高壓燃燒器 的英文怎麼說

中文拼音 [gāoyāránshāoqì]
高壓燃燒器 英文
high pre ure burner
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 壓 : 壓構詞成分。
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 高壓 : 1 （殘酷迫害; 極度壓制） high handed 2 [氣象學] （高氣壓） high pressure3 （高電壓） high tension...
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空燃比；通過提高壓縮比來彌補動力性的損失；以動力性為主控目標，對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調節；通過空燃比的合理控制，直接改善發動機的動力性、經濟和排放指標；作為對缸內燃燒過程的理論分析，進行了燃燒特性的實驗測試；對原汽油機和新開發的液化石油氣發動機，進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  3. In the range of flight mach number mo = 3 ~ 7, in order to take the advantage of ramjet and scramjet, a fix - shaped dual - mode scramjet, in which both subsonic and supersonic combustion can be obtained, is used for hypersonic vehicle

    在飛行馬赫數m _ = 3 - 7的范圍內，為充分發揮沖壓發動機的性能優勢，高超聲速飛行器採用了既能在亞聲速燃燒模態，又能在超聲速燃燒模態下工作的固定幾何形狀的雙模態沖壓發動機。
  4. Results show that all the geometric parameters have remarkable effects on combustion performance ; the swirl of intake air generated by skew intake holes enhances fuel - air mixing, minimizes dead zone and stabilizes the flame with reverse flow, but the excessive reverse flow can cause overheat in combustion chamber and exhaust ; the consistency of flow resistance in intake and exhaust system is conducive to the stability of heater performance

    研究表明，燃燒室進氣孔的孔徑、孔數、孔的分佈及方向等均對燃燒性能影響很大；斜孔所產生的旋轉進氣，雖具有強化燃氣混合、消除死區和迴流穩焰的作用，但迴流過度會使燃燒室及排溫過高；保證進排氣系統流動阻力（壓力）的一致性，有助於保證加熱器性能穩定。
  5. After the coke being puted into the coke - quenching device, the lid of the device should be shut at once. while the suction pump, refrigeration compressor, high pressured water circuling pump are started, the subpressure will be produced by the burning coke. then, in the vacuum, the coke will be extinguished in a flash. the burning of the coke instantly, still, produces a large quantity of heat which can be taken away by circulating water in refriger and the interlayer, after that, the temperature will fall to 60oc, even lower. in this condition, the coke will be pushed out to be stored, thus, the coke won ' t rekindle

    當焦炭推上攔焦車進入熄焦器后，立即關閉罐蓋，同時啟動真空泵、冷凍機、高壓循環水泵，這時，燃燒著的焦炭就會因真空泵把熄焦器內抽成負壓，由於缺氧，使焦炭熄滅，雖然煤炭在瞬間被熄滅，但由於焦炭生成過程中所產生的大量的熱量還存在，這時，冷凍機和夾層中的循環水的工作就會把焦炭中的熱量帶走，使之在短時間內將溫度降到60以下，在這種狀態下把焦炭從熄焦器內推出入庫，焦炭就不會復燃。
  6. It is noted that high pressure mixed gas has to be used in connection with forced blowing wind for gas combustion chamber to produce qualified casting

    特別強調，即使用高壓煤氣，也必須用強制送風的方法供給煤氣燃燒器所必須的空氣量，才能生產出合格的鑄件。
  7. Heating boilers - heating boilers with forced draught burners - heating boilers with forced draught burners - special requirements for boilers with forced draught oil burners with outputs up to 70 kw and a maximum operating pressure of 3 bar - terminology, special requirements, testing and marking

    供暖鍋爐.帶強制通風燃燒器的供暖鍋爐.最大操作壓力3巴最高輸出達70kw的帶強制通風燃油器的鍋爐的特殊要求.術語特殊要求試驗和標記
  8. A quick spectroscopic diagnostic system for the flame temperature is set up in this paper. it consists of an optic imaging system, a scanning system, a dispersive system, a photoelectricity conversion cell, operational amplifiers, a computer - based data collection system and a data processing. the temperature profile varying with the time can be quickly measured by this system

    目前光學診斷由於其相應快、精度高，屬于非接觸式測量手段，在研究中得到越來越多的應用，這里要介紹的就是本文中建立的一套光學診斷系統，它由高壓燃燒室、旋鏡掃描儀、旋鏡控制器、小型光柵攝譜儀、光電轉換裝置，微弱信號放大器以及數據採集系統組成。
  9. About design programs of propylene tower post weld whole heat treatment, we have made analyses and compare from the various technical and economic aspects, and in vertical state of large pressurized vessel, we propose to adopt the internal combustion heat treatment method, in horizontal state of it, to adopt high temperature flue gas heat treatment method, and propose center combustion tube method as the future direction of technical developmnet insights

    摘要圍繞丙烯塔焊后整體熱處理的各種設計方案，從技術、經濟等方面進行分析對比，提出對超大型壓力容器，立置狀態下宜採用內燃法熱處理；臥置狀態時宜採用高溫煙氣法熱處理，並提出將中心燃燒管法作為今後技術發展方向的見解。
  10. There is hardly any smoke fog produced when sg 10 series transformers are burning under high temperature and blazing fire

    在高溫明火燃燒下， sg b 10系列非包封線圈變壓器幾乎無煙霧產生。
  11. In order to enlarge the productive scale and to improve the product techno - logy, the advanced circulation fluized bed combustion technology, the advanced equipment as well as funds will be imported from abroad. it is prodicted that 220ton hour circulation fluidized bed boiler output annual will be reached over 5 sets

    太原鍋爐廠現有b級爐和一二類壓力容器的生產能力，並在循環流化床鍋爐的設計製造方面做了大量的工作，為擴大生產規模提高產品技術，擬引進國外先進的循環流化床燃燒技術，引進國外資金和先進設備，生產200噸時循環流化床鍋爐，年生產量達5臺以上。
分享友人
分享到 Line

分享到臉書