預計偏低 的英文怎麼說

中文拼音 [piān]
預計偏低 英文
under prediction
  • : Ⅰ副詞(預先; 事先) in advance; beforehand Ⅱ動詞(參與) take part in
  • : Ⅰ動詞1 (計算) count; compute; calculate; number 2 (設想; 打算) plan; plot Ⅱ名詞1 (測量或計算...
  • : Ⅰ形容詞1 (不正; 歪斜) inclined to one side; slanting; leaning 2 (只側重一面) partial; prejudi...
  • 預計 : estimate; calculate in advance; expect
  1. Because rural real situation and farming tool needs were not thoroughly investigated and clearly understood, farming tool design and manufacturing ability were low, the related management and service were backward, many recommended new - type farming tools were bad in quality, high in price or not suitable for usage in the recommended regions, the new - type farming tools extension and adoption did not fulfill the goal as governments had hoped

    由於對農村的具體情況和農具的實際需求了解不充分,農具設和製造水平,新式農具質量較,價格高,技術傳授和維修服務差,經營管理相對落後,新式農具推廣使用未能達到期的目標,發揮應有的作用。
  2. And some experts even believe, the trend in the development of the iax system was, for quite some time, towards keeping high statutory tax rates, but simultaneously provide generous tax incentives tha t reduced the tax base. the basic asymmetry of tax system may favor large concerns, which may be in a better position to take advantage of the provisions in the tax code in certain states of nature. the result may be lower expected average and marginal tax rates, and a lower cost of capital, compared to newer and smaller companies

    更有學者認為,在以往很長一段時間里,稅制的發展趨勢是高法定稅率,同時附加大量稅收激勵來縮小稅基,稅制的這種基本不對稱性對大公司有利,可以面對平均和邊際稅率以及資本成本,然而大公司基於其擴張性的組織結構,與富有彈性的內容提要小公司相比,它轉變供求狀況的適應能力相對遲緩,那麼祖于大公司的稅收政策可能會阻礙宏觀經濟增長率和結構調整。
  3. In order to optimize the perpetuation tensioning tonnage of prestressed pier anchor wire of goupitan arch dam, first the scheme contrast method is adopted to define the perpetuation tensioning tonnage combination of the primary and secondary anchor wire, but the optimization result is that the pull - anchor coefficient is too big ; then the body form of the pier is optimized ; finally the anchor wire perpetuation tensioning tonnage is optimized by using ansys optimization design module based on parametric fem, the optimization result is acceptable and the pull - anchor coefficient is lowered down

    摘要為優化構皮灘拱壩中孔應力閘墩錨索永存張拉噸位,首先採用方案優選的方法確定主次錨索永存張拉噸位組合,但優選結果拉錨系數大,再對閘墩體型進行優化,然後採用基於參數化有限元的ansys優化設模塊對主次錨索永存張拉噸位進行優化,優化結果滿足應力控制要求,降了拉錨系數。
分享友人