頻率容限 的英文怎麼說

中文拼音 [bīnróngxiàn]
頻率容限 英文
frequency tolerance
  • : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
  • : 率名詞(比值) rate; ratio; proportion
  • : Ⅰ名詞(指定的范圍; 限度) limit; bounds Ⅱ動詞(指定范圍, 不許超過) set a limit; limit; restrict
  • 頻率 : frequency; rate
  1. In this paper, the concept of acceleration ambiguity function ( aaf ) and acceleration resolution is put forward for the first time. using aaf, the effects of target ' s relative acceleration on several outputs of a linear - phase matched filter are analyzed, such as the output signal - noise - ratio loss, the doppler resolution, the constraint on optimal accumulative time ( opt ) and their tolerable limits

    論文首次提出並研究了加速度模糊函數和加速度分辨力的有關概念,並以加速度模糊函數為分析工具,詳細討論了加速度對線性相位匹配濾波器的輸出信噪比的損失程度、對多卜勒分辨能力的影響程度、對最優相參積累時間的約束關系以及線性相位匹配濾波器輸出受加速度影響的等問題。
  2. Evolving the underlying networks to support a mass market, however, presents a number of challenges : spectrum is a limited resource ; cdma standards have sub - optimal spectral efficiency ; layered 3g network architectures are not conducive to low - latency services ; and capacity - enhancing smart antenna or multiple antenna systems have been disappointing

    但開發基本網路以滿足廣大市場,仍面臨幾大挑戰:譜資源有、 cdma標準的光譜效未達最優、分層3g網路架構未能實現即時服務、及量增大的智能天線或多天線系統仍不盡人意。
  3. Through utilizing the shift multiplication characteristics of m series, this kind of radar system eliminates the bad effect of doppler frequency. in theory, the doppler tolerance of the radar system can reach the half of the code rate with proposed echo pretreatment method in this paper

    從理論上說,應用於該雷達系統的信號處理方法可以使得雷達系統的多普勒達到偽碼子碼重復的一半,從而使偽碼調相雷達可以有效地發現高速目標。
  4. This paper describes mainly system functions, measuring methods, circuit design, software program and errors analysis of a new type of measuring instrument. this instrument can measure and monitor electric parameters in single - phase circuits, three - phase ( three - wire or four - wire ) circuits. this system can be applied to electric devices and power plants, transformer substations with harmonic pollution. it can measure current, voltage, power, energy, frequence, power factor etc. it also can detect load quality, phase sequence, alarm, display and print results, as well as detect and dispose negative power

    該儀器適用於含有諧波污染情況下的機電設備現場、發電廠、供電局、企業變電所現場,可用來測量電流、電壓、有功功、無功功、視在功、有功電能、無功電能、視在電能以及和功因數等電參數,並具有負載性質(感性、性)判別,正、逆相序判別指示功能;超報警功能;列印記錄功能和負功檢測及處理功能。
  5. Bridge can be detected by the transformation of structure mode parameters with the modern technology of signal test. the vibration frequency is obtained easily in the measure, but it is n ' t sensitive to the transformation of mass and rigidity. so it is difficult to identify by test system when the damage of structure reach to the limit damage degree

    在實際的工程測量中最易獲取的結構模態參數就是振動,但是振動對質量、剛度的變化具有弱靈敏性,這使得即使結構的破損程度達到了極破損程度,振動的變化也很難被測試系統識別。
  6. B ) equivalent circuit method and finite element analysis ( fea ) to compute the static force are presented, the results obtained by each method are compared one with the other. c ) the results of dynamic simulation by means of the software, ansoft show the hlfm " s characteristics when the motor works in the special frequency and single stroke and the conditions used for position control. d ) the measured static thrust - displacement characteristics and the dynamic characteristics during starting show good correlation with the calculated results

    在設計並製作了實驗樣機的基礎上所做的研究內包括; ( 1 )分別用能量法和麥克斯韋張量法推導電磁力的計算公式,並討論他們的不同應用范圍; ( 2 )分別用等效磁路法和有元法作直線力電機的靜特性分析,並比較分析它們的計算結果; ( 3 )用有元模擬軟體做直線力電機動態特性的模擬,分別分析直線力電機的特性、動子開合閘特性和開環位置控制的工作特性; ( 4 )做直線力電機的靜推力?位移特性實驗和動子開合閘的動態實驗,並將實驗結果與計算結果進行對比,實驗驗證了計算模型及計算方法的正確性。
  7. Quick and frequent cutting for a few sets of capacitors shall be carried out, of which the factors of electric power shall be maitained in optimum condition so as to minimize the line loss, increase effective output capacity of distrubuting transformer and optimize the quality of power demand

    對多組電器進行快速而繁的投切,使受電功因數始終保持在最佳狀態,從而最大度地降低線路損耗和增加配電變壓器的有效輸出量,優化用電質量。
  8. Comparing with the traditional phase - shifted laser range finder, the method could implement the ranging with multifrequency by using single modulated frequency. it could not only solve the contradiction of the range and the precision, but has high degree of accuracy and wide range, simplify the hardware design, and reduce the cost. this paper introduced the theory of phase distance measurement, analyzed various testing methods and expatiated the hardware and the software for the proposal system

