飽和蒸汽壓 的英文怎麼說

中文拼音 [bǎohézhēngqìyā]
飽和蒸汽壓 英文
saturated vapor pre ure
  • 飽 : Ⅰ形容詞1 （吃足） have eaten one s fill; be full 2 （充實; 飽滿） full; plump Ⅱ副詞（充足; 充分）...
  • 和 : 和動詞（在粉狀物中加液體攪拌或揉弄使有黏性） mix （powder） with water, etc. : 和點兒灰泥 prepare some plaster
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 壓 : 壓構詞成分。
  • 飽和 : （在一定溫度壓力下, 溶液可含溶質的量達到最大限度, 不能再溶解, 泛指事物達到最高限度） saturation; saturated
  • 蒸汽 : vapour; reek; breath; steam蒸汽採暖 steam heating; 蒸汽錘 [機械工程] steam hammer; 蒸汽打樁鍾 ste...
  1. Specification for rubber hoses for high - pressure saturated steam

    高壓飽和蒸汽橡膠管規范
  2. Specification for rubber hoses for low - pressure and medium - pressure saturated steam

    低壓和中壓飽和蒸汽用橡膠軟管規范
  3. The results show that in 185 saturated steam, pyrite tailing doesn ' t hydrate alone, but is converted into calcium silicate hydrate when mixed with lime

    結果表明： 185飽和蒸汽壓下，硫鐵尾礦不具有水熱水化的能力，硫鐵尾礦與石灰可以形成具有膠凝性能的水化產物。
  4. When the moisture content is below fibre saturation point, the movement of absorbed water is subdivided into two parts : one is diffusion transfer due to the vapor pressure gradient, the other is moisture movement caused by the pressure fluctuation due to the variation of medium

    在纖維飽和點以下時，木材內部吸著水的遷移可分為：水蒸汽壓力梯度下的擴散遷移和由於乾燥介質壓力的波動而引起的浮動壓力下的遷移兩個部分。
  5. The saturated densities, vapour pressures, and latent heats of vaporization for hfc working substances of refrigeration are calculated by using a set of general equations of thermophysical property of liquids

    摘要應用一套通用型流體熱物性方程對hfc類致冷工質的飽和密度、蒸汽壓和汽化潛熱進行計算。
  6. High water saturated vapour pressure leads to the more possible occurrence of cavitation phenomena in water hydraulic pump, and so as in sliding shoes hydraulic supporting without exception

    水的高飽和蒸汽壓力使得水壓泵中極易發生氣蝕現象，滑靴靜壓支承也不例外。
  7. Saturated vapour pressure

    飽和蒸汽壓力
  8. Saturated vapor pressure

    飽和蒸汽壓
  9. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響，對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響，弄清了氮氣輔助蒸汽增產的機理主要表現在：氮氣輔助后增加攜熱能力，降低殘余油飽和度，氮氣的壓縮膨脹作用分散和改變了原油流動形態，增強了原油流動性；擴大蒸汽的波及體積，補充地層能量，提高回採水率，強化蒸汽蒸餾效應。
  10. The project studied the direct contact condensation behavior of saturated steam on the subcooled liquid in passive gravity injection system. the experiment parameters were as follows : the initial pressure of prz ranged from 0. 2 0. 6mpa and the initial fluid temperature of core makeup tank ranged from 10 80. condensation phenomenon in cmt was observed

    本課題進行了非能動重力補水系統中飽和蒸汽在過冷液面上直接接觸冷凝的實驗研究，研究了在加裝遮流板時，系統壓力0 . 2 0 . 6mpa ， cmt初始溫度為10 80條件下壓力容器cmt中飽和蒸汽在過冷液面上冷凝的瞬態特性。
  11. Presents the operating principle, deduces the temperature - saturated steam pressure relationship, analyses the force balance of valve plates, and points out the factors determining the action of valve plates and the key problems in making this trap domestic

    摘要介紹了膜盒式蒸汽疏水閥的工作原理，推導得到了膜盒內介質的溫度飽和蒸氣壓關系式，分析了閥片的受力平衡，指出了決定閥片動作的因素和膜盒式蒸汽疏水閥國產化進程中要解決的關鍵問題。
  12. In order to size a stop - check the technical information needed is saturated steam gage pressure in pounds per square inch and actual required steam volume flow in pounds per hour

