顆粒平衡 的英文怎麼說

中文拼音 [kēlìpínghéng]
顆粒平衡 英文
equilibrium of grains
  • 粒 : Ⅰ名 （小圓珠形或小碎塊形物） small particles; grain; granule; pellet Ⅱ量詞（用於粒狀物）
  • 平 : Ⅰ形容詞1 （沒有高低凹凸 不頃斜） flat; level; even; smooth 2 （高度相同; 不相上下） on the same l...
  • 衡 : Ⅰ名詞1 （秤桿） the graduated arm of a steelyard2 （稱重量的器具） weighing apparatus3 （姓氏） a...
  • 顆粒 : 1 （小而圓的東西） pellet; bead; dust; anything small and roundish （as a bean pearl etc ）2 （一...
  1. Adsorbed pesticide is in equilibrium with that dissolved in the water film around the soil particle.

    吸附農藥與溶解在土壤顆粒周圍水膜中的農藥平衡。
  2. The frictional force between a particle and fluid counterbalances the weight of the particle.

    顆粒與流體之間的摩擦力與其重量相平衡。
  3. By making some assumptions, collision frequency were presented. then the the flocculation kinetics model was established through population balance equation. comparison of experimental data and modeling results indicate that there are the same trend between the two. so the model can predict floes number and size during flocculation of yellow river ' s loess particles without using empirical parameters. the tem and sem were used to obsever floes in the study of floe structure. the flocculation was divided as flocculi, floc and floe aggregate. the floes structure model was established by assumption that particles position in floe accords with tetrahedron. the fractal dimension of model and experimental floes was found to be coincidentso the model can reflect the structure of flocs formed in flocculation of yellow river ' s loess particles by macromolecule flocculant at a certain extent

    最後，本文還對絮凝動力學和絮體結構進行了研究，在前人研究的基礎上，針對高分子絮凝黃河泥沙，對絮凝過程作了一些符合試驗條件的假設，建立了顆粒碰撞頻率表達式，應用了顆粒數量平衡方程，從而建立了絮凝過程的動力學生長模型，模型計算結果與試驗數據對比表明，二者趨勢一致，在沒有使用經驗參數的情況下基本上能夠描述黃河泥沙絮凝過程中絮體數量和尺寸分佈的變化過程；對絮體結構的研究中，應用掃描電子顯微鏡和透射電子顯微鏡對絮體進行了觀察，將絮體分為絮粒、絮團和絮網三個不同的生長階段，通過假設顆粒結合位置符西安建築科技大學博士學位論文合正四面體，建立了絮體結構模型，計算得到的模型絮體分形維數基本與試驗中的實際絮體相符，在一定程度上能夠反映高分子絮凝黃河泥沙生成的絮體結構。
  4. In this paper, high heat penetration into a moving particulate bed is described mathematically with a comprehensive heat and mass transfer model. the distribution of gas velocity and pressure, the temperature field of gas and solid in the moving particulate bed are examined for different conditions. the results show that thermal penetration into the moving packed - bed particles by fluid flow in porous media is high only in the position near the gas entrance. the thermal penetration thickness tends to increase with the fluid flow velocity and decrease with the particle moving velocity. in the region of thermal penetration, the porosity of solid bed has significant effect on gas field and pressure loss. it is feasible to reduce the gas pressure loss by a larger width / height packed bed in design and operation. the correspondence between thermal infection depth and particle bed height would be helpful to keep high oapacity of reactor and reduce the cost of operation

    針對移動顆粒床中物料層內的高溫氣體滲流傳熱現象，考慮滲流與傳熱的相互作用，採用局部非熱平衡假設建立了多孔介質滲流傳熱物理數學模型並進行了數值計算.研究了不同情況下床內填充多孔介質中的流速、氣固溫度和床層壓力損失.計算結果表明，高溫熱氣對移動床顆粒料層的熱滲透主要發生在滲流入口端區域，增大入口滲流速度以及減小床層物料下移速度將導致物料溫度沿床高慢速下降，熱滲透深度擴大，熱滲透作用區域內的物料溫度水平提高.在熱滲透作用區域，孔隙率對流場和壓力損失有很大的影響.研究結果對于移動顆粒床反應器的設計與運行具有一定的參考作用
  5. Testing of ion exchangers - determination of bulk weight density, equilibrium moisture content and solids

