饋電電橋 的英文怎麼說

中文拼音 [kuìdiàndiànqiáo]
饋電電橋 英文
battery supply bridge
  • 饋 : 動詞（饋贈） make a present of
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 橋 : 名詞1. （橋梁） bridge 2. （姓氏） a surname
  1. A circuit topology of the inverter with duty cycle extended active clamp forward style high frequency pulse dc link is adopted by each independent inverter. each inverter is cascaded by a circuit with duty cycle extended active clamp forward style high frequency pulse dc link and a dc / ac inverting bridge. the control strategy of voltage mode pwm forwardback is adopted by the former, and the control strategy of three - state discrete pulse modulation ( dpm ) hystersis current is adopted by the later

    每個獨立的航空靜止變流器採用占空比擴展有源箝位正激式高頻脈沖直流環節電路拓撲，由占空比擴展有源箝位正激式高頻脈沖直流環節電路與dc ac逆變橋級聯而成，前級採用電壓型pwm前饋控制技術，后級採用三態dpm電流滯環控制技術。
  2. The voltage of bridge capacitor will become unbalanced, when inverter ' s input side is a single source. this phenomenon is inherent with the control of voltage feedback. a balance winding can overcome this shortcoming and widen the application of this circuit

    採用單電源供電的半橋電路，如僅採用電壓反饋控制方案無法克服橋臂電容電壓的不平衡，通過加入平衡繞組可以克服這一缺陷，擴大電路的應用場合。
  3. The full - bridge converter was controlled with the pid strategy based on the feedback of voltage output

    電源的全橋功率變換器採用基於電壓瞬時值反饋的數字pid控制。
  4. At the aspect of hardware design, it adopts pulse distributor and the technology of single polar voltage drive to accomplish the function of controlling and driving stepmotor ; it adopts the technology of pulse width modulation and cmos h - bridge drive to accomplish the function of controlling and driving dc servomotor ; it adopts d / a convertor to accomplish the function of controlling ac transducer ; it adopts the technology of digital phase detection to accomplish the function of detecting the feedback position signal of induction phase shifter ; it adopts dsp ’ s capture cell to accomplish the function of detecting the feedback position signal of photoelectric coder

    硬體方面，採用脈沖分配器和單極性電壓驅動技術實現了步進電機的控制和驅動功能;採用脈寬調制技術和cmos互補h橋驅動技術實現了直流伺服電機的控制和驅動功能;採用d / a轉換器實現了交流變頻器的控制功能;採用數字化相位檢測技術實現了感應移相器位置反饋信號的檢測功能;採用dsp的捕獲單元實現了光電編碼器位置反饋信號的檢測功能。
  5. Different power circuits and control strategy of the single phase inverter in parallel condition are first analyzed, and half - bridge inverter is selected as the power circuit and current hysteresis control is selected as the control strategy

    本文首先對單相逆變器的主電路結構和控制電路的結構在並聯條件下進行了比較分析，最後選用了半橋結構的主電路和內環為滯環控制的瞬時電壓電流雙閉環反饋控制方式。
  6. The topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full - bridge mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of the converter are investigated. the output characteristic curve, the design for the key circuit parameters and the reference sinusoidal circuit which is synchronous with the signal of n or 1 / n times line voltage frequency are given

    該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式電路，以全橋式電路為例分析研究了這類換器工作模式、穩態原理與電壓瞬時值反饋控制策略，給出了變換器的外特性曲線、關鍵電路參數、與電網電壓n倍頻或n分頻信號同步的基準正弦電路的設計。
  7. This paper put forward a method of using amending sine value in the spwm sine table. this method can correct the distortion of the output voltage waveform, which resulted from the dead time used to the voltage type whole bridge main circuit. the inverter system adopts digital fuzzy controller with feed forward correction and which proportion coefficient and integral coefficient is changeable, so dynamic response is improved

    本文提出了一種採用修補spwm正弦表值的方法，用以改善電壓型全橋逆變主電路因上下橋的功率器件切換時先關斷后導通的死區時間而引起的輸出電壓波形畸變；逆變系統採用帶前饋校正的變比例變積分系數的模糊控制器，提高了系統的動態響應指標；系統設計了完善的保護措施，並具有市電電網的故障診斷功能。
  8. A novel resonant pole zvt three - phase pwm inverter circuit for three - phase ac motor driving is presented. the proposed circuit has the feature of being more flexible with three inverter arms in zvt process. using only one resonant inductance, the inverter can not only reduce the power loss of inductance but also avoid possibility of unbalance in motor ' s three stator windings

    提出了一種針對三相交流電機驅動的新型諧振極零電壓過渡三相pwm逆變器電路，該電路中三個逆變橋臂的零電壓過渡更具有靈活性，僅使用一個諧振電感，既減少了電感損耗又防止了電機三相定子繞組可能存在的不平衡問題，並且諧振電感中殘余能量能夠回饋給電源；新型逆變器的輔助開關均工作在零電流開關條件下，並且控制邏輯簡單。
  9. The equation of selecting filter capacitor is derived to make the feedback energy which is produced by the inverter to be minimum. the value of the capacitor has been decreased from 20u. f to 7. 6fif and the efficiency has been improved by 1. 5 %. the maximal filter inductor value has been given on the base of the hysteresis control principle

    推導出了使逆變橋的無功回饋能量最小的濾波電容取值公式，原理樣機的濾波容因此從20 f減小到7 . 6 f ，減小了62 ；系統的效率提高了1 . 5個百分點，重量也有所減小。
  10. Feed - forward control strategy of voltage error on dc - link capacitors in current - mode control half - bridge inverter

    電流型控制半橋逆變器直流分壓電容電壓偏差前饋控制技術
  11. This system is mainly constructed from a tms320lf2407a dsp which is used as the core of control parts and a dual full - bridge driver l298 which is used as driving parts. combined with other circuits and apparatus, the system fulfills the digital motor control

    本系統採用tms320lf2407adsp微控制器作為核心控制器件，採用專門為兩相四相步進電機設計的l298雙全橋驅動晶元作為功率驅動器件，結合電流、轉速反饋電路等實現對兩相混合式步進電機的數字控制。
分享友人
分享到 Line

分享到臉書