高溫區 的英文怎麼說

中文拼音 [gāowēn]
高溫區 英文
high temperature region
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : Ⅰ形容詞(不冷不熱) warm; lukewarm; hot; gentle; mild Ⅱ名詞1 (溫度) temperature 2 (瘟) acute ...
  • : 區名詞(姓氏) a surname
  • 高溫 : high temperature; elevated temperature; hyperthermia; megatemperature; inferno
  1. For large blast furnaces, the change of main operation parameters are analyzed and gas channels in high temperature and lower part of blast furnace an discussed for three modes

    在大型爐工況條件下,解析了3種富氧操作方式下主要冶煉參數的變化規律,以及爐下部高溫區煤氣通道狀況。
  2. In this paper we discuss the three - dimensional quasi - static problems by using the magneto thermo elasticity theory, which is related to geotherm : the situations of the heat - carrying fluid intruding into the vertical or horizontal cracks, and the case of static local high temperature regions

    摘要以磁熱彈性理論為工具,討論與地熱有關的三維準靜態問題:載熱流體侵入豎直或水平裂隙的情況和存在靜態局部高溫區的情況。
  3. Combined with practical data of shannxi lin hekou hydropower plant, the temperature filed of m and n schemes during construction and operation are simulated and analyzed. the isoline map of stable temperature field of the arch crest girder section and the vertical section in the center of arch dam, the isoline map of unstable temperature field of the arch crest girder section and the vertical section in the center of arch darn during construction and operation and the maximal and minimal temperature value during construction and operation are provided. the distribution law of temperature in the dam and the form reason of high - temperature zone are analyzed and the effect and feasibility of cooling and the zone of cooling are discussed

    結合陜西藺河口水電站工程實際資料,對m方案和n方案度場進行了施工期和運行期全過程模擬計算分析,給出了拱冠梁剖面和壩體中心縱剖面準穩定度場等值線圖以及施工期、運行期拱冠梁剖面和壩體中心縱剖面非穩定度場等值線圖,提供了施工期逐月和運行期每年最、最低度等成果,分析了壩體度分佈規律以及高溫區形成的原因,並探討了預埋冷卻水管的效果和可行性以及預埋冷卻水管的域。
  4. A method to control the corrosion of high temperature section is provided

    提出了一種方法來控制和評估高溫區的腐蝕。
  5. Life may have evolved on earth and other planets in geothermally heated environments

    生命可能源於地球或其他行星上受地熱影響的高溫區
  6. Using radon measure technique to explore no. 1303 comprehensive caving face combustion high - tempreture area

    應用測氡技術探測綜放面煤自燃高溫區
  7. 2 in summer, haidian and fengtai lie in an area with high temperature. these areas are the main are as of the urban heat island over beijing area

    2夏季,城市西部海淀到豐臺一帶處在一個高溫區,構成北京「熱島」的一個主要域。
  8. At the area of high temperature at the bottom of dryer, thermal sensitive material does not contact with hot surface. it solves coking and discoloring problem of thermal sensitive material

    在乾燥機底部高溫區,熱敏性物料不與熱表面直接接觸,解決了熱敏性物料的焦化變色問題。
  9. Pm increases whereas pm decreases with the rise of temperature, which narrows the allowed pressure range for the safe and stable levitation of the processed drops at higher temperatures

    Pm和pm隨度的升分別增大和減小,從而縮小了在高溫區穩定安全地懸浮液態樣品的聲壓范圍。
  10. We investigated the transformation of the combustion with the increase of centrifugal force. when the acceleration became bigger, the temperature of high temperature field is increased and the flame became wider

    研究了燃燒隨著加速度增加的變化情況,隨著加速度的增大,高溫區度升,火焰變寬。
  11. At the bottom of drier, where is high temperature area, heatsensitivity raw material can not contact with heat surface directly, therefore it solves the carbonization and color charge problems of heat sensitivity raw material

    在乾燥機底部高溫區,熱敏性物料不與熱表面直接接觸,並裝有特殊裝置,解決了熱敏性物料的焦化變色問題。
  12. Research points out that the three key factors, which determine the nox emissions, are maximum peak temperature, rich oxygen concentration and the duration in which combustion products stay at high temperature zone

    船舶柴油機的氮氧化物主要是山于大氣中的氮在柴油機燃燒過程中被氧化而成。研究表明、富氧以及燃燒產物在高溫區的停留時間是決定氮氧化物排放量的三個決定因素。
  13. The result of experiment showed that the reaction between ti and c is a thermodynamic course, when 2 wt % mg is added to melt, it can restrain the formation of fragility phase al3ti, and gained al matrix composite which contained tic reinforced particles only. because mg reacts with the forms a micro - high temperature field around the oxide around the graphite particles and the oxygen gas which is brought by the immersion bell, and the reaction gives out a lot of heat energy, thus forms many high micro - fields in melt, which prompt the reaction between the al and ti

