高型 的英文怎麼說

中文拼音 [gāoxíng]
高型 英文
xing gao
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  1. Study on adsorbent by adding heat - conducting materials

    添加導熱材料提高型炭吸附劑儲氣性能的研究
  2. A dynamic high type control method is introduced in this dissertation. it can minish the dynamic error greatly by using this method

    本論文介紹了一種動態高型控制方法,利用該方法可以較大幅度減小跟蹤誤差。
  3. Zircon is a very lovely and affordable gemstone in its own right

    鋯石按成因分為高型鋯石和低鋯石。
  4. Dust catching hole is set on the top which can be directly connected with ventilation system for sand treatment to lower dust of used sand and enhance quality of moulding sand

    在頂部設置吸塵口,可以在砂處理通風系統中直接聯網,降低舊砂粉塵量,提高型砂質量。
  5. It is showed that toughness of phenol resin after modified has been increased, tensile strength and transverse strength of precoated sand and collapsibility of molding sand, which have been improved obviously

    改性后的酚醛樹脂韌性增強,覆膜砂抗拉強度和抗彎強度明顯提砂的潰散性得到了改善。
  6. Hexagon domed cap nuts, high type

    高型六角蓋螺母
  7. Evaluation of cultivars of tall bearded

    高型有髯鳶尾品種綜合評價
  8. In this paper, on the basis of reviewing the traditional handling technology in container terminal, the handling technology of existing automatic container terminal is introduced : automated ohbc crane 、 agv - rmg 、 drmg - crmg relay

    摘要在回顧集裝箱碼頭的傳統裝卸工藝的基礎上,介紹了現有集裝箱自動化碼頭的裝卸工藝:行架式自動化場橋與軌道式龍門吊配合;自動搬運車( agv )與軌道式龍門吊配合;高型軌道吊( drmg )和矮軌道吊( crmg )接力式。
  9. This machine fits for cast iron used sand and different damp used sand, including high pressure moulding used sand so that performance of moulding sand and recycling rate can be improved

    該機用於鑄鐵干舊砂和各種潮舊砂包括壓造舊砂篩分,以提高型砂性能和舊砂回收率。
  10. The high balance crane is widely used for the material feeding and laying off of lathe in the workshop, the workpiece swinging and the spare part assembling of production line in processing room, and the swinging in warehouse and other places

    機械高型平衡吊廣泛用於工廠車間的機床上下料工序間生產線的工件吊運零部件裝配及車間碼頭倉庫等到場合的吊運作業。
  11. Bottling industriy. glass bottles. glass crimps finish, tall form

    制瓶工業.玻璃瓶.高型玻璃凸緣瓶口
  12. Reliability analysis of high substation framework system based on damage

    基於損傷的高型布置變電構架體系可靠性分析
  13. High balance crane

    機械高型平衡吊
  14. Application of dynamic high type control method in the servo system of o - e theodolite is discussed in detail in the dissertation. a method differing from the former is brought forward

    本文深入探討了動態高型控制方法在光電經緯儀跟蹤伺服系統中的實際工程應用,提出了一種不同於前人的動態高型控制方法。
  15. Why dynamic high type control method can improve tracking precision is analyzed in theory and effects on dynamic performances of the method are analyzed, too. a mathematic simulation is carried out

    從理論上分析了動態高型控制方法之所以能夠提跟蹤精度的原因及其對系統動態性能的影響,並對該方法進行了模擬研究。
  16. The atmospheric circulation pattern of higher in the east and lower in the west causes mucn spring precipitation in shandong province, and on the other hand the pattern of higher in the west and lower in the east causes little spring precipitation

    500hpa度距平場西低東高型是造成山東春季降水偏多的主要形勢,其中東比西低更為重要。
  17. It is found that the smaller site of latex particle results in higher curing extent of waterborne epoxy / amine system, and the system has a optimized curing temperature, at which it shows the best comprehensive properties of the film and highest curing extent, and the curing extent with second amine higher than that with primary amine

    研究發現,水性環城樹脂乳膠粒粒徑越小,水性環氧體系的固化程度越水性環氧體系的固化存在最佳的固化溫度,在此溫度下,體系的固化反應程度最,塗膜的綜合性能最佳;仲胺類固化劑與環氧樹脂乳膠粒的固化程度比伯胺類固化劑的
  18. And when cop reaches 0. 3, temperature life is as low as 30 or 40. from the view of thermodynamics, conclusions can be drawn that the high - low cycle is good to be used to recover waste heat, the parallel cycle is not relatively, and the low - high cycle is not at all

    由此可以得出結論,在回收廢熱方面,從熱力學角度來看,二級熱變換器具有很好的應用價值,並聯相對一般,而低高型根本不具有實際應用價值。
  19. In order to deduce the effects on dynamic performances, a method by using prediction filter is introduced. to minish overshoot subsection of input signal with exponent is adopted. these methods are proved by mathematic simulation

    針對動態高型控制方法使系統動態性能變差的問題,提出了利用預測濾波技術改善系統動態性能的方法,進一步提出了利用指數函數將階躍輸入信號分段以降低系統超調量的方法,並通過數學模擬驗證了這兩種方法的有效性。
  20. The mathematic models of them are founded and computed with the new working pairs tfe / tegdme. the effects of heat source temperature, temperature drop of heat source in systems, output temperature, temperature of cooling water, concentration range of cycle on the quantity and quality of recovered heat are analyzed in the paper. the results show that in the three cycles, in the concerned range of parameters, cop of the high - low cycle ranges between 0. 32 and 0. 34, coe ranges between 0

    計算結果顯示,在所計算的三種方式的循環中、在所研究的參數變化范圍內,循環的cop大體維持在0 . 32 0 . 34的范圍內、 coe大體維持在0 . 53 0 . 6的范圍內,並聯循環的cop大體維持在0 . 29 0 . 32的范圍內、 coe大體維持在0 . 48 0 . 53的范圍內,而低高型循環的cop與溫升是一對很尖銳的矛盾:溫升在60左右時, cop只有0 . 1左右,而要達到較的cop時,溫升只能達到很低的30 40 。
分享友人