驗收性能試驗 的英文怎麼說

中文拼音 [yànshōuxìngnéngshìyàn]
驗收性能試驗 英文
acceptance functional test
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 收 : Ⅰ動詞1 （把攤開的或分散的事物聚集、合攏） put away; take in 2 （收取） collect 3 （收割） harvest...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 能 : 能名詞（姓氏） a surname
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗收 : check and accept; check before acceptance; check upon delivery; acceptance check; control reception
  • 試驗 : trial; experiment; test
  1. Standard methods of testing sorbent performance of absorbents

    吸收劑的吸收性能試驗
  2. Test method for determining solar or photopic reflectance, transmittance and absorptance of materials using a large diameter integrating sphere

    用大直經積分球測定材料的太陽能或光反射性，透明性和吸收性的試驗方法
  3. Figure 11 : three possibilities for acceptance testing

    圖11 ：驗收測試的三種可能性
  4. Experimental investigation on compensative shrinkage polypropylene fiber concrete

    聚丙烯纖維補償收縮混凝土性能試驗研究
  5. Through the experimental research, we think : the technological capacity of fiberglass asphalt macadam if weaker than asphalt macadam, however, if use elasticized capacity to solve blending technological problem. adjust the breed of fiber silk, extend its diameter, its paving capacity is still worth exploring, asphalt - rubber macadam structure lager have good deformed - become capacity and crazed - resistance capacity, small gap rate. good water - resistance capacity, good hot - stability and simple construction technology. therefore. pitch rubber spall is a good cover material which is suitable for the second class or lower whose asphalt pavement has split open because of fatigue. and is the good structural measure of preventing half - rigidity grass - roots unit shrink - rift reflecting. pave a thin layer of pitch rubber spall between asphalt - type pavement layer and half - rigidity basic level, although the cost of building is higher than paving togongbu in the middle, the construction technology, crazing - resistance and water - resistance are better than togongbu, not only could reduce greatly the reflex of half - rigidity grass - roots unit material, long then the use lifespan of pavement, but also it is possible to reduce suitably the thickness of asphalt mixture layer, though the cast of building in the early days becomes more, in the long - term opinion, it have fully important technological and economical significance

    通過試驗研究認為：玻璃纖維瀝青碎石的技術性能不如瀝青碎石好，但路用彈性性能較好，如能解決拌和工藝問題，調整纖維絲的品種，增大其直徑，其路用性能仍值得探討，瀝青橡膠碎石結構層具有變形性能和抗裂性能良好，空隙率小，防水性能好，熱穩定性較好，施工工藝簡單的特點，因此，瀝青橡膠碎石是二級及二級以下公路因疲勞而開裂的瀝青路面的良好罩面材料，也是防止半剛性基層收縮裂縫反射的良好結構措施，在瀝青類路面面層和半剛性基層之間夾鋪瀝青橡膠碎石薄層，雖然造價比夾鋪土工布高，但其施工工藝，抗裂性能和防水性能均優于土工布，不僅可以大大減少半剛性基層材料的反射裂縫，延長路面使用壽命，而且可能適當減薄瀝青混合料面層的厚度，雖然初期造價有所增加，從長遠來看，具有十分重要的技術和經濟意義。
  6. Loran - c receivers for ships. minimum performance standards. methods of testing and required test results

    船舶用勞蘭- c接收機.最低性能標準.試驗方法及要求的試驗結果
  7. Loran - c receivers for ships - minimum performance standards - methods of testing and required test results

    船舶用c型導航接收儀.最低性能標準.試驗方法和要求試驗結果
  8. Photographic properties ' result of this development accelerator ( m ) indicated that m could increased photosensitivity significantly and at the same time had good anti - aging properties, whereas did not change the absorption spectra of the main coupler development

    照相性能試驗結果表明：顯影促進劑m能明顯提高感光度而且具有良好的抗老化性能；染料吸收光譜的結果表明：它的使用不影響主成色劑成色染料的吸收光譜。
  9. Combine capacity and performance test procedure

    聯合收獲機容量和性能試驗程序
  10. Standard test method for moisture absorption properties and equilibrium conditioning of polymer matrix composite materials

    高聚物基體合成材料水分吸收性能和平衡條件的標準試驗方法
  11. Test method for properties of investment casting pattern materials - part 1 : determination of linear shrinkage

