非承重混凝土 的英文怎麼說

中文拼音 [fēichéngzhònghúnníngtǔ]
非承重混凝土 英文
non-load-bearing concrete
  • 非 : Ⅰ名詞1 （錯誤） mistake; wrong; errors 2 （指非洲） short for africa 3 （姓氏） a surname Ⅱ動詞1 ...
  • 承 : Ⅰ動詞1 （托著; 接著） bear; hold; carry 2 （承擔） undertake; contract （to do a job） 3 （客套話...
  • 重 : 重Ⅰ名詞（重量; 分量） weight Ⅱ動詞（重視） lay [place put] stress on; place value upon; attach im...
  • 混 : 混形容詞1. （渾濁） muddy; turbid2. （糊塗; 不明事理） foolish; stupid
  • 凝 : 動詞1. （凝結） congeal; curdle; coagulate 2. （注意力集中） fix
  • 混凝土 : concrete; beton; jetereting混凝土壩 concrete dam; 混凝土板 concrete slab; 混凝土標號 concrete gra...
  1. On the background of the innovation of the wall material and the current situation of the development in china, the regenerative material is synthetically used to prepare new wall material, including high - environmental - protection steam - maintain fly ash bricks ( hsfab ) and self - aerated lightweight concrete ( salc ). the mechanics characteristic, durability and micro - structure of the new wall material are analysed. it shows that the materials are the perfect replacement products of the traditional solid clay brick. two systems of hsfab - cement - steel slag - fly ash - slag and lime - steel slag - fly ash - slag - are designed to fit for the requirement of performance, cost and environmental - protection, etc.

    本課題以國家和地方墻體材料改革政策和發展現狀為背景，綜合利用當地可再生資源研製開發了新型墻體材料體系，該體系包括承重墻體材料? ?高綠色度蒸養粉煤灰磚（ high - environmental - protectionsteam - maintainflyashbricks ，以下簡稱hsfab ）和非承重墻體材料? ?自發氣輕質混凝土（ self - aeratedlightweightconcrete ，以下簡稱為salc ） 。
  2. Through the bonding tests and the theory analysis between the advanced composite glass sheets and the concrete under the general load - carrying condition, the iterative load - carrying condition, the freeze - thaw action, and the defective bonding, the calculative model has been established, and the numerical value of fibre sheet strain under different load - carrying has been confirmed. the bond strength calculative expressions for the concrete bonded with glass fibre sheet under the pull - shear and the bend load - carrying conditions have been established. the author put forward the decreasing coefficient and the calculative expressions for the influence of reinforce effect by the non - effective area and the calculative expressions for the influence of the freeze - thaw action on the carrying capacity of the concrete beams

    本文採用美國泰扶高強復合玻璃纖維布以及與之性能相當、由南京玻璃纖維研究院自行研製開發的egfw430型玻璃纖維布兩種材料，通過在靜載、重復荷載、凍融及有缺陷粘結條件下的高強玻璃纖維布與混凝土粘結性能的試驗研究與理論分析，建立了玻璃纖維布-混凝土的粘結計算模型，明確了不同受力狀態下纖維布應變的設計取值，提出了玻璃纖維布-混凝土抗剪粘結強度的計算公式;確定了考慮非有效粘貼面積對加固效果影響的折減系數;給出了凍融循環次數引起承載力下降的插值計算方法;並驗證了重復荷載作用下玻璃纖維布與混凝土良好的粘結性能。
  3. Standard specification for nonloadbearing concrete masonry units

    非承重混凝土圬工單位的標準規范
  4. In the finite element method analysis, the constitutional relationships of steel and three - dimension compressed concrete were conducted by using increment plastic theory. in the paper a serious of joint models were analyzed by using the program ansys and the mathematical formulas for determination of load - carrying capacity of shearing and bending in the joint region were also given. at last the influence of many parameters to the load - carrying capacity in the joint region was analyzed and some suggestions were given for the design in the practical projects

    在有限元分析中，用增量塑性理論推導出鋼材以及三維受壓混凝土的本構關系，重點是三維受壓混凝土的本構關系，建立了模型的單元剛度矩陣，給出了程序中非線性方程的求解方法，並用ansys軟體計算了一系列節點模型，得出了節點域的抗剪、抗彎承載力及各參數對節點域承載力的影響情況，並用試驗結果和計算公式驗證了有限元計算結果。
  5. Determination of steel stresses in unloaded reinforced components made of autoclaved aerated concrete ; german version en 1738 : 1998

    蒸氣淬火氣孔混凝土製非承重加強部件鋼應力測定
  6. Based on the experimental study and inelastic theory, the ultimate flexural capacity of steel encased concrete composite beams are derived. the difference between steel encased concrete composite beams with full shear connection and beams with partial shear connection, together with the relationship between the inelastic neutral axis of steel parts and concrete parts, are considered in the formulae. the calculation results of the eight specimens with full shear connection and the three specimens with partial shear connection are in good agreement with the experimental data, which validates the effectiveness and efficiency of the proposed calculation methods. furthermore, the nonlinear finite element analysis of the ultimate flexural capacity of the steel encased concrete composite beams is performed. nonlinear material properties and nonlinear contact properties are considered in the finite element analysis. the finite element analytical results also correlate well with the experimental data

    基於外包鋼混凝土組合梁的試驗研究和塑性理論，按照鋼梁和混凝土塑性中和軸相對位置的不同，分別推導了完全剪切連接和部分剪切連接的外包鋼混凝土組合梁的正截面極限抗彎承載力的計算公式，並對外包鋼混凝土組合梁進行了非線性有限元分析，分析中重點考慮了材料非線性和接觸非線性. 8根完全剪切連接和3根部分剪切連接試件的正截面極限抗彎承載力的計算結果及有限元分析結果與試驗結果吻合良好
分享友人
分享到 Line

分享到臉書