靶裝置 的英文怎麼說

中文拼音 [bǎzhuāngzhì]
靶裝置 英文
target assembly
  • 靶 : 1. （射擊的目標） target 2. （轡革; 韁繩） bridle; halter; reins
  • 裝 : Ⅰ名詞1 （服裝） dress; outfit; attire; clothing 2 （演員的化裝品） stage makeup and costume Ⅱ動詞...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 裝置 : 1 （機器設備的配件）installation; device; apparatus; equipment; arrangement; gear; appliance; rig...
  1. The charter i introduced the schematics of the experimental setup, the model of pulsed laser ablating solid target ( s - n model ) and the subplantation model for film growing proposed by y. lifshitz

    第一章簡要介紹了實驗裝置、激光燒蝕固體靶的s - n模型和y . lifshitz提出的次表面生長模式。
  2. According to the intersection measuring principle, two optoelectric devices intersecting with the ground into the same angle with, are placed to form one overlapping upright sky screen

    交匯測量方案是利用交匯原理，放置兩臺光電檢測裝置，形成的光幕相互交疊，構成垂直於地面的交匯測量靶面。
  3. For liquid xe aerosol spray target, important lpp characteristics, such as laser - to - euv conversion efficiency, euv radiation absorption, debris production by target material erosion or deposition, are studied in detail, a 13. 4nm conversion efficiency of 0. 75 % into 2 % bandwidth and 2 steradian emission solid angle is achieved at 0. 5mm laser - nozzle distance

    在實驗上，建成了一套高光譜解析度和高靈敏度的軟x射線脈沖輻射測量裝置。測量了co _ 2 、 o _ 2 、 cf _ 4 、 kr和xe液體微滴噴射靶lpp光源在6 20nm波段的軟x射線輻射光譜。
  4. Boresight fixture assembly

    校靶裝置
  5. Contrasting the results of simulation and the experiment for depositing the 3 inch thin films by icds technique, the center position of substrate and the target is in a 18mm offset, the thickness distribution homogeneity is under 8 %. based on the analyses of the theoretic heat distribution for the radiant heating system, a 3 inch size radiant heater fitting for the requirement is designed and made, whose temperature difference is under 6 %

    其次，對3英寸范圍內的膜厚分佈進行了理論模擬，在此基礎上和試驗結果對比分析，發現：在倒筒靶直流濺射裝置下，如果採用一種讓基片中心和靶中心處于相對偏心距離為18mm的位置來制備3英寸薄膜，其膜厚分佈的均勻度范圍控制在8以內。
  6. A funnel - shaped or cone - shaped device towed behind an aircraft as a target

    飛機拖靶拖在飛機尾部用作靶子的漏斗形或錐形裝置
  7. In this paper, the time - resolved spectrum measurement instrument has been improved and optimized based on what we have done, the real experiments for measuring time - resolved spectrum of xe flash - lamp and time - resolved spectrum of matter under pulse laser shocking were made

    本文在本科研組已有工作基礎上改進和優化了時間分辨譜測量方法和裝置，對xe閃光燈脈沖時間分辨光譜進行了成功的實測，對脈沖激光沖擊靶材的輻射譜進行了時間分辨測量。
  8. The mathematical formula about the dynamic object standard device used for measurement tracking precision in the factory is thorough researched in this paper, too. the entirety example calculate method used for define the parameter of the complex maths model about the dyamic object standard device is described

    本論文還對跟蹤精度室內檢測裝置- - - -動靶標標準裝置的數學模型進行了較深入的研究，並將窮舉法用於確定具有復雜數學模型的動靶標標準裝置基本參數。
  9. Officers in training wing adopted several new initiatives including using air filters at all indoor ranges to reduce the emission of hazardous particles

    訓練部員工所採取的環保新措施包括在室內靶場裝置空氣清新機，以減少向外釋出有害粒子。
  10. The proposition of the scheme for the electric power : according to the request, we imagine pull scheme have : generator - transfer and is fitted rapidly by direct current - direct current machine - target car ; generator - exchange and is adjusted and fitted rapidly - exchange the electrical machinery - the target car