    加入適量的mg ( 2wt )可以抑制tic al復合材料中的脆性相al _ 3ti的產生,生成僅含tic的鋁基復合材料;由於活化劑鎂在體系中與石墨顆粒周圍的氧化物、以及外來的氧反應放熱,在熔體中形成微高溫區,促進al - ti反應,同時, al - ti反應也是放熱反應,因此體系中的內能急劇增大,促使al _ 3ti分解以及ti朝c顆粒擴散,縮短反應的孕育時間。
  14. Transverse cte of c / sic composites increases linearly, changing in a similar way with that of cvd sic in low temperature range ( < 900 ), and decreases fast in high temperature range ( > 900 ), then increases again at 1200

    其徑向熱膨脹在低域( 900 )內線性增加,與cvdsic的熱膨脹十分接近,在高溫區域( 900 )內迅速降低,並在1200急劇回升。
  15. And the results of these two methods really show difference. we analyze the condition for the condensation using the concept of entropy and reach the conclusion that there will be no bec in the low dimension system. we get the relation between the critical temperature and the given number of the particles in a three - dimension infinite trap system directly, together with the tendency shown at a low temperature of the critical temperature " changing to the particle number

    指出了兩種方法的結果在低域的差別和高溫區域的一致性,比較結果表明,給定粒子數的系統處于低曲阜師范大學碩士研究生畢業論文第頁條件時,數值方法所求出的轉變度要比積分方法所得的結果,並且轉變度隨粒子數的變化趨勢也要迅速,然後分析了兩種方法存在差別的原困。
  16. Have to out : 1 temperature constructional reinforcing not can place in heat area to mass concrete design. temperature constructional reinforcing of bottom of mass concrete need content that owing to temperature change produce bottom control stress smaller than anti - pull strength at the same. get minimum rate of reinforcing to content construct request

    得出: 1在大體積混凝土結構的度構造鋼筋配置中,構造鋼筋不宜放置於高溫區;大體積混凝土的底部度構造鋼筋應滿足度變化產生的底部約束拉應力小於混凝土同齡期的抗拉強度的要求,從而求出抗拉要求的最小配筋率。
  17. The magnetic ground state of lafe _ ( 11. 4 ) al _ ( 1. 6 ) cx compound changes from antiferromagnetic to ferromagnetic for x > 0. 06 and the curie temperature increased monotonously with the increase of carbon content. a large magnetic entropy change was obtained near the phase transition temperature and the refrigerant capacity is good

    當碳含量於0 . 06時,化合物的基態由反鐵磁變為鐵磁且居里度隨c含量的增加向高溫區移動,在各自相變度附近保持較大磁熵變,具有良好的磁製冷能力。
  18. Compared the heating load ( and energy consumption ) of a same room with floor heating or radiator heating under same operative temperature. revealed the energy consumption of floor heating room could reduce 5 % ~ 10 % to radiator heating, and the heating load could reduce 10 % ~ 15 %. the main season of energy efficiency is due to no apparent high temperature zone in floor heating room, which avoid additional heat loss in outside envelopes, rather than the lower of indoor air temperature

    利用對連續供暖房間度場的研究結果,對分別採用上述兩種供暖方式的典型房間的熱負荷和能耗進行了全面分析后發現:低地板輻射供暖房間熱負荷比散熱器供暖房間可降低10 15 ,能耗可降低5 10 ;低地板輻射供暖房間節能的主要原因並不是由於房間空氣度可以降低,而是消除了室內空氣局部高溫區,避免了由此產生的在外圍護上的附加傳熱量。
  19. Comparing the intensity of esr line with the magnetization curve, we gain that all spins contributing to the magnetization are really observed by esr. 6. electronic transport and cmr effect in perovskite compounds the electronic transport properties of the dy - doped perovskite compounds la0. 67 - xdyxsr0. 33mno3 have been investigated

    高溫區,載流子的輸運特性為磁背景下的可變程躍遷,在丁tc的輸運行為受相分離以及la o層中dy鏈的影響。
  20. The simulation results show that each gas species has close relation with the temperature distribution, and the method of cell modeling to can effectively simulate the complicated physical and chemical process inside the furnace, and can provide the theories leading for boiler design , reformation and run

    模擬結果表明,爐內度分佈的高溫區和低與各氣體成份的分佈存在很強的對應關系,同時表明採用小室模型可以對爐內復雜的物理化學過程進行有效的模擬,該模型可為鍋爐設計、改造和運行提供理論指導。
分享友人