    熔模鑄造模料性能試驗方法第1部分:線收縮率的測定
  12. It is suggested that the micro - aggregate filling effect is highly correlated with the fineness of slag powder and the two effects are summed up with framed chart

    進行了礦渣粉、石灰粉加固土無側限飽水抗壓強度、水穩定性、凍穩定性、溫度收縮和乾燥收縮等路用性能試驗，並進行比較。
  13. Evaluation and routine testing in medical imaging departments. part 3 - 2 : acceptance tests imaging performance of mammographic x - ray equipment

    醫療成象科的評價和常規檢驗.第3 - 2部分:乳房x射線照相設備的成象性能和驗收試驗
  14. More recent studies show nanowires products with narrow dismeter distribution around 5 - 10mn and lengths ranging from several hundred nanometers to several micrometers can be obtained if the mixture solution of naoh and koh was replaced by koh solution. the nanowires were analyzed by a range of methods including powder x - ray diffraction ( xrd ), high resolution electron microscopy ( hrem ), selected area electron diffraction ( saed ), electron energy loss spectroscopy ( eels ), xrd and hrem image simulations. the structure of nanowires is determinded to be of the type of k2ti6oi3

    利用x射線衍射（ xri ） ） 、高分辨電子顯微鏡（ hrtem ） 、選區電子衍射（ saed ） 、電子能量損失譜（ eels ）以及x射線衍射和高分辨像模擬等分析測試手段，初步分析了這種納米線的生長機理，探討了她的結構和光學性能，實驗結果顯示這種納米線具有kzti6o ; 3的結構，紫外一可見光吸收光譜顯示， kzti6ol3納米線禁帶寬度約為3 . 45ev 。
  15. Rotary positive displacement pumps - performance tests for acceptance

    回轉容積泵.驗收性能試驗
  16. Test method for properties of investment casting ceramic core - part 2 : determination of sintered shrinkage

    熔模鑄造陶瓷型芯性能試驗方法第2部分:燒成收縮率的測定
  17. This paper described some experience in test contents, test organization, and quality control of the acceptance tests for ccpp units with type 9f grade, to supply other large - scale unit engineering construction to refer

    介紹了我國第一批打捆招標的某大型9f級聯合循環機組工程的性能試驗內容和驗收試驗中組織實施、以及質量控制等方面的內容，以供其他大型機組建設工程參考。
  18. Test method for water penetration of flat plate solar collectors by uniform static air pressure difference

    均勻的靜氣壓差下平板太陽能收集器的透水性的試驗方法
  19. Test methods for conducting performance tests on mechanical conveying equipment used in resource recovery systems

    資源回收開發系統用機械輸送設備性能試驗的試驗方法
  20. 2. based on the test results published over the word of steel fiber reinforced concrete beams without web reinforcements and with stirrups, the effects of steel fiber to shear resistance and the relationship of steel fiber to stirrups are analyzed, the improvements of steel fiber to failure states of reinforced concrete beams without web reinforcements are discussed. it is proposed that the formula of shear resistance of steel fiber reinforced concrete beams based on the model of the current design and construction spectification of steel fiber reinforced concrete structures ( cecs38 : 92 ), used of the uniaxial tensile strength of steel fiber reinforced concrete, and combined with different formulas specified in current design codes of concrete structures issued by different trades

    根據收集到的國內外對鋼筋鋼纖維混凝土無腹筋梁和鋼筋鋼纖維混凝土有腹筋梁的斜截面受力性能試驗研究成果，對鋼纖維在增強鋼筋混凝土無腹筋梁和有腹筋梁斜截面承載力方面的作用及其在箍筋抗剪承載力的關系進行了總結分析，對鋼纖維改善鋼筋混凝土梁破壞形態方面的作用進行了分析討論，提出了採用鋼纖維混凝土軸心抗拉強度指標，基於現行cecs38 ： 92 《鋼纖維混凝土結構設計與施工規程》計算模式、能夠與目前國內各行業現行混凝土結構設計規范中不同的鋼筋混凝土梁受剪承載力設計方法配套使用的鋼筋鋼纖維混凝土梁受剪承載力設計方法。
分享友人
分享到 Line

分享到臉書