頻帶放大器 的英文怎麼說

中文拼音 [bīndàifàng]
頻帶放大器 英文
band amplifier
  • : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
  • : releaseset freelet go
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 放大器 : amplifier; pantograph; lawnmower; enlarger; magnifier
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  1. There is a great deal of demand in modern electronics, however, for bandpass amplifiers.

    然而近代電子學對調諧的率范圍很寬的提出很多要求。
  2. Delay line oscillator is composed of broadband amprifer adjustable attenuator and saw sensor device. after output signal of delay line oscillator is smoothed, it mixes with 109mhz local oscillation signal. its differential frequency signal is smoothed by low - pass filter trimmed by shaping circuit and processed by digital processing circuit

    延遲線振蕩由寬、可調衰減和聲表面波質量傳感件構成。延遲線振蕩輸出信號經濾波后與109mhz的本機晶體振蕩輸出信號相混,通過低通濾波取其差,並經整形後由數字信號處理電路處理。
  3. The factors limiting the frequency band of the wide - band amplifier are introduced. through analyzing the effects of the intrinsic parameters and parasitical on the frequency characteristics, a method of improving fr of mosfet by using short channel device and making mosfet work at the saturation region through raising vgs is put forward ; the effects of different kinds of circuit configurations on the frequency characteristics and the junction voltage on the voltage pattern circuit, current pattern circuit and frequency characteristics are analyzed. according to the linear theory of transconductance which is applied in the bit circuit, the current pattern amplifier circuit, current transfer circuit and output circuit which consist of mosfet and the wide - band amplifier composed of them are put forward

    介紹了限制寬寬度的因素,通過分析mosfet的本徵參數、寄生參數對率特性的影響,提出了採用短溝件、使mosfet工作在飽和區、抬高柵源電壓等提高mosfet特徵率的方法;分析了不同電路組態對率特性的影響、節點電壓對電壓模電路、電流模電路率特性的不同影響,根據應用於雙極晶體管電路的跨導線性原理,提出了採用mosfet構成的電流模電路、電流傳輸電路、輸出電路以及由它們所組成的寬,獲得了良好的率響應。
  4. A uhf sensor is designed and fabricated, which mostly consists of antenna, uhf amplifier, high pass filter, and broadband wave detector

    通過與華無線電廠合作,研製了超高傳感,其主要由天線、超高、高通濾波、寬檢波等組成。
  5. Broad band amplifier

    頻帶放大器
  6. And i finished the layout design, chip test of line driver and equalizer in 2. 5gbps baseband copper cable transceiver and equalizer in the 1. 5gbps sata transceiver respectively. the main improvements and innovations in this thesis are as follows : 1 、 to design an analog equalizer tuned on - chip for 2. 5gbps baseband copper cable transceiver ; 2 、 to present an adaptive equalizer for 1000base - cx transceiver ; 3 、 to present an auto - gain control amplifier used in the adaptive equalizer for the 1000base - cx transceiver ; 4 、 to present an adaptive continuous - time gm - c filter in very high frequency for the adaptive equalizer for the 1000base - cx transceiver

    論文主要的改進和創新有: 1 、設計了適用於2 . 5gbps基銅纜收發系統片上可調的模擬均衡電路; 2 、提出了一種新的適用於千兆以太網基銅纜收發系統的自適應均衡結構; 3 、設計了甚高自動增益控制; 4 、設計了一種適用於千兆以太網基銅纜接收均衡的自適應甚高連續時間gm - c二階通濾波
  7. In active section, in order to meet performance of out put power above 10dbm, the power amplifier module of ka - band is fabricated by using hmc283 to achieve the 14db conversion gain. there are five parts that include of waveguide - to - microstrip ? mixer ? filter ? power amplifier and waveguide - to - microstrip. input signal ' s power is 10dbm, after it pass waveguide - to - microstrip, it ' s frequency is escalate from 30ghz to 35ghz

    該組件由五個部分組成:功率為10dbm信號經過波導? ?微過渡,然後混,濾波將30ghz提高到35ghz濾除不需要的諧波鏡以及三階交調信號,為了彌補混濾波的變損耗,加一級功率,此採用hittle公司hmc283晶元,此上變組件完成了上變?濾波?功能。
  8. This reduces gain but widens the amplifier's passband.

