高度氣壓開關 的英文怎麼說

中文拼音 [gāokāiguān]
高度氣壓開關 英文
abs altitude barometric switch
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 壓構詞成分。
  • : Ⅰ動詞1 (使開著的物體合攏) close; shut 2 (圈起來) shut in; lock up 3 (倒閉; 歇業) close down...
  • 高度 : altitudeheightelevation
  • 氣壓 : [氣象學] pressure; atmospheric pressure; barometric pressure; gas pressure; air pressure
  1. Our main products are micro barometer low pressure gauge low pressure capsule gauge vacuum pressure with low pressure gauge pressure gauge with electrical contact shock - proof electric contact gauge stainless steel pressure gauge dry and glycerin filled pressure gauge normal pressure gauge freon pressure gauge oxygen - acetylene pressure gauge stainless steel vacuum pressure gauges series diaphragm seal pressure gauge diaphragm pressure gauge with electrical contact pp diaphragm seal pressure gauge shock - proof pressure gauge with electrical contact diaphragm seal pressure gauge explosion - proof electric contact pressure gauge minitype pressure gauge accurate pressure gauge test pressure gauges as well as pressure gauge switch pressure separator tube pressure gauge radiator double - metal thermometer all the products can meet both national and international stands,

    一般力表表抗震力表充油力表全不銹鋼力表膜盒微表電接點力表冷媒力表真空力表力真空表隔膜力表微型力表差表微差表絕表精密力表耐力表蒸力表汽車燃力表醫用力表遠傳力表衛生型力表力表緩沖管力表冷凝散熱器力表翅片散熱器力表不銹鋼連接彎管不銹鋼連接軟管轉換接頭油連接頭力表針閥節流閥及過保護附件濾油網加油口油溫油麵計雙金屬溫計等。
  2. According to relative criteria, the performance of ash - jd such as ratio of water - reducing, ratio of compressive strength, effect of enhancing strength, ratio of bleeding, air entrainment content, effect of keeping slump value, compatibility with cement, resistance to concrete shrinkage and damage by freezing and thawing and impermeability to water etc are all equal to the traditional aminosulfonic - based superplasticizers, and the ratio of performance to price is better than naphthalene series superplasticizers

    按照相標準,對產品進行了測試,所發的低成本改性氨基磺酸鹽效減水劑ash - jd的各項性能如減水率、抗比、增強效果、引性、坍落保持效果、與水泥適應性、收縮性能、抗凍融性能、抗滲性能等相當于傳統氨基磺酸鹽效減水劑,性能價格比優于萘系效減水劑。
  3. Based on the variables of inlet length, compression ratio, inlet opening phase and the exhaust closing phase, multi - objective optimization was conducted for power, torque, combustion noise and fuel consumption indicators with constraint conditions of fuel consumption rate and the maximum breakout pressure

    以進道長縮比、進啟相位、排閉相位為可變因素;以比油耗、最爆發力為約束條件,針對滿足功率、扭矩、燃燒噪聲和油耗指標進行多目標優化設計。
  4. ( 3 ) p and s wave velocity and dynamic & static modul of sand rock in huanhua basin are the first time measured using " mts rock physical parameter testing system under formation condition " of " state key laboratory of oil and gas reservoir geology and exploitation ". at the same time, relationship between seismic response and oil & gas is discussed and summarized

    ( 3 )利用「油藏地質與發工程」國家重點實驗室mts巖石物性測試系統,首次對黃驊坳陷砂巖進行了下的縱、橫波速及動彈模量的測定,對黃驊坳陷砂巖的地震響應與油系進行了分析和總結。
  5. The paper mainly discussed the reasons of stress from liquid ammonia pressure vessel causing crack through examing data and experimental results and analysing relevant referential documents and materials, taking 1200 ammonia vessel ' s crack and leaking in a certain fertilization company as an example : there existed remaining welding, stress in the equipment ; there existed a stress decaying surrounding, i. e., moisture 0. 2 %, and temperature > - 5 with o2 or co2 inside ; the higher the intensity of raw materials, more possible it was to have stress decaying crack

