loses voltage sustentation and the level of the system stabilization is debased greatly

    四川電網的二灘水電站和500kv輸變電系統投入運行后，由於二灘水電站的大量電力遠距離輸送至負荷中心，迫使負荷中心的火電機組在豐水期大量停機，使負荷中心失去電壓支撐，大大降低了電網的電壓穩定水平；同時，因為四川電網中的無功補償裝置全為靜態無功補償電容器（或電抗器） ，這些設備只能在系統正常運行狀態下起到無功補償和電壓支撐的作用，而在電網出現事故時，不但不能起到電壓支撐作用，反而會促使電網電壓崩潰事故的發生。
  3. The typical performance characteristics include : line and load transient response, efficiency, output voltage ripple, quiescent current, maximum load current, output voltage temperature characteristics and the short

    其中，整體模擬指標包括:晶元線性調整率和負載調整率、轉換效率、輸出電壓紋波、晶元靜態電流、最大負載電流、輸出電壓溫度特性及短路負載電流。
  4. While it works with supply voltages down to 1. 5v, the standby current is lower than 80n a together with the static power consumption lower than 240u w as well as the dynamic range of output voltages and currents is very wide

    模擬結果表明，電路工作於1 . 5v的低電壓時，靜態電流小於80 a ，靜態功耗不到240 w ，電壓輸出端和電流輸出端的輸出動態范圍大。
  5. The procedure of the test is as follows : first, the piezoelectric stack has been examined to test the performance parameters of the piezoelectric material ; second, the 2 - x actuator has been functioned with different static voltage to test its capability ; last, function the 2 - x actuator with voltage with different frequencies to test its dynamic properties. all the output of the actuator has been measured by the laser vibration measurement

    首先對壓電堆進行試驗，驗證壓電材料的性能參數;再對推挽式雙x驅動器施加不同的靜電壓驅動它，驗證作動器的驅動能力，最後對推挽式雙x驅動器輸入不同頻率的電壓驅動，測量該驅動機構的動態特性，試驗均採用激光測試儀測量推挽式雙x驅動器的輸出特性。
  6. The hardware circuit design include : industrial control computer configuration, selection of industrial control board type, design of the power supply and monitoring interface circuit, design of signal processing interface circuit ( the constant current source circuit, the time base signal processing circuit, the processing circuit for the signal to be measured ), design of panel control circuit, design of the system self - checking circuit, and etc. the program flow hart include : main program flow chart, system boot - strap self - checking program flow chart, manual static testing program flow chart, semiautomatic static testing program flow chart, automatic static testing program flow chart, dynamic testing program flow chart, transient testing program flow chart, source voltage and current monitor program flow chart, investigate function testing program flow chart, and etc. the measure system offers six working power supplies, the signal of time base, the signal of constant current source, sine wave signal and step to leap signal, and measures the frequency of the output pulse signal of the wide range pulse convert circuit accurately under three kinds of different test state ( static form, dynamic form and transient form )

    硬體電路設計包括：工控機配置、工控板卡選型、產品電源及監控介面電路設計、信號處理介面電路（恆流源電路、時基信號處理電路、被測信號處理電路）設計、面板控制電路設計、系統自檢電路設計等。程序流程圖包括：主程序流程圖、系統開機自檢程序流程圖、手動靜態測試程序流程圖、半自動靜態測試程序流程圖、自動靜態測試程序流程圖、動態測試程序流程圖、暫態測試程序流程圖、電源電壓和電流監控程序流程圖、研究功能測試程序流程圖等。測試系統提供六路工作電源、時基信號、恆流源信號、正弦波信號和階躍信號，並對三種不同測試狀態（靜態、動態、暫態）下大量程脈沖變換電路輸出脈沖信號的頻率進行精確測量。
  7. The test results demonstrate that this prototype has excellent comprehensive performances such as small bulk, lower weight, high efficiency, high steady precision, fast dynamic response, wide range input voltage, good output waveforms, strong over - load and short - circuit ability, and strong function with different nature load and three - phase unbalanced load

