預緊彈簧 的英文怎麼說

中文拼音 [yùjǐndànhuáng]
預緊彈簧 英文
preloaded spring
  • 預 : Ⅰ副詞（預先; 事先） in advance; beforehand Ⅱ動詞（參與） take part in
  • 緊 : Ⅰ形容詞1 （物體受到幾方面的拉力或壓力以後呈現的緊張狀態） taut; tight 2 （物體受外力作用變得固定...
  • 彈 : 彈名詞1. （彈子; 小球形的東西） ball; pellet 2. （內裝爆炸物, 具有破壞和殺傷能力的東西） bullet; bomb
  • 簧 : 名詞1. [音樂] （樂器里能發聲的薄片） reed2. （器物上有彈力的機件） spring
  1. This spring is a key part for ensuring normal operating of aira. stress and beforehand close quantum of helix torsion spring of rectangle section is educed by some conclusions of mechanics of materials and compute formula

    該彈簧是保證調整臂正常工作的關鍵件，本文從材料力學的結論出發，詳盡地推導了該彈簧應力及其初始預緊量的設置，並給出它們的計算公式。
  2. The results show that decreasing the driving voltage, primitive cavity, pre - tightness force of spring, and the mass of mobile elements can improve the performance of solenoid

    通過降低驅動電壓，減小初始氣隙，降低彈簧預緊力，減輕電磁閥運動部件的質量，均可以提高電磁閥的性能。
  3. At last, in according to the experiment results, the interpretation of the mechanism of the slip phenomenon of prepressing - contact spring - damping system was given in this dissertation. further more, the relationship among the limit frequency, the value of prepressing, excitation frequency, the amplitude of excitation and the materiel parameter was analyzed. base on the theory analysis the limit frequency formula was given, and the contact - slip condition for engineering application was concluded

    最後根據理論研究與試驗分析的結果，分析預緊接觸式彈簧阻尼系統產生滑移現象的機理以及共振峰值漂移現象的理論解釋，並通過定性分析接觸分離時的頻率與預緊量、激勵頻率、激勵力幅值以及墊層的材料參數之間的關系，提出能定量描述系統出現滑移現象的極限頻率公式，總結了預緊接觸式結構始終保持接觸的條件。
  4. Completely pre - assembled spring - loaded panel fasteners. thread sizes # 4 to # 10 and m3 to m5

    完整預安裝的彈簧面板緊固件。螺紋尺寸# 4到# 10和m3到m5
  5. Then the initial stress was calculated with proper load and the assembly process simulation

    模擬裝配夾緊過程施加載荷約束，並計算該過程中鋼板彈簧內部產生的預應力。
  6. Finally, the calculation method of the pre - pressures of the springs in the ” unchaining coupling equipment ” is obtained, and the magnitudes of the pre - pressures are calculated out according to the value of the grasping forces got by optimizing process

    最後獲取了「解藕裝直」中彈簧預緊力的計算方法，並根據優化所得到的各力佳計算得到了該預緊力的大小。
  7. The simplified prepressing - contact spring - damping system was studied in this dissertation. the nonlinear dynamic characteristic of this system was research by experiment method

    本文以簡化的預緊接觸式彈簧阻尼系統為研究對象，著重於用試驗方法來研究系統在動態載荷作用下的非線性動力學特性。
  8. In the theoretical analysis, first the dynamics model of the prepressing - contact spring - damping system was established by vibration theory. then the stability of the solution of this system was studied base on the qualitative theory of nonlinear vibration

    在理論分析方面，首先根據振動理論建立預緊接觸式彈簧阻尼系統的力學模型，然後利用非線性振動的定性理論研究系統周期解的穩定性。
  9. An opposite force is located in the piston to balance the one caused by pressing the spring beforehand. the precision of measurement has been enhanced

    在傳力活塞上施加一反方向的力來平衡彈簧預緊力，提高了電磁力的測量精度。
分享友人
分享到 Line

分享到臉書