    摘要以某化肥公司1200氨冷器殼體裂泄漏的失效分析為例,通過對檢驗數據和結果及有文獻資料的分析研究,探究了液氨介質力容器產生應力腐蝕裂紋的原因:設備中存在較的焊接殘余應力;液氨介質具備應力腐蝕環境,即含水量0 . 2 % ,且有空( o2或co2 )污染(或摻入) ,使用溫於零下5 ;母材強,應力腐蝕裂紋產生的傾向就越大。
  6. By improving surface condition of parts and one shot seal - off clean room grade, using ultrasonic vapor phase cleaning process, the inner parts of vacuum interrupter get cleaner. movable particles have been diminished by automatic current ageing, power frequency hi - voltage ageing and dynamic high current ageing. as the dielectric strength of clearance in vacuum interrupter improved, the probability of re - ignition in test drops evidently

    通過提零件表面加工質量,改善一次封排間的真空衛生條件、制定合理的超聲波相清洗工藝提管內潔凈,採用自動電流老煉、超工頻老煉、大電流動態老煉等工藝進一步消除真空滅弧室內活動性微粒,可提真空滅弧室真空間隙介質強,使真空投切電容器組的重燃率大大降低,並通過實驗驗證真空投切電容器組的重燃率在製造工藝改進後由原來的10 . 7 %降低至1 . 3 % 。
  7. The results of numerical experiments, using the four - dimensional variational data assimilation system of the nonhydrostatic mesoscale model mm5, show that : the tangent linear model and adjoint model conducted by keeping the " on - off " switches the same as the basic state, can provide a good approximation of the first - order information to the nlm perturbation and a good descent direction for the minimization procedure ; switching on and off at every other time step in the kuo cumulus parameterization scheme do n ' t impact the convergence rate of cost function ; the existence of the switches do n ' t impact improvement to the mm5 model rainfall prediction because that not only specific humidity, but also wind, temperature and pressure are assimilated into the model

    非靜力中尺數值模式mm5的四維變分資料同化系統進行的數值試驗結果表明: 「」變量保持與基態一致,所構造的切向線性模式能夠提供于非線性模式擾動的一階近似,伴隨模式所計算的梯值能夠為最小化過程提供較好的下降方向;郭氏降水參數化方案中對流每隔一個積分步的交替發生並不影響目標函數最小化的收斂速; 「」變量的存在也不影響將風、溫和比濕結合起來同化對mm5降水預報準確性的提
  8. Abs altitude barometric switch

    海拔
  9. By testing according to correlation criterions, the performances of jd such as ratio of water - reducing, ratio of compressive strcngth, effect of accelerating and enhancing strength, ratio of bleeding, air entrainment content, effect of keeping slump value, compatibility with cement, resistance to concrete shrinkage and damage by freezing and thawing and water - tightness etc are all better than that of the traditional melamine resin superplasticizer sm and naphthalene series superplasticizer fdn

    按照相標準進行測試,所發的改性密胺樹脂效減水劑的各種性能如減水率、抗比、早強增強效果、泌水率、引性、坍落保持效果、與水泥適應性、收縮性能、抗凍融性能、抗滲性能等都遠遠優于傳統的三聚氰胺效減水劑sm ,也優于萘系效減水劑fdn 。
  10. With the development of energy industry, the application of electrical equipments, such as electric motors, large capacity transformers, high voltage switches etc, are more and more used in many industrial fields. therefore, it is essential for electrical manufacturers to design their products more precise, to meet the requirements of electrical products with higher quality and higher performance in modern society

    隨著能源工業的發展,電機、大型電力變器、等電裝備的應用越來越多,對它們的性能、質量及製造精的要求也越來越,這就要求電裝備製造廠家必須對電產品進行精確的設計,以滿足現代社會對電產品質量、性能的要求。
  11. The model analysis of the deployed beams were studied in both theory way and simulation way. the differences of the beams in different pressures were studied. investigations showed that the method of modeling for short and long rolled beams is doable ; the process of fold maybe lead so large displacement and stress that membrane is damaged at local areas, ration and material wrinkle generates,

    研究結果表明:本文提出的分別針對短、長捲曲折疊充管的建模方法是有效的;在充管展過程中,充越大,展的速越快,但由於阻尼損耗,二者並非線性系;充過大不利於結構展過程的穩定性;充支撐管的越大其固有頻率越,但影響效果很小。
分享友人