高壓射流 的英文怎麼說

中文拼音 [gāoyāshèliú]
高壓射流 英文
high pressure jet
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 壓 : 壓構詞成分。
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 高壓 : 1 （殘酷迫害; 極度壓制） high handed 2 [氣象學] （高氣壓） high pressure3 （高電壓） high tension...
  1. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。
  2. Research on comminuting mechanism of high pressure water jet

    高壓水射流射孔過程及機理研究
  3. Study on erosive mechanism of coal by high - pressure water jet

    高壓水射流對煤的沖蝕機理研究
  4. Alternating - current high - voltage fuses. expulsion fuse

    交流高壓熔斷器噴射式熔斷器
  5. The application of high pressure water fluidics to coal production

    高壓水射流技術在煤礦生產中的應用
  6. High water pressure jet technique used to remove well - blockup

    高壓水射流解堵技術的應用
  7. Second, the paper in - depth discuss the reinforce foundation operation mechanism of technique of composite grouting, including spray incise action of high pressure spray flow to soil, mill metathesis concretion action, and penetrate, split, crush action of serum to soil, etc. third, the paper in - depth study design calculate of composite grouting, design of composite grouting technic parameter

    其次，本文對復合注漿法加固地基的作用機理進行了深入的探討，包括高壓噴射流對土體的噴射切割作用、漿液與土的攪拌置換固結作用以及漿液對土體的滲透、劈裂、擠密作用等問題。第三，本文對復合注漿的設計計算、注漿技術參數的設計進行了深入的研究。
  8. The characteristics of high pressure gyratory sprayed pumping discusses is presented, which is applicable in wide range of scope and ground layers, convenient for construction, long durability, wide source of materials. mechanism for subgrade strengthening : complex foundation of cement solid and earth between piles was formed by pulsant load of flowing pressure and spraying flow, water wallop, cavitation phenomenon, water wedge effect, extrusion force and air flow agitation etc so as to enhance foundation bearing force and reduce settlement and deformation

    高壓旋噴注漿技術具有適用范圍、適用地層較廣，施工方便，耐久性好，材料廣闊等特點；其加固地基機理主要是通過流動壓、噴射流的脈動負荷、水塊的沖擊力、空穴現象、水楔效應、擠壓力、氣流攪動等效應形成水泥固結體與樁間土的復合地基，從而提高地基承載力，減少沉降變形。
  9. Numerical simulation of superhigh pressure water jet in rust remover

    超高壓純水射流除銹機的數值模擬
  10. Study on pressure stability of ultrahigh - pressure water jet system

    超高壓水射流系統壓力穩定性研究
  11. Application of high - pressure jet grouting in flood underflow project, xiyang county

    高壓噴射灌漿技術在昔陽縣洪水潛流二水源工程中的應用
  12. Pipe bundle cleaning by high pressure water jet

    管束的高壓水射流清洗
  13. Block - removing technus using high pressure water jets combined with acidization

    高壓水射流與化學劑復合解堵工藝的機理及應用
  14. Principal conclusions were drawn as the following : the non compatibility of pressure or velocity of the gas on both sides of the contact surface is the cause of the formation of shock wave ; the heating effect of reflective shock wave to driving gas during charging or exhausting process is the internal mechanism of peak oscillating effect, and all the factors that influence the formation and the running of the shock wave will influence the peak oscillating frequency, cooling effect

    主要結論如下：熱分離機內激波形成的原因是射氣瞬間接觸面兩側壓力和速度不相容；峰值振蕩效應的內在機制為反射激波對充氣階段的驅動氣或低溫排氣的加熱，凡是影響激波形成及運動的因素都將對峰值振蕩頻率、冷效應及熱效應產生影響；當充、排氣時間比為0 . 1763時，最佳射流激勵頻率出現在高階峰值振蕩頻率上。
  15. ( 2 ) on the leading edge, the film cooling effectiveness at the zone immediately downstream of the cooling holes is affected by blowing ratio and mainstream reynolds number, while the effects are not important in the downstream zone far from the cooling holes. ( 3 ) on the front half of pressure surface, the effectiveness increases with decreasing blowing ratio at the downstream near the cooling row and it is contrary at the downstream far from the cooling row. ( 4 ) on the rear pare of the pressure surface, the effectiveness decreases with increasing blowing ratio and does not vary so much downstream in the cases of higher blowing ratio

    研究結果表明葉片吸力面端壁附近區域壓力系數分佈呈現出較強的三維特性，動葉吸力面尤其明顯；氣膜孔流量系數隨吹風比的增加而增大，在高吹風比情況下，流量系數逐漸趨于常數；在不同型面區域，冷卻效率分佈有較大的差異，而且吹風比與主流雷諾數的影響程度也不盡相同；低吹風比下，孔出口下游附近可以得到較好的冷卻，中、高吹風比下，冷氣射流在加速流動主流的作用下返回壁面進行二次冷卻，孔下游較遠區域可以得到較好的冷氣覆蓋。
  16. A comparison of the flows with different gate - opening rates shows the causes that opening the gate at a higher rate is favorable to the reduction of cavitation, gate vibration as well as the gate load fluctuation. in addition, a study has been made to show the influence of the high - speed jet flow coming downward from the narrow gate gap on the flow condition in the tunnel downstream to the gate

    通過分析比較不同閥門開啟速率對流動特性的影響，闡明了快速開啟閥門不僅有利於減少空化空蝕也有利於減小弧門振動和啟門力的脈動，此外，研究了門楣處狹窄縫隙高速射流對門后流態、壓力脈動和弧門受力等方面的影響。
  17. Material is ejected into the crushing chamber by means of high speed ejection flow formed by high - pressure air through charging ejector, and the crushing nozzles outside ejects high - speed airflow into the crushing chamber at certain direction, making the materials severely collided and fractionated, and thus crushed

    該機是靠高壓氣體通過加料噴射器所形成的高速射流，使粉碎原料被射入料碎室，粉碎室外圍的粉碎噴嘴，有方向性的向粉碎室噴射高速氣流，使物料間產生激烈的碰撞，磨擦而獲得粉碎。
  18. By drilling to weak position, the jet - grouting technique breaks through and mixes with soil and stone of dam foundation to form diaphragm - wall

    高壓噴射灌漿可由鉆機鉆孔至需處理的薄弱部位，通過高壓射流的沖擊攪拌，水泥漿在噴射范圍內與地層土石顆粒摻混攪合后形成防滲墻。
  19. Saving function low operating cost. fully automatic jet flow is suitable for : micro fiber, high twist, woven fabric, curly edge. ect

    全自動噴射式高壓水流適用於：超細纖維強捻布機織布卷邊布經編布
  20. In the process of oil exploration and exploitation, a great deal of data can be collected. these data form 3d data sets, for instance, density sets, hole degree, and flow sets of high - pressure shoot in one block. at present, the usual adopting method is to draw isoclines of data sets, and ask the career men to analyze and explain them

    在石油勘探、開發過程中，會採集到大量的數據，形成三維數據場，如某一區塊的密度場、孔隙度場、高壓射流的流場，目前使用這些數據時，通常採用的方法是畫出數據場的等值線，然後由專業人員進行分析、解釋。
分享友人
分享到 Line

分享到臉書