靜電故障 的英文怎麼說

中文拼音 [jìngdiàngùzhàng]
靜電故障 英文
electrostatic accident
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 故 : Ⅰ名詞1 （事故） event; incident; happening; accident 2 （原因） cause; reason 3 （朋友; 友情） fr...
  • 障 : Ⅰ動詞（阻隔; 遮擋） block; hinder; obstruct Ⅱ名詞（遮擋物） barrier; block; obstacle
  • 靜電 : [物理學] static electricity; franklinism; franklinic electricity
  • 故障 : hitch; breakdown; stoppage; fault; faulting; accident; blunder; bug; conk; failure; impairment; i...
  1. In order to verify the effectiveness of steep - front impulse voltage test in finding the internal faults of composite insulator, some insulators with faults, including conductive channel, semi - conductive channels, airy channel, partial little air bubble that occur separately at different place, are modeled. steep - front wave impulse voltage test is made for these faulty insulator and normal insulator

    為了檢驗陡波試驗對于發現合成絕緣子內部故障的有效性，分別模擬了絕緣子內部不同部位有導電性、半導電性通道，小氣泡，金屬雜質，長氣泡以及芯棒與護套間不粘連故障的絕緣子，並從三維靜電場計算和用不同陡度的陡波試驗兩個方面進行了驗證。
  2. Work 100, 000 hours without maintenance ; imported longevous 200w electrical machine, passed the 3c certification. save electricity and be mute

    引進超長壽命的200w電機， 10萬小時工作無故障，並通過3c品質認證，保證低耗能靜音運行，更符合綠色環保標準。
  3. Troubleshooting of special artifact caused by static electricity

    靜電造成特殊偽影的故障處理
  4. Electricity power system computer simulation the computing include the current computing, simple fault computing, complicated fault computing, quiescent stabilization the computing and development stabilization the computing etc. because the computing software of electricity power system are all the earlier words software, it is very difficulty for studying and isn " t easily for using and ca n ' t draw the graphics of the electricity power system ect

    對電力系統的運行狀態進行分析需要進行大量的計算，電力系統計算機模擬計算主要包括潮流計算、簡單故障計算、復雜故障計算、靜態穩定計算和動態穩定計算等計算。本文針對當前電力系統計算軟體大多都是早期的字元界面的軟體，學習難度大，不易使用，以及不具備電力系統圖形繪制等弊病，對microsoft公司的visualc + + 6 . 0及其所提供的microsoft基礎類庫（ mfc ）展開了理論與應用的研究工作。
  5. This paper is mainly about some researches in three areas : iddq detecting method, iddt detecting method and fault location algorithm

    本文著重在靜態電流檢測方法、動態電流檢測方法以及故障定位演算法三個方面進行了研究。
  6. But this method can ’ t detect some kinds of faults under some high performance ics. recently, a novel fault diagnosis technology including iddq and iddt has developed rapidly

    基於電流的故障診斷方法包括靜態電流診斷方法（ iddq ）和動態電流診斷方法（ iddt ） ，是近期發展起來的新方法。
  7. Random failures of generator, transformer, transmission line, protection system and topology of both power station and power network are constructed

    根據元件故障的概率分佈，建立靜態安全分析中發電機、變壓器、輸電線路、保護系統的隨機故障模型。
  8. Fault analysis and simulation of distribution network static reactive compensator

    配電網靜止無功補償器的故障分析及模擬
  9. Stochastic and uncertain performance of power systems is thoroughly studied with a probabilistic simulation method in this paper. based on modeling of element failure and dispatching measures, static, dynamic and integrated securities are analyzed, and hence operation states are quantitatively classified. in probabilistic static security assessment, sequential and non - sequential monte - carlo sampling techniques are applied considering time varying parameter and constraints

    本文採用概率模擬方法，深入研究了電力系統運行中的隨機和不確定特性，在對元件隨機故障和調度控制措施建模的基礎上，對系統的靜態安全、動態安全和綜合安全進行概率評估，建立了電力系統運行狀態的量化分析模型。
  10. Based on the summarization of previous work, this dissertation conducts systematical research work on static voltage stability, such as load modeling and contingency screening and ranking

    本文在總結前人研究工作的基礎上，對電力系統靜態電壓穩定做了較為深入的研究，主要包括對負荷模型的研究和故障篩選演算法的研究。
  11. The shahe pumped - storage power station with two 50mw reversible units has been in good conditions on general since it was put into operation, but there still were some defects, such as the failure of unit ' s contemporaneous device, the insufficient cooling water discharge and pressure, and the failure of static frequency converter and excitation overcurrent

    摘要沙河抽水蓄能電站兩臺50mw可逆式機組自投運以來，總體情況良好，但是也出現了一些缺陷，如機組同期裝置故障，機組冷卻水流量或壓力不足，靜止變頻器故障，勵磁過電流故障等。
  12. According to request that military put forward, the target car that subject research should have such characteristics as remote control, high precision, good safeguarding, needing no track, etc, so as to achieve purpose of course require correctly when training to carry on cannon static to static, static to move, move to static, move to move etc. target car transfer speed require low inertia, high accuracy, high dependability, stupid and getting excellent and kind systematically ; wireless communication system expect much dependability, better anti - interference ability ; computer control system demand and try one ' s best to adopt advanced technology, components and parts source of goods reliable, high dependability, structure to be simple, have serial communication, digital display, systematic trouble examine and function of showing etc. the job of this thesis is divided into three major parts : the proposition and confirming of the electric power pulls, specification requirement and selecting type of equipment of communication system, sureness of the computer control system scheme

    根據軍方提出的要求，本課題研製的遙控坦克靶車應具有遙控、精度高、維護性好、無軌道、自帶動力等特點，以達到訓練時進行火炮或導彈靜對靜、靜對動、動對靜、動對動設擊等課目的要求。靶車調速系統要求低慣性、高精度、高可靠性、魯棒性好；無線通訊系統要求高可靠性、抗干擾能力強；微機控制系統要求盡量採用先進技術、元器件貨源可靠、高可靠性、結構盡量簡單，具有串列通訊、數字顯示、系統故障自檢及顯示等功能。本文的工作分為三大部分：電力拖動方案的提出及確定、對通訊系統的技術要求及設備選型、微機控制系統方案的確定。
  13. With the application of real - time multi - tasks mechanism and modulization software structure, the controller can set and modify the parameters on - line, collect and process the real - time data of the four - battery charge / discharge devices, termly and digitally regulate the closed loop and monitor the real - time faults, so that the system can control different styles of charging and discharging operate mode such as in constant current style, constant voltage with limited current style and static style

    控制器軟體採用實時多任務機制和模塊化的設計思想，通過對蓄電池化成充放電過程中工藝參數的在線設定修改、實時數據的採集處理、定時的數字閉環調節和故障的監測，實現對蓄電池靜電、恆流、恆壓限流等多種充放電工作方式的控制。
  14. In fault location area, a novel algorithm for fault location using iddq and iddt is designed in this paper. this algorithm is realized by combination of iddq and iddt based on wavelet transform. after classification of the potential faults by pattern recognition, the actual faults can be accurately located effectively

    在故障定位演算法方面:本文設計了一種基於電流信息的電路故障定位演算法，該演算法將靜態電流診斷方法與基於小波分析的動態電流診斷方法相結合，並通過模式識別進行決策，可以實現cmos集成電路多故障的準確定位。
分享友人
分享到 Line

分享到臉書