高液面 的英文怎麼說

中文拼音 [gāoyèmiàn]
高液面 英文
high liquid level
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 液 : 名詞（液體） liquid; fluid; juice
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  1. Through the special studies on impacts to atomizing and humidifying effect from such factors as the firing pin type, centrifugal structure, higher spraying pressure, less aperture, initial water temperature and original state of the air, some conclusions are obtained, such as : the centrifugal nozzle with firing pin type, high pressure and little aperture has bigger air eddy and atomizing angle. the spaying liquid has high velocity. the droplet is small, and the heat and mass transfer velocity is high

    通過對撞針型結構、離心式結構、較高的噴水壓力、較小的噴嘴孔徑、噴水初溫及待加濕空氣初狀態對霧化加濕效果的作用原理的重點分析，得到：撞針型高壓小孔徑離心式噴嘴具有較大的空氣渦與霧化角，噴出的液體流速高、液滴小、水與空氣傳熱傳質速率高，撞針型結構提高了霧化加濕效率，高壓小孔徑的特點為霧化加濕提供了較大的能量，而噴水初溫的升高會減小水的粘性力和表面張力，從而優化加濕效果。
  2. Is the mould level and flow control in a closed loop system and are abrupt changes alerted, monitored and affected blooms controlled / downgraded

    鑄模液面高度和（鋼水）流控制是否在封閉的循環系統中進行？對突發情況是否有報警，監控措施？並且對受影響的鋼坯得到控制和降級使用？
  3. Moreover, the resulted prediction model of foam size of the closed cell aluminum foam was verified by comparison to the experimental results from the foaming process at different foaming conditions, and the predicted bubble diameter is in good agreement with the experimental ones, the relative error distributes between - 5. 04 % and 6. 32 %

    當入射空氣的壓強、氣流量，液面高度，出氣孔直徑增大時，氣泡直徑隨之增大；當出氣孔數量，液體粘度增大時，氣泡直徑減小，表面張力對氣泡直徑的影響可以忽略不計；靜態條件下液體表面氣泡直徑的預測值和實驗測量值符合得較好，相對誤差分佈在- 5 . 04 % ~ 6 . 32 %之間。
  4. The autonomous underwater vehicle which carries liquid oxidizer and liquid incendiary agent and uses the outside seawater as coolant request the oxidizer 、 incendiary agent and coolant can supply the power system according to accurate proportion and reasonable flow on any condition. the system should have small volume and light weight and should be easily realized. the system and control mode introduced in this article can fit these requirements well

    控制或降低液壓系統油液的污染度和提高液壓元件的污染耐受能力是確保液壓系統可靠工作的兩個重要方面，本文分析了液壓柱塞泵所在系統油液污染特性一定時影響泵污染耐受能力的諸多因素，指出了在結構形式確定的條件下設計高污染耐受度液壓柱塞泵所要求的摩擦副材料與主要表面工藝
  5. The result shows that the trench wall failure at shallow depth is the major failure mode of the slurry - supported excavation, and that the length of the excavated trenches and the difference between the slurry head and the water level are the key parameters controlling the stability of the slurry - supported excavation

    結果表明，淺層槽壁失穩是泥漿護壁開挖的主要失穩型式，開挖槽段的長度和泥漿液面與地下水位面的高差是控制泥漿護壁開挖穩定性的關鍵參數。
  6. H height from measured point to liquid surface

    H被測點到液面的高度
  7. Design of ultrasonic ranging system for liquid caging

    超聲波測量罐中液面高度的系統設計
  8. The utilization of organosilicon which has higher bond energy and lower surface energy to modify the acrylate latex can markedly improve and enhance those properties mentioned above for acrylate polymers, and to date, it has become one of the most important research directions in this field

    利用鍵能較高、表面能較低的有機硅組分改性丙烯酸酯乳液，提高丙烯酸酯聚合物的耐高、低溫性及耐水性能，已成為丙烯酸酯乳液改性的重要方法。
  9. With social development, the electrostatic atomization technology on high voltage of liquid has gained more and more attentions. its function which applied in industry, agriculture and spaceflight aspect etc. is outstanding in saving material, improving liquid work efficiency, reducing environmental pollution and so on

