非固定頻率 的英文怎麼說

中文拼音 [fēidìngbīn]
非固定頻率 英文
non-stationary frequency
  • : Ⅰ名詞1 (錯誤) mistake; wrong; errors 2 (指非洲) short for africa 3 (姓氏) a surname Ⅱ動詞1 ...
  • : Ⅰ形容詞(結實; 牢固; 堅硬) firm; hard; solid Ⅱ副詞1 (堅決地; 堅定地) firmly; resolutely 2 [書...
  • : Ⅰ形容詞1 (平靜; 穩定) calm; stable 2 (已經確定的; 不改變的) fixed; settled; established Ⅱ動詞...
  • : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
  • : 率名詞(比值) rate; ratio; proportion
  • 頻率 : frequency; rate
  1. Due to the short distance among the planes which fly in a group, the conventional low resolution radar can not distinguish them in both distance and azimuth ? if we use the technology of isar to resolve the difference among doppler frequency of the targets and obtain a fine resolution cross - cross image, we may separate them, but a long time of coherent processing is needed <, for the formation targets, it can be approximately divided to rigid body and nonrigid body, so for the formation targets, that can be regarded as rigid which has a relative position and an identical movement, can be approximately considered as a large target, and be compensated by translational phase with the rule of minimum entropy, but for the most those cannot accord with the approximation of rigid, being the doppler - frequency of the aim is linear changed, by the relax method with short data, increases the resolving performance of multiple target to the aim in the frequency domain, since cross - range resolution is based on the accumulative time, so it is greatly improve the resolution to formation targets by the instant cross - range image which produced by radon - wigner transformation

    低分辨isan成像及干涉技術應用研究一因此直接無法分辨編隊目標的架數,我們借鑒isar的技術,通過較長時間的相干積累,在多普勒域上對目標進行分辨。而對于編隊目標,可分為近似剛性的多目標和剛性的多目標,所以對于可以近似為剛體的編隊目標相對位置,運動方式一致,可以近似看作一個大目標,採用最小墑準則對平動相位的進行補償,但是大多數並不滿足剛體近似的編隊目標,由於目標在相干積累時間的多普勒近似呈線性變化,通過對較短數據利用relax的時分析方法,提高了域上目標分辨的性能。由於橫向解析度取塊于橫向積累時間,所以利用radnwigner變換得到瞬時的一維橫向距離像大大提高了對編隊目標的分辨,對模擬和實測數據的大量分析結果表明此方法的有效性和可行。
  2. The widely applications of nonlinear instruments have produced many high order harmonics, they are flowing into the power network and greatly influence the quality of electric power. and the frequency is n ' t constant but changed around 50hz

    電網中線性設備的使用日益增多,所產生的高次諧波電流大量注入電力線路中,使得電網電壓、電流波形發生畸變,同時電網並不是不變的,而是在50hz附近波動。
  3. Connectors for electronic equipment - part 7 - 4 : detail specification for 8 - way, unshielded, free and fixed connectors, for data transmissions with frequencies up to 250 mhz

    電子設備連接器.第7 - 4部分:數據傳輸250mhz及以下的8路屏蔽活動和式連接器的詳細規范
  4. 3. a raytrace model of both co - axis and non - axis beam propagations for high - power solid - state laser systems has been set up and simulations on shots have been conducted to get the spot distribution at target point. according to the requirement of system design and theory of mathematic statistics, the dispersion circle and frequency distribution, which optimize the stability allocation of optical components, have been presented

    3 、建立了共軸與共軸相結合的光線追跡模型,通過對大型體激光裝置打靶的模擬模擬,獲取光束在靶點處的彈著點分佈,依據總體設計要求,運用數理統計原理,採用彌散圓和分佈方法對彈著點分佈進行分析,優化光學元件穩性分配指標。
  5. Telecommunications - fixed radio systems - characteristics and requirements for point - to - point equipment and antennas - part 3 : harmonized en covering essential requirements of article 3. 2 of r tte directive for equipment operating in frequency bands where no frequency co - ordination is applied v1. 1. 3