    為了確定正確的截止止回閥的通徑，需要下列有關的技術參數，飽和蒸汽表壓（磅/平方英寸） ，和實際所需的正氣流量（磅/小時） 。
  13. A treatment method of super - saturation steam for deposited salt in steam turbine is introduced, output of the steam turbine is therefore improved through purge. purification process and attentions are introduced

    摘要介紹了背壓式汽輪機積鹽積垢的處理方法?過飽和蒸汽法，通過清洗使汽輪機的出力率得以提高。介紹了清洗的過程和注意事項。
  14. Saturation vapour pressure of internal combustion engine under actual operation conditions is expressed as the multinomial by using least square method, which facilitates the calculation of rectifying coefficient of engine output and fuel consumption as well as the fabrication of computer programme for such calculations

    摘要介紹了用最小二乘法擬合方法，將內燃機現場環境狀況下飽和蒸汽壓表示為多項式形式，為計算功率和燃油消耗率校正系數，並為此而編制計算機程序提供方便。
  15. The paper is on how to set up lab platform of vapour spewing to uppercooling water surface to coagulate directly and to observe and analyse which vapour coagulate on the water surface, the results enable people to know the security system of nuclear power. the range of the pressure parameters of prz is from 0. 2mpa to 0. 6mpa, and the range of the initial temperature parameters of cmt is from 23. 5 to 78. 5, all of the testing points are 30 and there are fifty thousand testing data. many results of vapour spewing to uppercooling water surface vertically to coagulate can get. for example : coagulating can make the water of cmt surge forcefully when vapour spews to uppercooling water surface, too many vapour - bubbles come into being and strike the water of cmt owing to rupture continually, all these will strengthen the surge because of the vapour pressure of cmt

    實驗中prz飽和蒸汽壓力變化范圍為: 0 . 2mpa - 0 . 6mpa ， cmt中水初始溫度變化范圍: 23 . 5 - 78 . 5 ，實驗中測試工況30個左右，實驗測試數據50萬余個，得出了很多與非能動安全系統相關的蒸汽垂直噴向過冷水表面凝結時的結論：蒸汽垂直噴入過冷水表面凝結時會造成cmt中液面的強烈波動和振蕩，產生大量蒸汽汽泡，汽泡不斷破裂對cmt中液體帶來很大沖擊，勢必引起cmt中液體的振蕩，造成cmt汽空間汽壓不均勻，加強cmt液體的振蕩和波動。
  16. There will be a hot water layer in the water of cmt when vapour spews to uppercooling water surface vertically and coagulates directly. the higher of the vapour pressure of prz and the initial water temperature of cmt are, the deeper the hot water layer is. and obtaining the experience formula of the hot water layer is as follows : the condensation coefficient is high when vapour coagulate at first, then it will lessen with the process of coagulation, the higher of the vapour pressure of prz and the initial water temperature of cmt are, the higher of condensation coefficient is

    蒸汽垂直噴入過冷水表面凝結時， cmt中水有明顯熱分層現象， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，熱分層厚度越大，熱分層厚度的經驗關聯式為：凝結剛開始時，凝結換熱系數非常大， ，隨著凝結的進行，凝結換熱系數越來越小， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，凝結換熱系數越大。
  17. Pressures, water level, surface and axial temperatures and total clotted liquid were obtained and analyzed. by experimental phenomenon, the condensation process was divided into two phases : steam supply limit and condensation limit. the interfacial heat transfer coefficient in steam supply limit phase was calculated

    通過實驗，觀察飽和蒸汽在cmt內的冷凝現象，獲取cmt內壓力、水位變化、表面、軸向溫度分佈和累積冷凝量等重要實驗數據，對實驗所得的數據進行分析。
  18. Environmental testing for electric and electronic products. part 2 : test methods. test cx : damp heat, steady state unsaturated pressurized vapour

    電工電子產品環境試驗第2部分:試驗方法試驗cx :未飽和高壓蒸汽恆定濕熱
分享友人
分享到 Line

分享到臉書