非剛性轉子 的英文怎麼說

中文拼音 [fēigāngxìngzhuǎnzi]
非剛性轉子 英文
nonrigid rotator
  • : Ⅰ名詞1 (錯誤) mistake; wrong; errors 2 (指非洲) short for africa 3 (姓氏) a surname Ⅱ動詞1 ...
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • : 轉構詞成分。
  • : 子Ⅰ名詞1 (兒子) son 2 (人的通稱) person 3 (古代特指有學問的男人) ancient title of respect f...
  1. In this paper, the rotating machinery at high speed is studied. there are discussed about numerical calculating methods for non - linear dynamical system, the rotor system radial impact and rubbing dynamics behavior analysis having the nonlinear rigidity on the unsteady and non - linear oil film, the rotor system dynamics behavior analysis with bending - torsional - pendular coupling vibrations, application of wavelet, fractal and network in fault diagnosis. the main works in this paper are as follows : ( 1 )

    本文以高速旋機械為主要研究對象,系統、深入地研究了動力學系統的數值計算方法、具有度的系統在穩態油膜力作用下的徑向碰摩動力學行為、彎扭擺耦合振動的動力學分析、小波和分形理論及人工神經網路在故障診斷中的應用問題。
  2. The crystalline structure changes of pp induced by pan - milling were characterized by x - ray diffraction and raman spectroscopy. xrd analyses show that when pp was co - milled with uhmwpe, crystal transformation of pp occurred, its crystallinity and crystallite size decreased, whereas, only slight reduction of crystallinity and crystallite size were observed and no crystal transformation was found when pp was co - milled with wtr chips, and amorphization of pp was strongly enhanced by co - milling pp with iron

    採用x -射線衍射研究了聚丙烯碾磨粉碎過程微觀結構變化, uhmwpe存在下pp發生晶型變、結晶度降低和晶粒尺寸減小;彈材料wtr抑制pp塑變形,碾磨導致分堆積有序區域膨脹,晶面間距增大,結晶度下降;材料金屬鐵與pp產生強烈摩擦,加快晶粒細化,晶格破裂導致晶化。
  3. This is the second bifurcation of the rotor, leading to low frequency movement at about 1 / 6 rotary speed. ( 3 ) in the third part of the paper, we focus on how to establish a rotor model with multi. span and multi. disk including main linear and nonlinear stimulations on the rotors system. the rules for establishing this kind of rotors model are put forward at the beginning of this part

    ( 3 )提出了大系統的理論建模準則,考慮油膜力、聯軸節度及標高等因素的影響,建立了一個16dof兩跨四盤四支撐不平衡彈模型,並提出了大型汽輪發電機組全軸系的48dof理論模型,建立了考慮陀螺效應時的復數形式的動力學模型。
  4. Analysis of the nonlinear response of a cracked rotor considering the influence of coupling stiffness

    考慮耦合度時含裂紋響應
  5. The way to eliminate chaos phenomenon through adjusting system parameters is indicated. the nonlinear dynamic behavior of journal bearing - rotor system in large parameter space is studied in numerical integral method and floquet theory and the first and second bifurcation behavior of nonlinear rotor system are discussed ; the concept is advanced that realizing the controllable nonlinear stiffness with sfd with the soft - nonlinear of sma in the super - elasticity state to make the vibration amplitude of system always be in the small solution state to reduce the vibration amplitude of rotor system

    運用數值積分方法結合floquet理論對滑動軸承-系統的大參數范圍動力學特進行了全面的研究,詳細地討論了系統的一次和二次分岔行為; 5 )提出了用形狀記憶合金在超彈狀態下的軟,結合擠壓油膜阻尼器實現系統可控,降低系統在定常狀態下的最大振幅的構想。
  6. It is constructed that radial impact and rubbing dynamics differential equations of the rotor system having the nonlinear rigidity on the unsteady and non - linear oil film. the bifurcation and chaos behavior of impact and rubbing fault rotor system caused by the parameters of nonlinear rigidity, rotor rotating speed, eccentric mass is analyzed, in the numerical value analysis method. the bifurcation diagrams, maximum lyapunov exponent diagrams, poincar maps, phase plane portraits, trajectories of journal center, time - history curve, amplitude spectra diagrams of the rotor motion are used

    ( 2 )建立了具有度的系統在穩態油膜力作用下的徑向碰摩動力學微分方程,並應用含高階余項的動力方程的線化數值法研究了此類系統響應的復雜動力學行為,利用響應的分岔圖、最大lyapunov指數曲線、 poincar截面映射、時域波形、相軌線、軸心軌跡、幅值譜等圖形分析了系統響應的周期運動、擬周期運動、倍周期分岔、混沌等運動形式的化與演變過程,重點研究了度、速、偏心質量等系統參數對碰摩故障系統的分岔和混沌行為的影響。
分享友人