    電力拖動方案的提出及確定：根據陸軍指揮學院元氏分院提出的要求，設想的拖動方案有：發電機-直流調速裝置-直流電機-靶車；發電機-交流調速裝置-交流電機-靶車。
  11. 3. a raytrace model of both co - axis and non - axis beam propagations for high - power solid - state laser systems has been set up and simulations on shots have been conducted to get the spot distribution at target point. according to the requirement of system design and theory of mathematic statistics, the dispersion circle and frequency distribution, which optimize the stability allocation of optical components, have been presented

    3 、建立了共軸與非共軸相結合的光線追跡模型，通過對大型固體激光裝置打靶的模擬模擬，獲取光束在靶點處的彈著點分佈，依據總體設計要求，運用數理統計原理，採用彌散圓和頻率分佈方法對彈著點分佈進行分析，優化光學元件穩定性分配指標。
  12. Reliability, which is the most important index to measure the stability of sg - iii, is closely related to the system shot success ratio, maintenance and support costs. it indicates the ability of sg - iii to keep working or to perform its required function

    可靠性作為神光iii裝置穩定運行的最重要的衡量指標，直接關繫到其打靶成功率、運行維修和保障費用，表徵了裝置在使用過程中保持正常工作狀態或完成規定任務的能力。
  13. The sg - iii prototype facility is a experiment facility that is applied for the inertial confinement fusion ( icf ). the electrical control reflective mirror is the last adjust equipment when the laser enter the final optics module. so the adjust precision of the reflective mirror directly affects the shooting quality

    神光-原型裝置為我國用於慣性約束核聚變（ inertialconfinementfusion ， icf ）研究的試驗裝置，電控反射鏡架為入射激光進入終端光學組件的最後一套調整裝置，該裝置調整精度的高低直接影響激光打靶的質量。
  14. A device was constructed, which is made up of a detector, a three demension micromovement device with high precision which can be controlled at long distance, an enough large target chamber, a serial balzers pressure stabilizing system which can measure and adjust the pressure and an electronic acquiring system to measure the ionization distribution

    它包括探測器、可遠距離遙控的高精度三維微動裝置、足夠大的靶室系統、可對工作氣體的氣壓進行測量和調節的氣壓穩定系統以及進行電離分佈研究的電子學系統。
  15. Methods based on statistics for dimensional position and data processing were suggested for the calibration of the dimensional angle shown by a programmable dynamic target using linear matrix ccd and video interpretation. studies in this paper show that the programmable target system is functional and capable of testing photoelectric theodolite. consequently conclusions can be drawn that programmable dynamic target is new equipment to tes t photoelectric theodolite, not only can it check and test the performance, but also can measure the precision

    得出了初步結論：可編程動態靶標由於配置了位置輸出元件和時間統一系統，實現了位置閉合，能對靶標的運動進行有規律的控制，克服了常規旋轉靶標的固有缺點，可以提供模擬目標的空間標準角，因此可編程動態靶標不僅可以作為跟蹤靶標使用，還可以作為測量靶標使用，是檢測光電經緯儀跟蹤性能和測角精度的新裝置。
  16. The examples of the planar gpa pressure explosive loading devices and its applications are given

    給出了可調控靶中應力波形的平面低壓化爆加載裝置的應用實例。
  17. When the laser facilities are in operation, the position and direction of all the beams are subject to change due to the optical structural drifts excited by multiple input sources. these changes will influence the precision of the beam propagation and finally the focal spot positions on targets which are strictly dictated by the requirements of plasma physics experiments

    這些激光裝置在運行過程中，光學元件結構在外界激勵因素作用下容易產生漂移，使光束位置和方向發生改變，影響光束打靶定位精度，無法滿足精密物理實驗要求。
  18. The relation between drifts of optical components and the beam focal positions on targets has been analyzed and a physical model has been set up to describe the relation

    1 、分析和論證了大型固體激光裝置中光學元件穩定性與靶點光束定位之間的關系，確立了光學元件穩定性影響打靶精度的物理模型。
  19. Employing the crucial component of the system : a photoelectric phase monitor, the entire sample phase change can be observed instanly, so the reliability of data acqired from shocl copressed experiments are assured

    冷靶系統的關鍵-光電物相監測裝置可全程實時監控樣品的狀態，從而確保了沖擊壓縮數據的可靠性。
  20. 8 gold target and shield installing equipments provide gold for yourself

    8金靶安裝裝置及屏蔽裝置一套黃金自備
分享友人
分享到 Line

分享到臉書