    離子交換器的試驗.散重密度，平衡濕度和固體顆粒的測
  6. It is the result of self - assembly of molecules and embodiment of dissipative structure under the imbalance state. for chondroitin sulfate ( cs ), the self - assembly behavior of cs in the presence of ca2 + is studied by afm. the result shows that cs can be formed integrated self - assembly films when its concentration exceeds 1. 0mg / ml

    實驗結果表明通過稀溶液澆鑄法可以制備具液晶性的薄膜，這種液晶結構是殼聚糖膠束顆粒在分子間的相互作用下形成的自組裝構型，是一種非平衡狀態下的耗散結構。
  7. The random mathematical model is described using equivalent markov equations. the time and state parameters are discrete. based on the model, the flow rate distributions along radial and average at any height can be calculated directly, moreover, the probability transition matrix of the flow can be determined via the statistic character of the random cumulate particles, and be corrected by s. cd the random theoretical model shown in fig. l, the section of the bed of tbr is divided into a series of concentric circles

    一、在常溫和常壓下進行滴流床反應器流率分佈的研究，以狀態離散、時間離散的齊次markov過程描述了滴流床在滴流區的流率分佈，建立了滴流床在滴流區流率分佈的隨機模型，根據此模型可以： 1 、可直接確定任一高度下的液體徑向流率分佈及平衡流率分佈； 2 、液體流動的概率轉移矩陣可由隨機堆積顆粒的統計特性確定，以參數s修正。
  8. And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change

    結果發現：二氧化硅膠體顆粒均勻分佈於脲醛聚合物網路中，煅燒去除有機模板后微球表面變粗糙，而粒徑沒有明顯變化； ph值較小時，復合微球中聚合物含量較大，而ph值較大時，得到復合微球結構鬆散，因此熱處理后的二氧化硅微球孔容及平均孔徑都較大，而在ph = 0 . 8時，得到最小值；武漢理工大學碩士學位論文隨著熱處理溫度的變化，小於160時，空分佈較窄，而比表面積較小，在350時，由於有機模板的去除，微球孔結構發生突變，比表面積明顯增大，而孔徑分佈變寬，溫度繼續升高時，二氧化硅網路發生收縮，平均孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態，分佈沒有太大變化。
  9. The results approve that i ac i is a good parameter to be a token of the diameter distributing of particles. then a criterion of mean fluctuation difference is put forward for b particle. fluctuation complexity varied with different particle, static bed height diameter particle and axis position of sensor are studied

    本文認為是顆粒密度的差異造成漲落復雜性均值的差異，而平均漲落偏差| c |廣定程度上是顆粒粒徑分佈的一個重要衡量指標，而且針對b粒子提出了平均漲落偏差判據，實驗數據和該判據有很好地符合。
  10. Abstract : this paper analyzed the mechanism of solutes removal from water in a pa cked granular bed based on the principles of adsorption equilibrium and mass tra nsfer, put forward a numeric method to predict the treatment effects, and how to u se the method in actual situation

    文摘:本文從對流傳質和吸取平衡的基本原理出發，分析了顆粒填充床吸附溶質的機理，提出了用吸附模型的一種數值解來預測過濾處理的結果，以及如何在實際中應用該方法。
  11. If we known radius distribution of media grains and add the thermal perturbation on the normal thermal gradient, thus it lead to unremitting the dynamics process of heat and mass transportation and chemical interaction in the area

    並使用此模型研究了局部的溫度變化和顆粒半徑不均一分佈對研究區域內溫度場和濃度場的變化情況，其結論是它們之間的耦合可能打破系統的平衡，驅使系統長時間持續進行流體輸運反應動力學過程。
分享友人
分享到 Line

分享到臉書