風口冷卻器 的英文怎麼說

中文拼音 [fēngkǒulěngquèqì]
風口冷卻器 英文
tuyere block
  • 風 : Ⅰ名詞1 （空氣流動） wind 2 （風氣; 風俗） practice; atmosphere; custom 3 （景象） scene; view 4 ...
  • 口 : Ⅰ名詞1 （人或動物進飲食的器官; 嘴） mouth 2 （容器通外面的地方） mouth; rim 3 （出入通過的地方） ...
  • 冷 : Ⅰ形容詞1 （溫度低; 感覺溫度低） cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
  • 卻 : Ⅰ動詞1 （後退） step back 2 （使退卻） drive back; repulse 3 （推辭; 拒絕） decline; refuse; reje...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 風口 : 1 （比兩旁風大的地方） a place where there is a draught 2 [地質學] wind gap3 [冶金學] （blast） t...
  1. Whole scheme of frame design of test - bed is proposed as : the host fanner supply the firebox the once and twice air required by diesel oil ' s burning and the cooling air ; the export parameter of the test - bed is varied by the adjust of the flux of air and diesel oil. and the air flux is varied by adjusting the rev of the fanner adjusted by transducer and the corner of the fan inlet adjusted by step motor. the quantity of oil is varied by adjusting the oil valve adjusted by step motor ; the measurement of the air flux in the test - bed adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；利用變頻器調節主風機轉速、用步進電機調節風門開度來調節風量，用步進電機調節回油閥開度來調節供油量，從而實現對模擬實驗臺出口煙氣熱流量的調節；實驗臺的流量測量採用風機動力性能測試標準中測流量方法等。
  2. Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；模擬實驗臺出口煙氣熱流量是通過調節風機的轉速、風門開度及燃油量來改變；實驗臺的流量測量採用風機動力性能測試標準中流量方法等。
  3. The suitable oil flux during the circulating of transformer could be defined according to the difference of temperature between the oil and wind in the inlet and the cooling capacity of the wind cooling system ; besides the oil flux can be determined by ultrasonic, it can be estimated whether the oil is flowing equably by determining the oil flux in the branch pipes ; reducing the oil flux of the oil pump could be realized by controlling to change its frequency, which could not only save the energy, reduce the wastage, but benefit the transformer ' s circulating safely

    變壓器運行中可根據進口油溫和進口風溫之差、風冷卻器的冷卻容量來確定合適的油流量；油流量可以通過超聲波法進行測量，測量油的分管流量還可判斷油流的均勻情況；降低潛油泵流量可通過潛油泵的變頻控制來實現，不僅節能降耗，對變壓器的安全運行也有著重要意義。
  4. Air - conditioner, heat sources, cooling coils, heating coils, reheaters, smoke exhaust systems, air handling units, fan coil units, room air units, etc

    空氣調節裝置冷氣機、發熱線圈、冷卻線圈、加熱器、排煙系統、風櫃、風機盤管、窗口機等
  5. 2. there are three measuring positions for temperature transducer : inner sand temperature of double disk cooler ; testing sand temperature near feeding hopper can reflect low temperature condition of old sand ; the temperature of double disk cooler top can reflect inner temperature change of double disk ; therefore, it can estimate temperature change according to this change

    2溫度傳感器的測量位置有三處： 1雙盤冷卻器內部砂溫2進料口附近檢測砂溫，能夠反饋舊砂降溫情況3雙盤冷卻器頂部抽風口氣溫，反映雙盤內氣溫變化情況，由此氣溫可大致判斷雙盤內砂溫變化情況。
分享友人
分享到 Line

分享到臉書