    電信.無線電系統.點對點設備和天線的特徵和要求.第3部分:在協調帶中運行的設備用包含r tte指令3 . 2條款基本要求的協調的en
  6. We apply fuzzy control theory to active control over engine body vibration, design fuzzy control system which combines intelligent control with feedback control. this control strategy mends the flaw of complexity, nonlinear and uncertainty when we use traditional control method. by measuring rotate speed and vibration speed of i. c

    在主動控制的基礎上,採用了模糊控制的演算法,設計了內燃機整機振動模糊控制器,改進了傳統控制方法在處理振動復雜性、線性和不確性等方面的缺陷,通過測量內燃機轉速和內燃機整機振動速度信號,動態地改變動力減振器的剛度,使減振器的跟隨內燃機整機振動激勵的變化,達到降低內燃機振動的目的。
  7. In chapter 3, the non - linear equation was linearized with the jacobi matrix, and then the linearized equation was transformed into fixed frame to analyze the stability problem with eigenvalue method ( on - ground or hovering ) or floquet theory ( forward flight ). meanwhile, the equation was perturbed by sweep frequency excitation from steady state to get transit decay of lag response which was then transformed into fixed frame with a numerical fourier coordination transformation ( fct ). the fixed frame response along with the body response was analyzed via an fft to determine modal frequencies

    然後,在穩態響應的基礎上利用雅各比矩陣對線性方程進行了線化,線化后的方程利用多槳葉坐標變換轉換到系下后,利用直接特徵值分析(地面、懸停)或floquet理論(前飛)對系統進行了穩性分析;同時,對系統進行了瞬態響應分析;在系統達到穩態的基礎上進行掃激勵,用fft變換求得系統,進而用移動矩形窗方法分析得到系統的阻尼。
  8. Its main contents is as follow : firstly, it makes the discrete model for the subsystems of the scraper conveyor and the whole system with the finite element method ; secondly, the modal analysis method is used to obtain the inhere frequency and mode of the viberation ; finally, computer simulation is applied to get the displacement, velocity, acceleration and tension of the anyplace on the scraper conveyor for the four special working condition

    其主要內容如下:用有限元方法建立了刮板輸送機子系統及整個系統的離散體動力學模型;應用模態分析法求解系統的和振型;對四種工況下的動態特性進行計算機模擬,得出整個刮板輸送機在任意點的位移、速度、加速度和動張力。
  9. General in each country s power supply voltage and power frequency are fixed such as chinese american 220v 50hz 120v 60hz, the very same applies to hang rotational speed electrical driven occasions

    一般在每個國家的電源電壓和電源都是的如中國220v 50hz美國120v 60hz ,所以同步電機常適用於恆轉速驅動的場合。
  10. The model analysis of the deployed beams were studied in both theory way and simulation way. the differences of the beams in different pressures were studied. investigations showed that the method of modeling for short and long rolled beams is doable ; the process of fold maybe lead so large displacement and stress that membrane is damaged at local areas, ration and material wrinkle generates,

    研究結果表明:本文提出的分別針對短、長捲曲折疊充氣管的建模方法是有效的;在充氣管展開過程中,充氣速度越大,展開的速度越快,但由於阻尼損耗,二者並線性關系;充氣速度過大不利於結構展開過程的穩性;充氣支撐管的氣壓越大其越高,但影響效果很小。
  11. Diode - pumped q - switch solid - state lasers have many advantage such as high efficiency, compactness, high stability, and long lifetime. high peak power, high repetition rate short - pulse can be obtained by high power diode pumped, which is used comprehensively in the field such as measuring, remote sensing, photoelectric resisting, medical et

    激光二極體( laserdiode ,簡稱ld )泵浦的調q態激光器具有結構緊湊、穩性好、壽命長等優點,用大功ld作為泵浦源,可以獲得高重復、大峰值功的窄脈沖激光,這在激光測量、光電對抗、激光遙感、激光醫療等領域有著常廣闊的應用前景。
  12. Connectors for frequencies below 3 mhz for use with printed boards. part 7 : detail specification for connectors, 8 - way, including fixed and free connectors with common mating features, with assessed quality. european standard en 60 603 - 7

    印製板用低於3mhz的連接器.第7部分:包括具有通用匹配特性連接器的經質量評的8路連接器詳細規范
分享友人