    這方法降低了增益,但加寬了的通
  9. Switching power amplifier is popularly used because of its virtues of low power losses, high efficiency and high frequency bandwidth

    開關型功率因其損耗小、效率高、通寬等優點,廣泛取代了早期低效率的線性功,成為目前功率研究的重點。
  10. The paper first reviews the research background and actuality of the filter " s design in china and other country, introduces the meaning of the project and the work of the paper, narrates the theory of the switched - capacitor network and the basic switch building blocks, analyses the related factors of the design of sc filter. such as the selection of the architecture, the trade off of the opamp " s gain, bandwidth, phase margin, slew rate and setting time, the effect of the switch " s on resistor, how to reduce the charge injection and the clock feed - through, the power consumption and the selection of the sampling frequency and so on

    本文首先回顧了濾波設計的國內外研究背景和現狀,介紹了本課題提出的意義以及本文的主要工作,論述了開關電容網路原理和基本開關模塊,分析了開關電容濾波設計的相關因素:電路結構的選擇,對運算設計中高增益、寬寬、相位裕度、轉換斜率和建立時間等的折中考慮,開關的打開電阻對電路的影響,開關電容電路中怎樣減少電荷注入和時鐘饋通,以及整個電路的功耗問題和采樣率的選擇等。
  11. When signals pass high power amplifier, they would be distorted in amplitude and phase, leading to spectrum spread and distortion of in - band signals, both of which would weaken performance of the whole system in turn

    在無線通信中,信號在通過高功率時會產生幅度和相位失真,造成譜擴展以及內信號畸變,導致整個系統性能的降低。
  12. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究,分析了這些技術的工作原理和優缺點,在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算。在設計輸入級時,為了使輸入共模電壓范圍達到軌至軌,不是採用傳統的差動輸入結構,而是採用了nmos管和pmos管並聯的互補差動輸入對結構,並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中,電流鏡負載並不是採用傳統的標準共源共柵結構,而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時,為了提高效率,採用了推挽共源級作為輸出級,輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運的設計,採用了電流鏡負載的差分設計了一個基準電流源,給運提供穩定的偏置電流和偏置電壓,保證了運的穩定性;並採用了調零電阻的密勒補償技術對運進行率補償。
  13. The amplifier request band width, to adapt radiation pulse randomness and its extremely quick front

    要求寬,以適應輻射脈沖的隨機性和其極快的前沿。
  14. The design of wide band low noise amplifier with the smith chat assistance

    圓圖輔助設計低噪聲寬頻帶放大器
  15. All band amplifier

    頻帶放大器
  16. Grading standard of quelity for broadband amplifier used in cabled distribution systems primarily intended for sound and television signals operating between 30mhz and 1ghz

    30mhz 1ghz聲音和電視信號的電纜分配系統寬頻帶放大器質量分等標準
  17. In modern wireless communication, high linear broadband amplifer is necessary and play a critical role, and even the whole communication system will be affected by its performance

    隨著當代無線技術的發展,微波寬頻帶放大器已經成為無線通信系統的關鍵組成部分,其性能好壞將影響整個通信系統的性能。
  18. Theoretically several solutions are derived in the final scheme such as broadband matching technology which included negative - feedback technology, traveling wave technology and balance technology. in addition, the design will be optimized by eda software and the final test result indicates that our design is successful. the principle of microwave amplifier is introduced at first in this paper, especially its main parameters index sign, then the material performance and the influence of parasic parameter and model setting of the gaas phemt is discussed

    文中首先介紹寬頻帶放大器的主要參數指標,接著介紹了gaasfet的材料特性,以及phemt管芯寄生參數對實際設計的影響,然後討論gaasphemt的、小信號模型的建立與分類;結合gaasphemt模型和s埠參數分析了寬匹配技術的原理;最後論述本課題中各個實現的具體方案,以及在實現過程中應該注意的問題,給出了實際寬的測試結果,並將軟體模擬結果與實測曲線進行對比。
  19. Because gyrotron traveling wave tube amplifier ( gyro - twt ) is an important millimeter wave amplifier with the characteristics of the high output power, the broadband width, and good efficiency, which has vast application vistas in many areas such as millimeter radar, communications, electronic countermeasure, and so forth, it has been pay much respect in the world

    迴旋行波管是一種功率、高效率、寬頻帶放大器,在毫米波雷達,通信與電子戰等方面有十分重要的應用前景,因而在國際上受到高度重視。由俄羅斯人g . denisov等提出的螺旋波紋波導是一種比較理想的結構。
  20. Because of low noise figure, high linear, broad frequency scale and simple structure, lossless feedback broadband amplifier becomes one of the most important types of broadband amplifiers

    無損耗反饋寬以其噪聲低、線性好、寬以及結構簡單的特點成為重要的寬類型。
分享友人