    隨著社會的發展，液體高壓靜電霧化技術越來越受到重視，它在節省原料、提高液體利用效率、減少污染等方面的作用日益突出，被廣泛用在工業、農業和航天等領域。
  10. The influence of the temperature of durene solution, the height from airway nozzle to liquid level, the temperature and feed rate of air on the vapor phase concentration of durene were studied with the self - made adjustor

    摘要利用自製的高熔點物料氣相濃度調控儀，研究了均四甲苯溶液的溫度、導氣管管口距離均四甲苯液面的高度、空氣進氣溫度和進料量等對均四甲苯氣相濃度的影響。
  11. As a result, the temperature of the durene solution and the feed rate of air had a greater influence on the vapor phase concentration of durene, whilethe influence of the height from airway nozzle to liquid level and the feed air temperature on the vapor phase concentration was small

    實驗結果表明：均四甲苯溶液的溫度、空氣進料量對均四甲苯氣相濃度影響較大，而導入管距離液面的高度和空氣溫度影響較小。
  12. The results denote that the sand layer can greatly enhance heat transfer in high temperature region because it changes film boiling to liquid film evaporation in the sand layer

    在高溫金屬面上覆蓋砂層后，可將高溫面上的膜沸騰轉化為砂粒表面的液膜蒸發，從而大幅度提高表面換熱系數，強化冷卻能力。
  13. There are three controlling signs for output : the displacement of casting roller, the casting temperature, the surface height of melting pool. the executing element for rotate speed is the frequency conversion

    三個控制信號，即三路輸出，分別為：鑄輥轉速、鑄輥位移、熔池液面高度，控制轉速的執行元件為變頻器，位移和熔池液面高度都用伺服閥進行控制。
  14. During the laser sintering, due to the large liquid phase viscosity and surface tension, the balling effect occurred when the molten did not wet the solid metal particle and the underlying substrate

    實驗發現，在液相粘度較高、表面張力大，熔體材料不浸潤固相顆粒和基板等因素的影響下，燒結過程中出現了球化現象。
  15. Fli fluid level indicator

    液面高度指示器
  16. We are increasingly paying close attention to the viewing - angle characteristics of the liquid crystal display ( lcd ). in improving the viewing characteristics of all kinds of cells, the ips mode is getting more attention extensively, it can greatly increase the viewing angle

    在液晶顯示器中，顯示器的視角特性越來越受到關注，在提高液晶顯示器的視角特性的各種類型盒中，共面轉換模式（ ips ）受到廣泛重視，它能大大增加液晶顯示器的視角。
  17. For the purpose of high temperature gradient, liquid metal cooling with circulatory water cooling is used directly to cool the sample, and at the same time, radiation baffle with appropriate size and shape is needed

    該裝置採用了雙區加熱和液態合金直接冷卻技術，再配以合適的輻射擋板，可以提高液固界面處的溫度梯度。
  18. Discussions were first made on the mechanism of vibro - replacement crushed stone columns for different types of soils and then, based on the experience on a practical project, methods for building vibro - replacement crushed stone columns for improvement of soft soils and methods for testing to verify the improvement effect of the vibro - replacement crushed stone columns were also discussed

    摘要首先對振沖碎石樁法在不同土質地基中的加固機理進行了闡述；然後，以實際工程為依託，對應用振沖碎石樁法處理高液限軟粘土地基的施工、加固效果檢測等方面的問題進行了討論。
  19. Program of the model was built and having a mathematical simulation. and perfoimed a detailed analysis of the simulation result of the important characterize parameter, the height of advance, the height of the absorption ' s liquor face, and the difference of the libr density

    對氣泡泵的主要的特性參數，直徑，提升高度，吸收器液面設計高度，製冷量，濃度差的相互關系，在文中進行了詳盡的數值模擬計算，並對模擬結果進行了理論分析。
  20. If same mediums are measured, the digital collections from every lay should be same or near, otherwise should be rather different. utilizing this phenomenon, the lay where the interface is can be judged, the interface or liquid - level height can be calculated

    如果測量的是同一介質，各段採集的數字量應該一致或接近，反之則有較大差異，利用該現象可以判斷出介質分界面的層段，就能計算出界面或液面高度。
分享友人
分享到 Line

分享到臉書