    試驗結果表明，該變流器具有體積重量小、變換效率高、靜態精度高、動態響應快、輸入電壓變化范圍寬、輸出波形質量高、過載與短路能力強、帶不同性質負載和帶三相不平衡負載的能力強等優良的綜合性能。
  8. In order to obtain three - phase four - line ac output, system applied the four - legged main circuit topology. with the 3d - svm, the power system realizes voltage regulation and three - phase four - line output. meanwhile, this kind of control is easy to be realized in the digital inverter

    為實現三相四線的交流輸出，變換器電路採取四橋臂新型拓撲，其控制採取了三維空間矢量調制，實現了變換器的在線調壓及輸出中點的形成，具有良好的動靜態性能，且這種控制思想可以方便地在現有數字變換器平臺上實現。
  9. But often what is not obvious when reading a manufacturer ' s data sheet is how the initial accuracy of the device is affected by other key device parameters such as line regulation, load regulation, initial voltage error, output voltage temperature coefficient ( tc ), output voltage noise, turn - on settling time, thermal hyste - resis, quiescent supply current, and long - term stability

    但，人們閱讀廠家的數據手冊時，因受諸如（電源電壓）線性調整率、負載調整率、初始電壓誤差、輸出電壓溫度系數tc 、熱遲滯（系數） 、靜態電流和長期穩定度等參數的影響而使初始精度往往不明顯。
  10. The calculation of ttc involves network limitations due to thermal and voltage stability limits. network limitations are to be calculation not only for the current operating but also for a worse case that could occur due to a set of contingency cases, which require huge amount of computation

    本文以連續潮流技術為基礎，提出了考慮各種約束條件的電力系統區域間最大輸電能力的分析與計算，考慮了電力系統運行中鞍型分叉點造成的靜態電壓穩定性約束條件等的計算。
  11. The outer - loop adopting the voltage effective value feedback regulates voltage output and reduces the steady error of output voltage. the inner - loop control is inductance current feedback, which implements the stabilization of system, and limits the inductor current

    外環採用電壓有效值反饋，調節輸出電壓，內環採用電感電流瞬時值反饋，提高系統動靜態特性，並對採用該方案的級聯逆變器進行了全面分析。
  12. The other is the design of amplifier with constant trans - conductance ( gm ) rail - to - rail input stage. when common mode input voltage changes, it provides nearly constant - gm independent of input transistor operating region ( strong, moderate or weak inversion ), and the quiet nods of the circuit for current addition and the output stage keep unchanged

    當輸入共模電壓變化時，不管它的輸入mos差分對管處于強反型區還是弱反型區，輸入級的跨度保持不變，而且輸入級後面的電流加法電路和輸出級的靜態工作點也不會隨之改變。
  13. Usually the low power operational amplifier is designed with rail to rail output stage, whose signal dynamirange is small, its output driving force is not strong, here it is designed with voltage displacement stage, and the strong driving force and the low power consumption in this circuit are achieved. with 5v single power, this amplifier consumes only several a, 100khz unity - gain frequency, achieves 80db dc open gain and 55 phase margin for a 100pf load capacitance and a 1m load resistance and other advantages

    通常設計的低功耗軌對軌輸出運算放大器中，由於信號的動態范圍比較小，它的輸出驅動能力不強，這里設計的是採用電平位移電路同時實現了電路的強驅動能力與低功耗，它具有在單電源電壓5v的條件下，靜態工作電流只有幾微安，單位增益帶寬達100k ，開環增益能達80db以上，相位裕度也能達55度，輸出源沉電流達500微安以上等優點。
  14. In this control scheme, the voltage error is processed by pi algorithms first, and then the current of the capacitor which equal to the differential of the voltage is imported to compose a two - loop control

    該方案先對輸出電壓誤差進行pi調節，在此基礎上引入相當于輸出電壓微分的電容電流反饋信號構成雙環控制，使逆變器輸出電壓具有良好的靜態特性和動態特性。
分享友人
分享到 Line

分享到臉書