韌帶破裂 的英文怎麼說

中文拼音 [rèndàiliè]
韌帶破裂 英文
desmorrhexis
  • : 形容詞(不易折斷; 柔軟而結實) pliable but strong; tenacious; tough
  • : Ⅰ動詞1 (完整的東西受到損傷) be broken; be damaged 2 (使損壞) break; break down; damage 3 (使...
  • : 裂動詞[方言] (東西的兩部分向兩旁分開) open
  • 韌帶 : anadesma; ligament; ligamentum (pl. ligamenta)
  • 破裂 : break; fracture; burst; split; rupture; crack
  1. He was carried off but initial fears he had ruptured an anterior [ / size ] [ size = 3 ] cruciate ligament were allayed when scans instead indicated a much more [ / size ] [ size = 3 ] minor injury to a posterior cruciate

    他被迫離開賽場,他的十字韌帶破裂使得他感到恐懼,還好掃描結果顯示十字韌帶破裂的傷勢要比之前估計的要輕得多
  2. The following conclusions are gained : ( 1 ) the located shear band prongs the ligament near the top crack tip and the structure may occur shear - mode fracture at the angle of 155 ? to crack when load is 87. 92mpa ; the mode of fracture of the flange joint structure is not possible to be void - mode ; ( 2 ) it is proved that loading and then unloading repeatedly can not increase the possibility of invalidation of the structure when the times of loading and unloading are not too more when load is operating pressure ; the structure is safe when the vessel is operating ; ( 3 ) in the fe model of the thesis, not considering the influence of water pressure test which is in the process of fabrication of vessel in fe results in larger deviation in analysi

    得出了以下結論:在8792mpa的載荷下筒體一封頭連接結構處的集中剪切貫穿,可能發生沿與原紋線成155 「角方向剪切型斷;筒體一封頭連接結構不可能發生窩型斷; ( 2 )在工作壓力下進行次數不多的反復加、卸載,結構不會壞,也不會喪失安定性:結構在工作狀態下是安全的; m在本文的彈塑性有限元模擬計算中,對于紋尖端進行力學分析時,不考慮壓力容器製造過程中水壓試驗的影響,將導致計算結果出現較大的偏差; ( 4 )筒體完全屈服時的載荷為92石3mpa ,封頭完全屈服時載荷為86
分享友人