    與傳統的相位法測距相比,本方法使用單調制實現了多測距,有效地解決了相位法測距中測程與測量精度之間的矛盾,具有高精度、大量程、大噪聲的特點,而且簡化了硬體設計,降低了成本;其次在數據處理中採用數據加窗函數的方法,提高了方波信號的譜解析度,進而提高了測量的精度。
  9. A fem software as an important tool, work has been done as follows : the method using fem to design anomalous structure of transducers was adopted ; the vibration modes of the elastic pipe, ultrasonic transducers and system has been analyzed in piezoelectric coupled field. resonant frequencies of the transducers have been matched quite well with resonant frequencies of pipe, which can make it easy and accurate to design a transducer. the values of equivalent dynamic capacitors and dynamic inductances of ahead nine orders have been gotten derived by fem method, and fem equivalent circuit of the transducers has been built

    以ansys有元軟體為主要分析工具完成了設計工作;在經典換能器設計理論和前人經驗的基礎上,對不規則形狀的換能器採用了有元的方法設計;在耦合場中分析了換能器、導管及整體裝置的振動情況,使換能器的諧振與導管的諧振達到了較好的匹配,使設計變得更加易和準確;利用有元方法建立了振子的等效電路模型,求出了其前6階模態的等效動態電電感值,為阻抗匹配和驅動電路的設計提供了依據。
  10. Its main contents is as follow : firstly, it makes the discrete model for the subsystems of the scraper conveyor and the whole system with the finite element method ; secondly, the modal analysis method is used to obtain the inhere frequency and mode of the viberation ; finally, computer simulation is applied to get the displacement, velocity, acceleration and tension of the anyplace on the scraper conveyor for the four special working condition

    其主要內如下:用有元方法建立了刮板輸送機子系統及整個系統的離散體動力學模型;應用模態分析法求解系統的固有和振型;對四種非穩定工況下的動態特性進行計算機模擬,得出整個刮板輸送機在任意點的位移、速度、加速度和動張力。
  11. Frequency tolerance for transmitter

    發射機頻率容限
  12. The 3rd generation ( 3g ) mobile communications system and part of the 2nd generation ( 2g ) mobile communications use pn sequences or walsh codes as spread codes, and their system capacities are limited by the multiple access interference ( mai ) from asynchronous transmitted signals

    採用pn序列和walsh碼進行直序列擴的第三代和部分第二代cdma移動通信系統,其量受到異步傳輸時多址干擾的制,其數據因在n個碼片的時間內只能傳輸一個數據符號而受
  13. Taking single four - quadrant power switch mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy, the auxiliary switching power supply and parallel technology of this kind of converters are investigated. the output characteristic curve and the design for the key circuit parameters are given

    以單四象開關式電路拓撲為例,分析研究了這類變換器工作模式、穩態原理與電壓瞬時值反饋控制策略,給出了變換器的外特性曲線、關鍵電路參數、機內輔助開關電源的設計,對電流源高交流環節ac ac變換器並聯擴技術進行了研究。
  14. It has been widely applied in personal communications, mobile communications and the field of broad band wireless access, and it has also been regarded as the main air access of the third generation mobile communications, because comparing with tdma and fdma, cdma has greater system capacity, higher frequency efficiency and stronger anti - interference ability, at the same time it still has the potential of solving the conflict of limited frequency resource and limitless user request

    相對于tdma , fdma等多址技術而言,它具有系統量大,帶利用高,抗干擾能力強,保密性能好等優越性,同時還具有緩解有帶與無線用戶需求之間矛盾的潛力,因而在個人通信,移動通信,寬帶無接入領域都得到了廣泛的應用,也被普遍認為是未來第三代移動通信的主流空中介面技術。
  15. This becomes increasingly critical as systems are being designed to combine circuits operating at lower power ( implying higher impedance levels ), higher speed ( implying lower nodal stray capacitance, faster edges, and higher frequencies ), and higher resolution ( much less output noise permitted )

    當今的電子系統常常包含著低功耗(意味著阻抗更高) 、高速度(節點寄生電更小、信號邊沿更陡峭、信號更高)和高分辨力(噪聲更小)等電路,因此這個問題尤其應該引起重視。
  16. The transient analysis and simulation studies in time - domain showed that the transient capacitance current of busbar is unable to be caught due to the limitation of the given sampling frequency, therefore the transient current singularity of the fault line and the non - fault line will approximate, which prevents to identify the fault line with the criterion calculation result of transient current protection

    研究結果表明,線路出口故障時暫態電流保護完全失去選擇性的根本原因是,在給定的采樣制下,難以捕捉到過渡過程中極其短暫的母線分佈電中的暫態電流,從而故障線路與非故障線路暫態電流波形的奇異性相近,根據故障線路和非故障線路的暫態保護判據計算結果不能正確識別故障線路。
分享友人